Development of a dual-component infection-resistant arterial replacement for small-caliber reconstructions: A proof-of-concept study.

Introduction: Synthetic vascular grafts perform poorly in small-caliber (<6mm) anastomoses, due to intimal hyperplasia and thrombosis, whereas homografts are associated with limited availability and immunogenicity, and bioprostheses are prone to aneurysmal degeneration and calcification. Infection is another important limitation with vascular grafting. This study developed a dual-component graft for small-caliber reconstructions, comprising a decellularized tibial artery scaffold and an antibiotic-releasing, electrospun polycaprolactone (PCL)/polyethylene glycol (PEG) blend sleeve. Methods: The study investigated the effect of nucleases, as part of the decellularization technique, and two sterilization methods (peracetic acid and γ-irradiation), on the scaffold's biological and biomechanical integrity. It also investigated the effect of different PCL/PEG ratios on the antimicrobial, biological and biomechanical properties of the sleeves. Tibial arteries were decellularized using Triton X-100 and sodium-dodecyl-sulfate. Results: The scaffolds retained the general native histoarchitecture and biomechanics but were depleted of glycosaminoglycans. Sterilization with peracetic acid depleted collagen IV and produced ultrastructural changes in the collagen and elastic fibers. The two PCL/PEG ratios used (150:50 and 100:50) demonstrated differences in the structural, biomechanical and antimicrobial properties of the sleeves. Differences in the antimicrobial activity were also found between sleeves fabricated with antibiotics supplemented in the electrospinning solution, and sleeves soaked in antibiotics. Discussion: The study demonstrated the feasibility of fabricating a dual-component small-caliber graft, comprising a scaffold with sufficient biological and biomechanical functionality, and an electrospun PCL/PEG sleeve with tailored biomechanics and antibiotic release.

Control of femtosecond thin-flap LASIK using OCT in human donor eyes.

PURPOSE: Thin-flap keratomileusis is a procedure that minimizes LASIK flap thickness to preserve both the corneal epithelium and the maximum residual stroma. This study investigated the usefulness of optical coherence tomography (OCT) as a tool in guiding the femtosecond laser in the creation of a thin flap in human eyes in a non-randomized case series. METHODS: In a private research laboratory, an in vitro investigation was performed on human autopsy eyes. Five human cadaver eyes, unsuitable for transplantation, underwent flap creation with a femtosecond laser. The laser procedure was controlled in real-time with an OCT system (Thorlabs HL AG) to ensure that the cut was placed just underneath Bowman's layer. The repetition rate of the femtosecond laser was 10 MHz with a single-pulse duration of <400 femtoseconds (pulse energy in the nJ range). As a control, all eyes underwent histological dissection and were examined using light microscopy. RESULTS: Video monitoring of the flap creation supported the feasibility of real-time OCT monitoring of the femtosecond laser flap creation process. A clear distinction of the corneal epithelium was possible in all eyes. Bowman's layer was not identified in all donor eyes at the given resolution of the OCT device used in this study. Light microscopy demonstrated flaps approximately 50-microm thick, confirming that the real-time monitoring assured a positioning of the cutting plane at minimum distance underneath Bowman's layer. CONCLUSIONS: This study of five human cadaver eyes shows that real-time OCT monitoring of the creation of thin-flaps in LASIK using a femtosecond laser is possible, thus ensuring that the flap is created at the desired depth.

Use of sucrose to diminish pore formation in freeze-dried heart valves.

Freeze-dried storage of decellularized heart valves provides easy storage and transport for clinical use. Freeze-drying without protectants, however, results in a disrupted histoarchitecture after rehydration. In this study, heart valves were incubated in solutions of various sucrose concentrations and subsequently freeze-dried. Porosity of rehydrated valves was determined from histological images. In the absence of sucrose, freeze-dried valves were shown to have pores after rehydration in the cusp, artery and muscle sections. Use of sucrose reduced pore formation in a dose-dependent manner, and pretreatment of the valves in a 40% (w/v) sucrose solution prior to freeze-drying was found to be sufficient to completely diminish pore formation. The presence of pores in freeze-dried valves was found to coincide with altered biomechanical characteristics, whereas biomechanical parameters of valves freeze-dried with enough sucrose were not significantly different from those of valves not exposed to freeze-drying. Multiphoton imaging, Fourier transform infrared spectroscopy, and differential scanning calorimetry studies revealed that matrix proteins (i.e. collagen and elastin) were not affected by freeze-drying.

3D imaging of transition metals in the zebrafish embryo by X-ray fluorescence microtomography.

Synchrotron X-ray fluorescence (SXRF) microtomography has emerged as a powerful technique for the 3D visualization of the elemental distribution in biological samples. The mechanical stability, both of the instrument and the specimen, is paramount when acquiring tomographic projection series. By combining the progressive lowering of temperature method (PLT) with femtosecond laser sectioning, we were able to embed, excise, and preserve a zebrafish embryo at 24 hours post fertilization in an X-ray compatible, transparent resin for tomographic elemental imaging. Based on a data set comprised of 60 projections, acquired with a step size of 2 µm during 100 hours of beam time, we reconstructed the 3D distribution of zinc, iron, and copper using the iterative maximum likelihood expectation maximization (MLEM) reconstruction algorithm. The volumetric elemental maps, which entail over 124 million individual voxels for each transition metal, revealed distinct elemental distributions that could be correlated with characteristic anatomical features at this stage of embryonic development.