RESUMO
When designing a molecular electronic device for a specific function, it is necessary to control whether the charge-transport mechanism is phase-coherent transmission or particle-like hopping. Here we report a systematic study of charge transport through single zinc-porphyrin molecules embedded in graphene nanogaps to form transistors, and show that the transport mechanism depends on the chemistry of the molecule-electrode interfaces. We show that van der Waals interactions between molecular anchoring groups and graphene yield transport characteristic of Coulomb blockade with incoherent sequential hopping, whereas covalent molecule-electrode amide bonds give intermediately or strongly coupled single-molecule devices that display coherent transmission. These findings demonstrate the importance of interfacial engineering in molecular electronic circuits.
RESUMO
Polyyne polyrotaxanes, encapsulated cyclocarbon catenanes and other fascinating mechanically interlocked carbon-rich architectures should become accessible if masked alkyne equivalents (MAEs) can be developed that are large enough to prevent unthreading of a macrocycle, and that can be cleanly unmasked under mild conditions. Herein, we report the synthesis of a new bulky MAE based on t-butylbicyclo[4.3.1]decatriene. This MAE was used to synthesize a polyyne [2]rotaxane and a masked-polyyne [3]rotaxane by Cadiot-Chodkiewicz coupling. Glaser cyclo-oligomerization of the [2]rotaxane gave masked cyclocarbon catenanes. The unmasking behavior of the catenanes and rotaxanes was tested by photolysis at a range of UV wavelengths. Photochemical unmasking did not proceed cleanly enough to prepare extended encapsulated polyyne polyrotaxanes. We highlight the scope and challenges involved with this approach to interlocked carbon-rich architectures.
RESUMO
Bulky photolabile masked alkyne equivalents (MAEs) are needed for the synthesis of polyyne polyrotaxanes, as insulated molecular wires and as stabilized forms of the linear polymeric allotrope of carbon, carbyne. We have synthesized a novel MAE based on phenanthrene and compared it with an indane-based MAE. Photochemical unmasking of model compounds was studied at different wavelengths (250 and 350 nm), and key products were identified by NMR spectroscopy and X-ray crystallography. UV irradiation at 250 nm leads to unmasking of both MAEs. Irradiation of the phenanthrene system at 350 nm results in quantitative dimerization via [2 + 2] cycloaddition to form a [3]-ladderane; irradiation of this ladderane at 250 nm generates a dihydrotriphenylene, which can be oxidized easily to a triphenylene. Irradiation of the indane-based MAE at 350 nm in the presence of traces of oxygen forms an endoperoxide and a bisepoxide. Both MAEs have been incorporated into rotaxanes via copper-mediated active metal template Glaser or Cadiot-Chodkiewicz coupling. The identity of the rotaxanes was confirmed by NMR spectroscopy and mass spectrometry. The phenanthrene rotaxane decomposes during attempted photochemical unmasking, whereas photolysis of the indane rotaxane results in unmasking of the polyyne thread to form a rotaxane with a chain of 16 sp-hybridized carbon atoms. This approach opens avenues toward the synthesis of encapsulated carbon allotropes.
Assuntos
Poli-Inos/química , Rotaxanos/química , Cristalografia por Raios X , Espectroscopia de Ressonância Magnética , Modelos Moleculares , Estrutura Molecular , Processos FotoquímicosRESUMO
Cyclo[18]carbon (C18, a molecular carbon allotrope) can be synthesized by dehalogenation of a bromocyclocarbon precursor, C18Br6, in 64% yield, by atomic manipulation on a sodium chloride bilayer on Cu(111) at 5 K, and imaged by high-resolution atomic force microscopy. This method of generating C18 gives a higher yield than that reported previously from the cyclocarbon oxide C24O6. The experimental images of C18 were compared with simulated images for four theoretical model geometries, including possible bond-angle alternation: D18h cumulene, D9h polyyne, D9h cumulene, and C9h polyyne. Cumulenic structures, with (D9h) and without (D18h) bond-angle alternation, can be excluded. Polyynic structures, with (C9h) and without (D9h) bond-angle alternation, both show a good agreement with the experiment and are challenging to differentiate.
RESUMO
The remarkable metalla-knot obtained by Kim, Jung, Chi and colleagues is an 818 knot, a metalla-knot that comprises eight crossings, not sixteen. It is the first knot to be synthesized having the 818 topology. Like several previous molecular knots, it adopts a conformation that does not correspond to the reduced form of the knot and has additional persistent nugatory crossings.
RESUMO
The first synthetic molecular trefoil knot was prepared in the late 1980s. However, it is only in the last few years that more complex small-molecule knot topologies have been realized through chemical synthesis. The steric restrictions imposed on molecular strands by knotting can impart significant physical and chemical properties, including chirality, strong and selective ion binding, and catalytic activity. As the number and complexity of accessible molecular knot topologies increases, it will become increasingly useful for chemists to adopt the knot terminology employed by other disciplines. Here we give an overview of synthetic strategies towards molecular knots and outline the principles of knot, braid, and tangle theory appropriate to chemistry and molecular structure.
