Application of Silicon Nanostructure Arrays for 6-inch Mono and Multi-Crystalline Solar Cell.

In this study, we fabricate uniform silicon nanowire (SiNW) arrays on 6-inch mono- and multi-crystalline wafers by employing the improved solution-processed metal-assisted chemical etching (MacEtch) method. Furthermore, the improved MacEtch can be applied to various crystalline orientation wafers. The SiNW arrays are 470 nm in length with high density; they demonstrate a good optical trapping effect and reflectance well below 6% over a broad wavelength range from 300 to 1100 nm. The improved MacEtch shows no difference in reflectance for a pyramid/SiNW mono-crystalline wafer with appropriate uniformity; the average delta from the center to other positions is within 22%. The effective lifetime is lower for SiNW arrays because the higher surface state causes higher surface recombination.Finally, we make the multi-crystalline wafer into an Al-BSF solar cell device with MacEtch SiNW texture, resulting in an averaged power conversion efficiency of 17.83%, which is higher than that of standard acid-textured solar cell devices. Consequently, the improved MacEtch concept is suitable for commercial mass production in the photovoltaic industry.

Photovoltaic Performance Enhancement of Silicon Solar Cells Based on Combined Ratios of Three Species of Europium-Doped Phosphors.

This paper presents a scheme for the enhancement of silicon solar cells in terms of luminescent emission band and photovoltaic performance. The proposed devices are coated with an luminescent down-shifting (LDS) layer comprising three species of europium (Eu)-doped phosphors mixed within a silicate film (SiO2) using a spin-on film deposition. The three species of phosphor were mixed at ratios of 0.5:1:1.5, 1:1:1, or 1.5:1:0.5 in weight percentage (wt %). The total quantity of Eu-doped phosphors in the silicate solution was fixed at 3 wt %. The emission wavelengths of the Eu-doped phosphors were as follows: 518 nm (specie-A), 551 nm (specie-B), and 609 nm (specie-C). We examined the extended luminescent emission bands via photoluminescence measurements at room temperature. Closely matching the luminescent emission band to the high responsivity band of the silicon semiconductor resulted in good photovoltaic performance. Impressive improvements in efficiency were observed in all three samples: 0.5:1:1.5 (20.43%), 1:1:1 (19.67%), 1.5:1:0.5 (16.81%), compared to the control with a layer of pure SiO2 (13.80%).

Plasmonic Light Scattering in Textured Silicon Solar Cells with Indium Nanoparticles from Normal to Non-Normal Light Incidence.

In this study, we sought to improve the light trapping of textured silicon solar cells using the plasmonic light scattering of indium nanoparticles (In NPs) of various dimensions. The light trapping modes of textured-silicon surfaces with and without In NPs were investigated at an angle of incidence (AOI) ranging from 0° to 75°. The optical reflectance, external quantum efficiency (EQE), and photovoltaic performance were first characterized under an AOI of 0°. We then compared the EQE and photovoltaic current density-voltage (J-V) as a function of AOI in textured silicon solar cells with and without In NPs. We observed a reduction in optical reflectance and an increase in EQE when the cells textured with pyramidal structures were coated with In NPs. We also observed an impressive increase in the average weighted external quantum efficiency (∆EQEw) and short-circuit current-density (∆Jsc) in cells with In NPs when illuminated under a higher AOI. The ∆EQEw values of cells with In NPs were 0.37% higher than those without In NPs under an AOI of 0°, and 3.48% higher under an AOI of 75°. The ∆Jsc values of cells with In NPs were 0.50% higher than those without In NPs under an AOI of 0°, and 4.57% higher under an AOI of 75°. The application of In NPs clearly improved the light trapping effects. This can be attributed to the effects of plasmonic light-scattering over the entire wavelength range as well as an expanded angle of incident light.

Low-Pressure-Assisted Coating Method To Improve Interface between PEDOT:PSS and Silicon Nanotips for High-Efficiency Organic/Inorganic Hybrid Solar Cells via Solution Process.

Nanostructured silicon hybrid solar cells are promising candidates for a new generation photovoltaics because of their light-trapping abilities and solution processes. However, the performance of hybrid organic/Si nanostructure solar cells is hindered because of carrier recombination at surface and poor coverage of organic material poly(3,4-ethylenedioxythiophene):poly(styrenesulfonate) ( PEDOT: PSS) on nanostructures. Here we demonstrate low-pressure-assisted coating method of PEDOT: PSS on surface-modified silicon nanotips with broadband light-trapping characteristics to improve interface property and to achieve high-efficiency hybrid solar cells through a solution process. The approach enhances the effective minority-carrier lifetime and the coverage of PEDOT: PSS on the surface of nanostructures. Hybrid solar cells fabricated with surface-modified nanotips exhibit a high fill factor of 70.94%, short-circuit current density of 35.36 mA/cm(2), open-circuit voltage of 0.528 V, and power conversion efficiency of 13.36%. The high efficiency and the high fill factor are achieved because of conformal coating of PEDOT: PSS via a low-pressure-assisted coating process, excellent light harvesting without sacrificing the minority-carrier lifetime, and efficient charge separation/collection of photogenerated carriers.

Performance-Enhanced Textured Silicon Solar Cells Based on Plasmonic Light Scattering Using Silver and Indium Nanoparticles.

Performances of textured crystalline-silicon (c-Si) solar cells enhanced by silver nanoparticles (Ag-NPs) and indium nanoparticles (In-NPs) plasmonic effects are experimentally demonstrated and compared. Plasmonic nanoparticles integrated into textured c-Si solar cells can further increase the absorption and enhance the short-circuit current density (Jsc) of the solar cell. To examine the profile of the proposed metallic particles, the average diameter and coverage of the In-NPs (Ag-NPs) at 17.7 nm (19.07 nm) and 30.5% (35.1%), respectively, were obtained using scanning electron microscopy. Optical reflectance and external quantum efficiency response were used to measure plasmonic light scattering at various wavelengths. Compared to a bare reference cell, the application of In-NPs increased the Jsc of the cells by 8.64% (from 30.32 to 32.94 mA/cm²), whereas the application of Ag-NPs led to an increase of 4.71% (from 30.32 to 31.75 mA/cm²). The conversion efficiency of cells with embedded In-NPs (14.85%) exceeded that of cells with embedded Ag-NPs (14.32%), which can be attributed to the broadband plasmonic light scattering of the In-NPs.

Hybrid organic-inorganic heterojunction solar cells with 12% efficiency by utilizing flexible film-silicon with a hierarchical surface.

This paper reports an organic-inorganic hybrid solar cell with a hierarchical surface composed of high density silicon nanoholes and micro-desert textures. High-efficiency organic-inorganic hybrid solar cell Si/PEDOT-PSS with a hierarchical surface, showing a power conversion efficiency of 12%. The structure provides excellent light absorption over 97% for the spectral range of 300 to 1100 nm with a thickness of 60 µm due to internal multiple reflections caused by subwavelength features of high density silicon nanoholes and micro-desert textures. In addition, from the angle of incidence (AOI) observed, even at the large angle of 75°, the reflectance value still exhibits less than 1%. With the advantage of very thin silicon material and inexpensive processing, hybrid silicon/polymer solar cells are promising for various applications and thus could be an economically feasible alternative energy solution in the future.