Drinking water magnesium and cardiovascular mortality: A cohort study in Denmark, 2005-2016.

INTRODUCTION: Cardiovascular diseases are globally a major cause of death. Magnesium deficiency is associated with several diseases including cardiovascular diseases. OBJECTIVE: To examine if a low concentration of magnesium in drinking water is associated with increased cardiovascular mortality and mortality due to acute myocardial infarction and stroke. METHODS: A nationwide population-based cohort study using national health registries was used. A total of 4,274,132 individuals aged 30 years or more were included. Magnesium concentration in drinking water was estimated by linkage of residential addresses in the period 2005-2016 with the national drinking water quality monitoring database. The association between magnesium concentration in drinking water and cardiovascular mortality and mortality due to acute myocardial infarction and stroke was examined using a Poisson regression of number of deaths and logarithmic transformation of follow-up time as offset. The incidence rate ratio (IRR) was adjusted for differences in age, sex, calendar year, cohabitation, country of origin, and socioeconomic status. RESULTS: Median magnesium concentration in drinking water at inclusion was 12.4 mg/L (range: 1.37-54.2 mg/L). The adjusted IRR for cardiovascular mortality was 0.96 (95% CI: 0.94; 0.97) for the lowest magnesium quintile (<6.5 mg/L) as compared to the highest magnesium quintile (>21.9 mg/L). The adjusted IRR for mortality due to acute myocardial infarction and stroke was 1.22 (1.17; 1.27) and 0.96 (0.93; 0.99), respectively, for the lowest magnesium quintile as compared to the highest quintile A decreasing mortality due to acute myocardial infarction was seen with an increasing magnesium concentration in a dose-response manner. CONCLUSION: Low concentrations of magnesium in drinking water were associated with an increased mortality due to acute myocardial infarction. Low concentrations of magnesium in drinking water were associated with decreased cardiovascular mortality, and mortality due to stroke.

Incorporation of osteoblasts (MG63) into 3D nanofibre matrices by simultaneous electrospinning and spraying in bone tissue engineering.

Nanofibre scaffolds are suitable tools for bone tissue engineering. Mimicking the extracellular matrix, they allow for cell growth and differentiation. However, in large 3D scaffolds, uniform cell colonisation presents an unsolved problem. Our aim was to design and analyse a method of colonising nanofibre scaffolds, combining electrospinning of fibres and electrospraying of cells, to determine its impact on cell survival, growth, and gene expression. The osteoblast-like cell line MG63 was suspended in medium and electrosprayed into growing scaffolds of poly-(l-lactic acid) (PLLA) or PLLA/Col-I blend nanofibres. Fluorescein diacetate (FDA) staining was used to determine survival and growth over a 22 d culture period. Expression of osteocalcin (OC) and type I collagen (Col-I) genes was determined by real time PCR. Fluorescence microscopy was used to analyse Col-I and OC deposition, as well as cell densities. While spraying distance and cell density in the spraying solution influenced survival and cell density, the combination of electrospinning and electrospraying did not negatively influence the maintenance of the osteoblast phenotype. Furthermore, VEGF induction in response to hypoxia was not suppressed, but modulated by polymer composition. Therefore, simultaneous electrospinning and electrospraying is a suitable tool in producing nanofibre based 3D cell seeded scaffolds.

Carbonate fabrics in the modern microbialites of Pavilion Lake: two suites of microfabrics that reflect variation in microbial community morphology, growth habit, and lithification.