RESUMO
A [2]rotaxane was produced through the assembly of a picolinaldehyde, an amine, and a bipyridine macrocycle around a Cu(I) template by imine bond formation in close-to-quantitative yield. An analogous [3]rotaxane is obtained in excellent yield by replacing the amine with a diamine, thus showing the suitability of the system for the construction of higher order interlocked structures. The rotaxanes are formed within a few minutes simply through mixing the components in solution at room temperature and they can be isolated through removal of the solvent or precipitation.
RESUMO
Quantum effects in nanoscale electronic devices promise to lead to new types of functionality not achievable using classical electronic components. However, quantum behaviour also presents an unresolved challenge facing electronics at the few-nanometre scale: resistive channels start leaking owing to quantum tunnelling. This affects the performance of nanoscale transistors, with direct source-drain tunnelling degrading switching ratios and subthreshold swings, and ultimately limiting operating frequency due to increased static power dissipation. The usual strategy to mitigate quantum effects has been to increase device complexity, but theory shows that if quantum effects can be exploited in molecular-scale electronics, this could provide a route to lower energy consumption and boost device performance. Here we demonstrate these effects experimentally, showing how the performance of molecular transistors is improved when the resistive channel contains two destructively interfering waves. We use a zinc-porphyrin coupled to graphene electrodes in a three-terminal transistor to demonstrate a >104 conductance-switching ratio, a subthreshold swing at the thermionic limit, a >7 kHz operating frequency and stability over >105 cycles. We fully map the anti-resonance interference features in conductance, reproduce the behaviour by density functional theory calculations and trace back the high performance to the coupling between molecular orbitals and graphene edge states. These results demonstrate how the quantum nature of electron transmission at the nanoscale can enhance, rather than degrade, device performance, and highlight directions for future development of miniaturized electronics.
RESUMO
Current strategies for the synthesis of molecular knots focus on twisting, folding and/or threading molecular building blocks. Here we report that Zn(II) or Fe(II) ions can be used to weave ligand strands to form a woven 3 × 3 molecular grid. We found that the process requires tetrafluoroborate anions to template the assembly of the interwoven grid by binding within the square cavities formed between the metal-coordinated criss-crossed ligands. The strand ends of the grid can subsequently be joined through within-grid alkene metathesis reactions to form a topologically trivial macrocycle (unknot), a doubly interlocked [2]catenane (Solomon link) and a knot with seven crossings in a 258-atom-long closed loop. This 74 knot topology corresponds to that of an endless knot, which is a basic motif of Celtic interlace, the smallest Chinese knot and one of the eight auspicious symbols of Buddhism and Hinduism. The weaving of molecular strands within a discrete layer by anion-template metal-ion coordination opens the way for the synthesis of other molecular knot topologies and to woven polymer materials.
RESUMO
Knots may ultimately prove just as versatile and useful at the nanoscale as at the macroscale. However, the lack of synthetic routes to all but the simplest molecular knots currently prevents systematic investigation of the influence of knotting at the molecular level. We found that it is possible to assemble four building blocks into three braided ligand strands. Octahedral iron(II) ions control the relative positions of the three strands at each crossing point in a circular triple helicate, while structural constraints on the ligands determine the braiding connections. This approach enables two-step assembly of a molecular 819 knot featuring eight nonalternating crossings in a 192-atom closed loop ~20 nanometers in length. The resolved metal-free 819 knot enantiomers have pronounced features in their circular dichroism spectra resulting solely from topological chirality.
RESUMO
Molecular knots occur in DNA, proteins, and other macromolecules. However, the benefits that can potentially arise from tying molecules in knots are, for the most part, unclear. Here, we report on a synthetic molecular pentafoil knot that allosterically initiates or regulates catalyzed chemical reactions by controlling the in situ generation of a carbocation formed through the knot-promoted cleavage of a carbon-halogen bond. The knot architecture is crucial to this function because it restricts the conformations that the molecular chain can adopt and prevents the formation of catalytically inactive species upon metal ion binding. Unknotted analogs are not catalytically active. Our results suggest that knotting molecules may be a useful strategy for reducing the degrees of freedom of flexible chains, enabling them to adopt what are otherwise thermodynamically inaccessible functional conformations.
RESUMO
The synthesis of 5,5'-dibromo-2,2'-bipyridine and 5-bromo-2,2'-bipyridine, useful intermediates for elaboration into more complex ligands through metal-catalyzed coupling reactions, can be efficiently conducted on a multigram scale from inexpensive starting materials. The described procedure is reliably scalable and suitable for the synthesis of tens of grams of 5,5'-dibromo-2,2'-bipyridine. 5-Bromo-2,2'-bipyridine is produced as a minor product. The 5,5'-disubstituted-2,2'-bipyridine motif has excellent coordination properties and is a versatile building block for the synthesis of functional materials (including biodiagnostics, photovoltaics and organic light-emitting diodes) and complex molecular topologies (including catenanes and trefoil and pentafoil knots). The selective stepwise functionalization of 5,5'-dibromo-2,2'-bipyridine by consecutive Stille couplings is therefore illustrated and documented in detail. The synthesis of 5,5'-dibromo-2,2'-bipyridine takes 4-5 d: 1 d to prepare the key intermediate 2,2'-bipyridine dihydrobromide, 3 d for its reaction with bromine in a steel bomb reaction vessel and 8 h to isolate and purify the final product.