Dimensioning of a multibeam coherent photonic beamformer fed by a phased array antenna.

The design and dimensioning of a photonic-aided payload for a multi-beam high-throughput communications satellite is a complex problem in which the antenna, RF and photonic subsystems must be considered as a whole for achieving best performance with lowest mass and power consumption. In this paper, we propose and dimension the receiving stage of a communications satellite comprising a phased array antenna (PAA) feeding a multibeam photonic beamforming system (PBS). The PBS uses a single wavelength and resorts to heterodyne detection such that the retrieved beams are frequency downconverted. End-to-end system modeling shows that the complexity of the PAA and PBS can be traded-off for signal-to-noise ratio (SNR) or power consumption without compromising the beam width. The dimensioning of a realistic scenario is presented, showing that an SNR and beam crosstalk on the order of 20 dB are achievable with a total power consumption below 1 kW for a typical number of 100 antenna elements (AEs).

Reconfigurable monitoring and control system for tunable optical delay lines.

In this Letter, we propose a monitoring and control system (MCS) for operating tunable optical delay lines (TODLs), regardless of their operation principle and implementation technology. The monitoring system resorts to two out-of-band pilot tones added to the input optical signal. The amplitude and phase difference between tones are retrieved to the control system, which calculates and applies the TODL control signals. The MCS was validated using a Mach-Zehnder delay interferometer-based TODL, implemented in three different silicon photonic integrated circuits (PICs). The three PICs resort to different kinds of phase shifters based on thermo-optic, carrier-injection, and carrier-depletion effects. The proposed MCS enabled tuning the delay within the entire range of the TODL in all tested PICs. The scalability of the MCS for large-scale photonic beamformers is discussed.

Highly efficient CW parametric conversion at 1550 nm in SOI waveguides by reverse biased p-i-n junction.

In this paper we present four-wave mixing (FWM) based parametric conversion experiments in p-i-n diode assisted silicon-on-insulator (SOI) nano-rib waveguides using continuous-wave (CW) light around 1550 nm wavelength. Using a reverse biased p-i-n waveguide diode we observe an increase of the wavelength conversion efficiency of more than 4.5 dB compared to low loss nano-rib waveguides without p-i-n junction, achieving a peak efficiency of -1 dB. Conversion efficiency improves also by more than 7 dB compared to previously reported experiments deploying 1.5 µm SOI waveguides with p-i-n structure. To the best of our knowledge, the observed peak conversion efficiency of -1dB is the highest CW efficiency in SOI reported so far.

Toward coherent O-band data center interconnects.

Upcoming generations of coherent intra/inter data center interconnects currently lack a clear path toward a reduction of cost and power consumption, which are the driving factors for these data links. In this work, the tradeoffs associated with a transition from coherent C-band to O-band silicon photonics are addressed and evaluated. The discussion includes the fundamental components of coherent data links, namely the optical components, fiber link and transceivers. As a major component of these links, a monolithic silicon photonic BiCMOS O-band coherent receiver is evaluated for its potential performance and compared to an analogous C-band device.

Modular coherent photonic-aided payload receiver for communications satellites.

Ubiquitous satellite communications are in a leading position for bridging the digital divide. Fulfilling such a mission will require satellite services on par with fibre services, both in bandwidth and cost. Achieving such a performance requires a new generation of communications payloads powered by large-scale processors, enabling a dynamic allocation of hundreds of beams with a total capacity beyond 1 Tbit s-1. The fact that the scale of the processor is proportional to the wavelength of its signals has made photonics a key technology for its implementation. However, one last challenge hinders the introduction of photonics: while large-scale processors demand a modular implementation, coherency among signals must be preserved using simple methods. Here, we demonstrate a coherent photonic-aided receiver meeting such demands. This work shows that a modular and coherent photonic-aided payload is feasible, making way to an extensive introduction of photonics in next generation communications satellites.