Modern microbialites in Pavilion Lake, BC, provide an analog for ancient non-stromatolitic microbialites that formed from in situ mineralization. Because Pavilion microbialites are mineralizing under the influence of microbial communities, they provide insights into how biological processes influence microbialite microfabrics and mesostructures. Hemispherical nodules and micrite-microbial crusts are two mesostructures within Pavilion microbialites that are directly associated with photosynthetic communities. Both filamentous cyanobacteria in hemispherical nodules and branching filamentous green algae in micrite-microbial crusts were associated with calcite precipitation at microbialite surfaces and with characteristic microfabrics in the lithified microbialite. Hemispherical nodules formed at microbialite surfaces when calcite precipitated around filamentous cyanobacteria with a radial growth habit. The radial filament pattern was preserved within the microbialite to varying degrees. Some subsurface nodules contained well-defined filaments, whereas others contained only dispersed organic inclusions. Variation in filament preservation is interpreted to reflect differences in timing and amount of carbonate precipitation relative to heterotrophic decay, with more defined filaments reflecting greater lithification prior to degradation than more diffuse filaments. Micrite-microbial crusts produce the second suite of microfabrics and form in association with filamentous green algae oriented perpendicular to the microbialite surface. Some crusts include calcified filaments, whereas others contained voids that reflect the filamentous community in shape, size, and distribution. Pavilion microbialites demonstrate that microfabric variation can reflect differences in lithification processes and microbial metabolisms as well as microbial community morphology and organization. Even when the morphology of individual filaments or cells is not well preserved, the microbial growth habit can be captured in mesoscale microbialite structures. These results suggest that when petrographic preservation is extremely good, ancient microbialite growth structures and microfabrics can be interpreted in the context of variation in community organization, community composition, and lithification history. Even in the absence of distinct microbial microfabrics, mesostructures can capture microbial community morphology.

[Anterior shoulder instability--the current situation]. / Vordere Schulterinstabilität--Aktueller Stand.

AIM: The aim of the study was to survey the current state of the conservative and operative treatment of anterior shoulder instability and its rehabilitation in German hospitals. METHODS: A previously evaluated online questionnaire was sent out to all German hospitals with orthopaedic or trauma surgery departments. The Federal Statistical Office's hospital list was the basis for the selection of hospitals. The questions referred to the year 2007. The survey, including 3 reminders, was conducted over 3 months. The questionnaire consisted of 6 response categories: always (100%), almost always (99-81%), predominantly (80-51%), rarely (50-21%), almost never (20-1%) and never (0%). RESULTS: The response rate was 41% and 67% of these had carried out shoulder stabilisations. In total, 99.2% of the 67% were evaluable. The proportion of shoulder surgery was 8.4% of the total number of operations. Shoulder stabilisations represented 10.6% of these operations. A specialised shoulder department existed in 22.9%. Conservative treatment was carried out with an immobilisation of the arm "predominantly", "almost always" and "always" for internal rotation in 70.8% and in 23.4% for external rotation. The shoulders were "predominantly", "almost always" and "always" stabilised in an arthroscopic technique in 68.2% and in an open one in 31.8% of the clinics. With 92.9%, the Bankart repair was the most common operation. Shoulder instability was principally treated with the arthroscopic technique, regardless of the care level and department and is considered the best surgical technique. Physiotherapy was prescribed "always" and "almost always" in 99.3%. The rate of reluxation after conservative treatment was estimated at 35.5%, after operative open anterior shoulder stabilisation at 9.1% and after arthroscopic shoulder stabilization at 10.6%. Nevertheless, 49.4% of respondents expected the best results after arthroscopic treatment. Participants, who mainly applied the arthroscopic technique, expected a lower rate of reluxation in comparison to other techniques (p<0.001). CONCLUSION: The operative shoulder stabilisation is most frequently carried out as arthroscopic Bankart repair. A standardised, subsequent treatment is well established.

The Brookhaven National Laboratory electron beam ion source for RHIC.

As part of a new heavy ion preinjector that will supply beams for the Relativistic Heavy Ion Collider and the National Aeronautics and Space Administration Space Radiation Laboratory, construction of a new electron beam ion source (EBIS) is now being completed. This source, based on the successful prototype Brookhaven National Laboratory Test EBIS, is designed to produce milliampere level currents of all ion species, with q/m=(1/6)-(1/2). Among the major components of this source are a 5 T, 2-m-long, 204 mm diameter warm bore superconducting solenoid, an electron gun designed to operate at a nominal current of 10 A, and an electron collector designed to dissipate approximately 300 kW of peak power. Careful attention has been paid to the design of the vacuum system, since a pressure of 10(-10) Torr is required in the trap region. The source includes several differential pumping stages, the trap can be baked to 400 C, and there are non-evaporable getter strips in the trap region. Power supplies include a 15 A, 15 kV electron collector power supply, and fast switchable power supplies for most of the 16 electrodes used for varying the trap potential distribution for ion injection, confinement, and extraction. The EBIS source and all EBIS power supplies sit on an isolated platform, which is pulsed up to a maximum of 100 kV during ion extraction. The EBIS is now fully assembled, and operation will be beginning following final vacuum and power supply tests. Details of the EBIS components are presented.

