Testosterone positively regulates vagina NO-induced relaxation: an experimental study in rats.

PURPOSE: Female sexual response involves a complex interplay between neurophysiological mechanisms and the nitric oxide (NO)-mediated relaxation of clitoris and vagina. The aim of this study was to evaluate sex steroids regulation of the relaxant pathway in vagina, using a validated animal model. METHODS: Subgroups of OVX Sprague-Dawley rats were treated with 17ß-estradiol, testosterone, or testosterone and letrozole, and compared with a group of intact animals. Masson's trichrome staining was performed for morphological evaluation of the distal vaginal wall, in vitro contractility studies investigated the effect of OVX and in vivo treatments on vaginal smooth muscle activity. RNA from vaginal tissue was analyzed by semi-quantitative RT-PCR. RESULTS: Immunohistochemical analysis showed that OVX induced epithelial and smooth muscle structural atrophy, testosterone and testo + letrozole increased the muscle bundles content and organization without affecting the epithelium while 17ß-estradiol mediated the opposite effects. In vitro contractility studies were performed on noradrenaline pre-contracted vaginal strips from each experimental group. Acetylcholine (0.001-10 µM) stimulation induced a concentration-dependent relaxation, significantly reduced by NO-synthase inhibitor L-NAME and by guanylate cyclase inhibitor ODQ. OVX resulted in a decreased responsiveness to acetylcholine, restored by testosterone, with or without letrozole, but not by 17ß-estradiol. OVX sensitivity to the NO-donor SNP was higher than in the control. Vardenafil, a PDE5 inhibitor, enhanced SNP effect in OVX + testosterone as well as in control, as supported by RNA expression analysis. CONCLUSIONS: Our study demonstrates that testosterone improves the NO-mediated smooth muscle vaginal cells relaxation confirming its role in maintaining the integrity of muscular relaxant machinery.

Classification and comparison of capillary columns by determination of the solution enthalpy of polar and non polar probes.

The behaviour and separation characteristics of capillary columns containing different stationary phases (bonded methyl- and methylphenylsiloxanes and polyglycols, and carbon layer and porous polymer) were classified and compared by measuring the values of the solution enthalpy DeltaHs of n-alkanes and 1-alcohols at various temperatures. The difference in DeltaHs values between straight-chain 1-alcohols and n-alkanes with the same number of carbon atom (DeltaDeltaHs) does not change with changing temperature when gas-liquid partition stationary phases are used, but depends on the column composition and polarity and therefore permits to evaluate the influence of polarity on the solute-solvent interaction. The trend of the DeltaDeltaHs values is correlated with that of the DeltaC parameter and with the McReynolds' polarity constants.

Prediction of theoretical plate number in isothermal gas chromatographic analysis on capillary columns.

A method for the prediction of the efficiency of gas chromatographic analysis in isothermal conditions by using experimental data of 1-alcohols and n-alkanes measured on capillary columns filled with polar and non-polar stationary phases in isothermal and isobaric conditions is described. The theoretical plate height trend indicates the change of separation efficiency as a function of inlet pressure and column temperature. By evaluating the variation of the diffusion coefficients of the analysed compounds into the mobile and stationary phase it is possible to predict the column efficiency and the number of theoretical plates at any temperature.

Effect of injected sample amount on the shape of chromatographic peaks under condition of linear partition isotherm.

In a previous paper a model function was tested in order to approximate the peak shape obtained on non-polar column by injecting different compounds. The simulation of the symmetrical or non-symmetrical shape of gas chromatographic peaks was satisfactory. In this paper, the influence of the amount of injected substance was investigated at different values of inlet pressure and carrier gas velocity, in order to evaluate the relative contribution to the total peak area and shape of the symmetrical distribution due to partition phenomena and of the non-symmetrical and tailing distribution due to adsorption-desorption kinetics. The effect of the molecular mass and of the chain length of compounds belonging to the homologous series of 1-alcohols and n-alkanes on the adsorption phenomena was evaluated.

Prediction of retention times and efficiency in linear gradient programmed pressure analysis on capillary columns.

