Superhydrophobicity enhancement through substrate flexibility.

Inspired by manifestations in nature, microengineering and nanoengineering of synthetic materials to achieve superhydrophobicity has been the focus of much work. Generally, hydrophobicity is enhanced through the combined effects of surface texturing and chemistry; being durable, rigid materials are the norm. However, many natural and technical surfaces are flexible, and the resulting effect on hydrophobicity has been largely ignored. Here, we show that the rational tuning of flexibility can work synergistically with the surface microtexture or nanotexture to enhance liquid repellency performance, characterized by impalement and breakup resistance, contact time reduction, and restitution coefficient increase. Reduction in substrate areal density and stiffness imparts immediate acceleration and intrinsic responsiveness to impacting droplets (∼350 × g), mitigating the collision and lowering the impalement probability by ∼60% without the need for active actuation. Furthermore, we exemplify the above discoveries with materials ranging from man-made (thin steel or polymer sheets) to nature-made (butterfly wings).

Imparting Icephobicity with Substrate Flexibility.

Ice accumulation hinders the performance of, and poses safety threats for, infrastructure both on the ground and in the air. Previously, rationally designed superhydrophobic surfaces have demonstrated some potential as a passive means to mitigate ice accretion; however, further studies on material solutions that reduce impalement and the contact time for impacting supercooled droplets (high viscosity) and can also repel droplets that freeze during surface contact are urgently needed. Here we demonstrate the collaborative effect of substrate flexibility and surface micro/nanotexture on enhancing both icephobicity and the repellency of viscous droplets (typical of supercooled water). We first investigate the influence of increased viscosity (spanning from 0.9 to 1078 mPa·s using water-glycerol mixtures) on impalement resistance and the droplet-substrate contact time after impact. Then we examine the effect of droplet partial solidification on recoil and simulate more challenging icing conditions by impacting supercooled water droplets (down to -15 °C) onto flexible and rigid surfaces containing ice nucleation promoters (AgI). We demonstrate a passive mechanism for shedding partially solidified (recalescent) droplets-under conditions where partial solidification occurs much faster than the natural droplet oscillation-which does not rely on converting droplet surface energy into kinetic energy (classic recoil mechanism). Using an energy-based model (kinetic-elastic-capillary), we identify a previously unexplored mechanism whereby the substrate oscillation and velocity govern the rebound process, with low areal density and moderately stiff substrates acting to efficiently absorb the incoming droplet kinetic energy and rectify it back, allowing droplets to overcome adhesion and gravitational forces, and recoil. This mechanism applies for a range of droplet viscosities, spanning from low- to high-viscosity fluids and even ice slurries, which do not rebound from rigid superhydrophobic substrates. For a low-viscosity fluid, i.e., water, if the substrate oscillates faster than the droplet spreading and retraction, the action of the substrate is decoupled from the droplet oscillation, resulting in a reduction in the droplet-substrate contact time.

Correction: A biomimetic approach to shielding from ionizing radiation: The case of melanized fungi.

[This corrects the article DOI: 10.1371/journal.pone.0229921.].

Light absorption enhancement and radiation hardening for triple junction solar cell through bioinspired nanostructures.

Multi-junction solar cells constitute the main source of power for space applications. However, exposure of solar cells to the space radiation environment significantly degrades their performance across the mission lifetime. Here, we seek to improve the radiation hardness of the triple junction solar cell, GaInP/Ga(In)As/Ge, by decreasing the thickness of the more sensitive middle junction. Thin junctions facilitate the collection of minority carriers and show slower degradation due to defects. However, thinning the junction decreases the absorption, and consequently, the expected photocurrent. To compensate for this loss, we examined two bioinspired surface patterns that exhibit anti-reflective and light-trapping properties: (a) the moth-eye structure which enables vision in poorly illuminated environments and (b) the patterns of the hard cell of a unicellular photosynthetic micro-alga, the diatoms. We parametrize and optimize the biomimetic structures, aiming to maximize the absorbed light by the solar cell while achieving significant reduction in the middle junction thickness. The density of the radiation-induced defects is independent of the junction thickness, as we demonstrate using Monte Carlo simulations, allowing the direct comparison of different combinations of middle junction thicknesses and light trapping structures. We incorporate the radiation effects into the solar cell model as a decrease in minority carrier lifetime and an increase in surface recombination velocity, and we quantify the gain in efficiency for different combinations of junction thickness and the light-trapping structure at equal radiation damage. Solar cells with thin junctions compensated by the light-trapping structures offer a promising approach to improve solar cell radiation hardness and robustness, with up to 2% higher end-of-life efficiency than the commonly used configuration at high radiation exposure.

A biomimetic approach to shielding from ionizing radiation: The case of melanized fungi.

Melanized fungi have been shown to thrive in environments with high radionuclide concentrations, which led to the association of the pigment melanin with the protection against ionizing radiation. Several hypotheses regarding the function of melanin have been proposed. Yet, the exact mechanism behind the protective property of melanin is unclear and poorly explored. A better understanding of the mechanisms that are involved in increasing the tolerance of the organisms to ionizing radiation could lead to technology transfer to human-related applications. Effective protection from radiation is essential for human space flight in general and human missions beyond Low Earth Orbit specifically. In this paper, we follow a biomimetic approach: we test two of current hypotheses and discuss how they could be applied to radiation shield designs. First we focus on the interaction of melanin with high energy electrons, which has been suspected to reduce the kinetic energy of the electrons through a cascade of collisions, thus providing physical shielding. Second, we investigate if the spatial arrangement of melanin, organized as a thin film or a collection of hollow micro-spheres, affects its shielding properties. To this end, we measured experimentally and by numerical simulations the attenuation of ß-radiation as pass through solutions and suspensions of melanin and contrasted the values to the ones of cellulose, a substance with similar elemental composition. Further, we investigate the spatial arrangement hypothesis using Monte Carlo simulations. In agreement with the simulations, our experiments indicated that melanin does not provide improved shielding in comparison to cellulose from ß-radiation. However, our simulations suggest a substantial effect of the spatial arrangement on the shielding performance of melanin, a pathway that could be transferred to the design of composite radiation shields.

Toward Contactless Biology: Acoustophoretic DNA Transfection.

Acoustophoresis revolutionized the field of container-less manipulation of liquids and solids by enabling mixing procedures which avoid contamination and loss of reagents due to the contact with the support. While its applications to chemistry and engineering are straightforward, additional developments are needed to obtain reliable biological protocols in a contactless environment. Here, we provide a first, fundamental step towards biological reactions in air by demonstrating the acoustophoretic DNA transfection of mammalian cells. We developed an original acoustophoretic design capable of levitating, moving and mixing biological suspensions of living mammalians cells and of DNA plasmids. The precise and sequential delivery of the mixed solutions into tissue culture plates is actuated by a novel mechanism based on the controlled actuation of the acoustophoretic force. The viability of the contactless procedure is tested using a cellular model sensitive to small perturbation of neuronal differentiation pathways. Additionally, the efficiency of the transfection procedure is compared to standard, container-based methods for both single and double DNA transfection and for different cell types including adherent growing HeLa cancer cells, and low adhesion neuron-like PC12 cells. In all, this work provides a proof of principle which paves the way to the development of high-throughput acoustophoretic biological reactors.