Shape coexistence in light se isotopes: evidence for oblate shapes.

Lifetimes of states in the ground-state bands of (70)Se and (72)Se were measured using the recoil-distance Doppler shift method. The results deviate significantly from earlier measurements, requiring a revision of the conclusions drawn from a recent Coulomb excitation experiment concerning the shape of (70)Se. The new results lead to a coherent picture of shape coexistence in the neutron-deficient selenium and krypton isotopes. The coexistence and evolution of oblate and prolate shapes in this mass region is for the first time consistently described by new Hartree-Fock-Bogolyubov-based configuration-mixing calculations which were performed using the Gogny D1S interaction.

Treatment with the antigranulocyte monoclonal antibody RB6-8C5 impairs resistance of mice to gastrointestinal infection with Listeria monocytogenes.

Treatment with the antigranulocyte monoclonal antibody (MAb) RB6-8C5 increased the severity of infection in mice intragastrically inoculated with Listeria monocytogenes. Most MAb RB6-8C5-treated mice died when inoculated intragastrically with as few as 4 x 10(4) L. monocytogenes bacteria, whereas most control mice survived intragastric inoculation with 4 x 10(8) L. monocytogenes bacteria. The increased severity of infection in MAb RB6-8C5-treated mice appeared to result from listerial multiplication in the spleen and liver rather than from local proliferation in the intestinal tract or mesenteric lymph nodes.

Unusual muscle abnormalities associated with thalidomide treatment in a rhesus monkey: a case report.

Unusual musculotendinous abnormalities were observed in the forelimbs of a rhesus monkey treated prenatally with thalidomide (10 mg/kg maternal body weight, gestation days 33, 34, and 35). Although the hindlimbs exhibited malformations typical of thalidomide dysmelia, the forelimbs appeared relatively normal externally. However, dissection revealed totally anomalous insertions of preaxial muscles of both forearms. Extensor muscles inserted on flexor surfaces even though normal sites of insertion were present and unoccupied. Radiographs revealed only minor ossification deficiencies in the carpus and distal radius. These observations suggest that thalidomide, given at the appropriate time, can disrupt condensation and splitting of pre-muscle masses without greatly disturbing condensation of corresponding preskeletal elements. These types of musculoskeletal relationships are unusual findings in congenital malformations of the limbs and have not been widely associated with thalidomide teratogenesis.

Specific nitrogen-15 labelling of leucine residues in human growth hormone.

Biosynthetic human growth hormone (hGH) specifically 15N labelled in the leucine residues has been obtained by recombinant DNA technology, using 15N-labelled leucine and an E. coli strain that requires leucine. It is shown that, despite the possibility of minor transaminase activity, the labelling on the whole is specific, and that the two-dimensional 1H-15N correlation NMR spectra of hGH can be greatly simplified by this methodology.

Origin of the beta S-globin gene in blacks: the contribution of recurrent mutation or gene conversion or both.

In order to investigate the origin(s) of the mutation(s) leading to the beta S-globin gene in North American populations of African ancestry, we analyzed DNA polymorphisms in the beta-globin gene cluster in a large number of both beta A- and beta S-globin gene-bearing chromosomes in U.S. and Jamaican Blacks. We found 16 different haplotypes of polymorphic sites associated with 170 beta S-globin gene-bearing chromosomes. The three most common beta S haplotypes, which account for 151/170 of the beta S-globin gene-bearing chromosomes, are only rarely seen in the chromosomes bearing the beta A-globin gene in these populations (6/47). Two observations suggest multiple origins or interallelic gene conversion, or both, of the beta S mutation. First, the mutation is present in all three beta-globin gene frameworks. Second, the beta S haplotypes can be divided into four groups, each of which cannot be derived from any other by less than two crossing-over events. In summary, our observation of the beta S mutation on 16 different haplotypes in African populations can be best explained by (i) a number of simple recombination events 5' to the beta-globin gene and (ii) up to four independent mutations and/or interallelic gene conversions.