A method for the prediction of the retention time and the resolution of chromatographic peaks in different experimental conditions by starting from few experimental data measured in isothermal and isobaric analyses was published previously. In this paper, the same mathematical model was implemented for calculating the retention times and the column efficiency in programmed pressure runs. Some models originated from the Golay equation and reported in the literature are compared, and a new modified equation for the calculation of the peak width at half height is proposed. The procedure for the prediction of the retention time and the peak width at half height at programmed pressure of the carrier gas and different column temperature and linear gradient by using retention data of different compounds obtained in few isobaric runs is described. The prediction of the retention time and the separation efficiency of compounds with different polarity gave good results for the programmed pressure runs with linear gradient. The effect of the variation of the initial parameters of the experimental analyses and of the mathematical model on the accuracy of the prediction has been evaluated.

Prediction of the plate height of capillary columns operated at any inlet pressure of the carrier gas by using few retention data measured under isobaric conditions.

Programming inlet pressure in gas chromatography permits to decrease the analysis time without changing the elution order of compounds of different polarity whose relative retention changes with changing temperature. The choice of the best values of the inlet pressure and flow-rate of the carrier gas often requires many preliminary analyses with different parameters to be carried out. A method for the prediction of the separation by starting from few experimental data measured in isothermal and isobaric conditions decreases the time required for the optimisation of the analysis. The efficiency of the separation depends on the change of the theoretical plate height at various pressures and temperatures, due to pressure drop along the column. By calculation of the diffusion coefficients of the analysed compounds into the mobile and stationary phase it is possible to evaluate the column efficiency and predict the number of theoretical plates at any inlet pressure. A procedure for the prediction of the plate height of a capillary column at any inlet pressure of the carrier gas and column temperature by using retention data of polar and non-polar compounds (1-alcohols and linear alkanes) obtained in few isobaric runs is described.

Prediction of retention times in linear gradient temperature and pressure programmed analysis on capillary columns.

The simultaneous temperature and inlet pressure programming (TPP) in gas chromatographic analysis decreases the retention time and the maximum value of temperature required for the elution of high boiling substances. Therefore, compounds sensitive to thermal degradation can be better analysed and column ageing is reduced. However, the empirical choice of proper analysis conditions requires many preliminary runs; this paper describes a procedure for the theoretical prediction of retention times in TPP using few preliminary runs carried out in isobaric and isothermal conditions. The used program permits the prediction of the retention times of the compounds analysed with any different TPP run carried out within the temperature and pressure ranges investigated with the preliminary runs. The influence of various analytical parameters on the accuracy of the prediction values was investigated. The proposed model also predicts the relative position in the chromatogram of closely eluting peaks and the possible coincidence of retention times or inversion of the elution order with changing temperature. It is also possible to foresee the analytical conditions, which offer a baseline separation of all of the peaks of the sample.

Prediction of the resolution of capillary columns in different conditions of inlet pressure and temperature.

A procedure previously described for the prediction of the plate height of capillary columns operated at different inlet pressure of the carrier gas and at various column temperatures by using few retention data measured under isobaric conditions was modified and improved in order to permit the prediction of the retention times and of the peak widths at various heights. It is therefore possible to calculate the ratio, delta, between the peak width at different heights and the peak width at half height, whose value is used to predict the resolution at different height of two closely eluting peaks. It was found that the delta values do not depend on temperature and inlet pressure and are a characteristic of the used column; they can therefore be used in order to calculate the resolution in any temperature and inlet pressure condition. The method was used to predict the retention time, the peak width and the resolution of polar and non-polar compounds (alkanes, alkenes, chloroalkanes, alcohols, ketones) on capillary columns of different length and polarity by using as the starting data retention and width values measured in three isobaric runs only.

Evaluation and prediction of the shape of gas chromatographic peaks.

