Metal bond strength regulation enables large-scale synthesis of intermetallic nanocrystals for practical fuel cells.

Structurally ordered L10-PtM (M = Fe, Co, Ni and so on) intermetallic nanocrystals, benefiting from the chemically ordered structure and higher stability, are one of the best electrocatalysts used for fuel cells. However, their practical development is greatly plagued by the challenge that the high-temperature (>600 °C) annealing treatment necessary for realizing the ordered structure usually leads to severe particle sintering, morphology change and low ordering degree, which makes it very difficult for the gram-scale preparation of desirable PtM intermetallic nanocrystals with high Pt content for practical fuel cell applications. Here we report a new concept involving the low-melting-point-metal (M' = Sn, Ga, In)-induced bond strength weakening strategy to reduce Ea and promote the ordering process of PtM (M = Ni, Co, Fe, Cu and Zn) alloy catalysts for a higher ordering degree. We demonstrate that the introduction of M' can reduce the ordering temperature to extremely low temperatures (≤450 °C) and thus enable the preparation of high-Pt-content (≥40 wt%) L10-Pt-M-M' intermetallic nanocrystals as well as ten-gram-scale production. X-ray spectroscopy studies, in situ electron microscopy and theoretical calculations reveal the fundamental mechanism of the Sn-facilitated ordering process at low temperatures, which involves weakened bond strength and consequently reduced Ea via Sn doping, the formation and fast diffusion of low-coordinated surface free atoms, and subsequent L10 nucleation. The developed L10-Ga-PtNi/C catalysts display outstanding performance in H2-air fuel cells under both light- and heavy-duty vehicle conditions. Under the latter condition, the 40% L10-Pt50Ni35Ga15/C catalyst delivers a high current density of 1.67 A cm-2 at 0.7 V and retains 80% of the current density after extended 90,000 cycles, which exceeds the United States Department of Energy performance metrics and represents among the best cathodic electrocatalysts for practical proton-exchange membrane fuel cells.

Inducing Mn defects within MnTiO3 cathode for aqueous zinc-ion batteries.

Layered manganese-based cathode materials are considered as one of the promising cathodes benefit from inherent low manufacturing cost, non-toxic and high safety in aqueous zinc-ion batteries (AZIBs). However, the sluggish reaction kinetics within layered cathodes is inevitable due to the poor electrical/ionic conductivity. Herein, MnTiO3 is reported as a new cathode material for AZIBs and in-situ induced Mn-defect within MnTiO3 during the first charging is desirable to improve the reaction kinetics to a great extent. Additionally, DFT calculations further demonstrate that MnTiO3 with manganese defects exhibits a uniform charge distribution at the defect sites, enhancing the attraction towards H+ and Zn2+ ions. Furthermore, it performs good cycling stability which can obtain 115 mA h g-1 even at 400 mA g-1 after 450 cycles and the discharge capacity reaches up to 233.8 mAh/g at 100 mA g-1 when Mn-defect MnTiO3 was employed as the cathode. This research could provide a new method for the development and mechanism research of cathode materials for AZIBs.

SARS-CoV-2 Vaccination Improves Semen Quality in Men Recovered From COVID-19: A Retrospective Cohort Study.

Coronavirus disease 2019 (COVID-19) has been reported to decrease semen quality in reproductive-age men. Semen quality in vaccinated men after SARS-CoV-2 infection remains unclear. We recruited reproductive-age Chinese men scheduled for COVID-19 vaccination from December 2022 to March 2023. Among 1,639 vaccinated participants, an upward trend was found in sperm concentration (p < .001), progressive motility (p < .001), total motility (p < .001), total motile sperm count (TMSC) (p < .001), and normal morphology (p = .01) over time following COVID-19 recovery. Among men with an SARS-CoV-2 infection that lasted less than 30 days, men who received an inactivated vaccine booster had higher sperm progressive (p = .006) and total motility (p = .005) as well as TMSC (p = .008) than those without a booster vaccine, whereas no difference was found in semen parameters among men who received a recombinant protein vaccine. Similarly, an upward trend in semen quality was found among 122 men who provided semen samples before and after COVID-19. Higher risks of asthenozoospermia (odds ratio [OR] = 2.23, p < .001) and teratozoospermia (OR = 2.09, p = .03) were found among men who had an SARS-CoV-2 infection that lasted less than 30 days than among those without COVID-19. Collectively, after receiving SARS-CoV-2 vaccination, adverse but reversible semen parameters were observed in men recovering from COVID-19 over time. Recombinant protein vaccines and inactivated vaccine boosters should be recommended to all reproductive-age men.

Two-Dimensional Transition Metal Boron Cluster Compounds (MBnenes) with Strain-Independent Room-Temperature Magnetism.

Two-dimensional (2D) metal borides (MBenes) with unique electronic structures and physicochemical properties hold great promise for various applications. Given the abundance of boron clusters, we proposed employing them as structural motifs to design 2D transition metal boron cluster compounds (MBnenes), an extension of MBenes. Herein, we have designed three stable MBnenes (M4(B12)2, M = Mn, Fe, Co) based on B12 clusters and investigated their electronic and magnetic properties using first-principles calculations. Mn4(B12)2 and Co4(B12)2 are semiconductors, while Fe4(B12)2 exhibits metallic behavior. The unique structure in MBnenes allows the coexistence of direct exchange interactions between adjacent metal atoms and indirect exchange interactions mediated by the clusters, endowing them with a Néel temperature (TN) up to 772 K. Moreover, both Mn4(B12)2 and Fe4(B12)2 showcase strain-independent room-temperature magnetism, making them potential candidates for spintronics applications. The MBnenes family provides a fresh avenue for the design of 2D materials featuring unique structures and excellent physicochemical properties.

Association of redundant foreskin with sexual dysfunction: a cross-sectional study from 5700 participants.

A previous study showed that the length of the foreskin plays a role in the risk of sexually transmitted infections and chronic prostatitis, which can lead to poor quality of sexual life. Here, the association between foreskin length and sexual dysfunction was evaluated. A total of 5700 participants were recruited from the andrology clinic at The First Affiliated Hospital of University of Science and Technology of China (Hefei, China). Clinical characteristics, including foreskin length, were collected, and sexual function was assessed by the International Index of Erectile Function-5 (IIEF-5) and Premature Ejaculation Diagnostic Tool (PEDT) questionnaires. Men with sexual dysfunction were more likely to have redundant foreskin than men without sexual dysfunction. Among the 2721 erectile dysfunction (ED) patients and 1064 premature ejaculation (PE) patients, 301 (11.1%) ED patients and 135 (12.7%) PE patients had redundant foreskin, respectively. Men in the PE group were more likely to have redundant foreskin than men in the non-PE group (P = 0.004). Logistic regression analyses revealed that the presence of redundant foreskin was associated with increased odds of moderate/severe ED (adjusted odds ratio [aOR] = 1.31, adjusted P = 0.04), moderate PE (aOR = 1.38, adjusted P = 0.02), and probable PE (aOR = 1.37, adjusted P = 0.03) after adjusting for confounding variables. Our study revealed a positive correlation between the presence of redundant foreskin and the risk of sexual dysfunction, especially in PE patients. Assessment of the length of the foreskin during routine clinical diagnosis may provide information for patients with sexual dysfunction.