The evaluation and prediction of the shape of asymmetric gas chromatographic peaks is important as the knowledge of the amount of tailing permits to foresee the resolution between closely eluting peaks and to select the best analytical conditions for an efficient and rapid separation. A model function was tested in order to approximate the true peak shape obtained on non-polar column by injecting different compounds. The trend of the parameters involved in the used equation has been investigated as a function of column temperature and inlet pressure. The reproduction of the symmetrical or asymmetrical shape of gas chromatographic peaks is satisfactory and the method also permits to predict the shape of peaks obtained in different conditions of temperature and pressure.

A note on the influence of grouping on illusory contours.

It is well known that dots superimposed on the Koffka cross change the shape of the illusory surface. It has been claimed, but never proved, that this effect is due to the shape of the virtual figure inwhich the dots organize. In this note it is proved that the shape of the virtual figure is indeed the crucial factor. In fact, the shape of the illusory surface changes if the way in which the dots organize is altered by adding other dots; if, then, the former organization is restored by adding further dots, the illusory shape is restored too, at least to a large extent.

Retention models for programmed gas chromatography.

The models proposed by many authors for the prediction of retention times and temperatures, peak widths, retention indices and separation numbers in programmed temperature and pressure gas chromatography by starting from preliminary measurements of the retention in isothermal and isobaric conditions are reviewed. Several articles showing the correlation between retention data and thermodynamic parameters and the determination of the optimum programming rate are reported. The columns of different polarity used for the experimental measurement and the main equations, mathematical models and calculation procedures are listed. An empirical approach was used in the early models, followed by the application of thermodynamic considerations, iterative calculation procedures and statistical methods, based on increased computing power now available. Multiple column arrangements, simultaneous temperature and pressure programming, applications of two-dimensional and fast chromatography are summarised.

A calculation method for the prediction of effective plate height in capillary gas chromatography.

The effective plate height, h(eff), is considered to be a better measure of the efficiency of capillary column than the conventional plate height, h, in isothermal conditions. By using experimental data of 1-alcohols and n-alkanes, 2-ketones and 1-alkenes measured on capillary columns coated with non-polar stationary phases in isothermal and isobaric conditions, the peak width at half height is predicted with a function similar at that of adjusted retention time. The results obtained under different analytical conditions as the head pressure and the temperature of the column confirm the validity of the model, whose parameters are linear, and as a consequence a unique solution is obtained.

Prediction of the separation number of capillary columns in programmed temperature gas chromatographic analysis.

The efficiency of capillary columns in programmed temperature analysis can be evaluated by calculation of the separation number ("Trennzahl"). A procedure for the prediction of this parameter at various initial temperatures, carrier gas pressures and heating rates, by using as the starting data the retention times and the peak widths obtained in some isobaric and isothermal runs is described. An equation is proposed that permits to obtain the values of the peak width at half height in any isothermal and linearly programmed temperature gas chromatographic run and therefore to calculate the separation number value. The effect on this parameter of the column polarity was investigated by using polar and non-polar compounds (n-alkanes and 1-alcohols).

Shrinkage and expansion by amodal completion: a critical review.

The whole literature on the so-called dimensional effects of amodal completion (shrinkage of a partially occluded figure and expansion of modally visible parts of the same figure) is critically reviewed. It is claimed that phenomenal shrinkage is the sum of at least two illusions independent of figure ground distinction: (1) shrinkage of spaces divided into a few parts, and (2) shrinkage of empty spaces. It is also shown that a partially occluded figure can widen, rather than shrink. It is concluded that the stratification in two phenomenally superimposed figures accompanies the shrinkage effect, but is irrelevant to its generation. Further experiments are needed in order to draw a well-grounded conclusion on the expansion effect.

A new motion illusion related to the aperture problem.

A previously unreported motion illusion is described. Oblique lines that drift smoothly on the retina in a vertical direction appear to be displaced laterally. The effect occurs both for moving lines under fixation and for stationary lines under ocular tracking of an external target. Orientation, length, and homogeneity of the obliques affect the magnitude of illusory displacement. We propose that this illusion is associated with a misregistration of the direction of displacement occurring, in lines slanted relative to the axis of their motion, because of the aperture problem.