Endoscopic visualization of the inferior alveolar nerve associated with somatosensory changes after impacted mandibular third molar extraction.

The aim of this study is to assess the relationship between somatosensory functional changes and inferior alveolar nerve (IAN) exposure after impacted mandibular third molars (M3M) removal. We recruited 35 patients who underwent impacted M3M extraction near the IAN. The M3Ms were extracted by combined endoscopy, piezosurgery, and contra-angle high-speed turbine handpiece. All IAN canal perforations and exposed regions were recorded and measured by endoscopy after extraction and on cone-beam computed tomography (CBCT) images before extraction. The patients were followed up 1, 7, and 35 days after surgery. A standardized quantitative sensory testing (QST) battery was performed on the lower lip skin. All of 35 cases had exposed IAN on CBCT images, 5 of which had no exposed IAN under endoscopy. For the other 30 cases, the endoscopy-measured IAN length and width were shorter than the CBCT measurements (P < 0.001). The warm and mechanical detection thresholds (MDT) on the operation side were significantly higher than the contralateral side after surgery (P < 0.05). Thermal sensory limen, MDT, and cold pain threshold were strongly correlated with the exposed IAN length and MDT also with the exposed IAN width one day after surgery. In conclusion, it was found that not all exposed IAN in CBCT images were real exposure after surgery. The intraoperative exposed IAN endoscopic measurements were smaller than by CBCT and strongly correlated with some QST parameters.

[Influence of acellular dermal matrix on differentiation of stem cells from young permanent tooth apical papilla].

OBJECTIVE: To get the stem cells from the young permanent tooth apical papillae, and observe the osteogenic differentiation of the cells after cultured with acellular dermal matrix (ADM). METHODS: Young permanent tooth apical papillae were obtained by the oral surgeon. The cells from the apical papillae were isolated, cultured and analyzed through a flow cytometer. The cells in the experimental group were induced both osteogenic and adipogenic differentiation. The cells were not induced in the control group.Both groups were evaluated by staining and real-time polymerase chain reaction (real-time PCR) to examine the quantity of RNAs in the experimental group. The cells from apical papillae were also cultured with ADM. These cells were also induced both osteogenic and adipogenic differentiation in the experimental group, and not induced in the control group. The measures of staining and real-time PCR were also carried out. RESULTS: The cells from the apical papillae proliferated in a rapid rate. Of which 70.3% in cultures were positive for Stro-1, and 96% positive for CD105 according to flow cytometric analysis. After induction, the RNA level related to osteogenic and adipogenic differentiation expressed higher in the experimental group than those of the control group without induction obviously, such as osteocalcin (OCN), bone sialoprotein (BSP), liver X-recepter α (LXRα), lipoprotein lipase(LPL), peroxisome proliferator activated receptor γ (PPAR-γ), and scavenger receptor class B type 1(SR-B1). The cells cultured with ADM also had a fast proliferation, and grew attached to ADM. After induction, the RNA level of OCN and BSP had a higher expression than the control group (P > 0.05), and LPL also expressed higher (P < 0.05). CONCLUSION: The study approved that there were a big amount of stem cells in the young permanent tooth apical papilla obtained by oral surgery, which had significant osteogenic potential. The cells still proliferated well when they were cultured with ADM as a kind of collagen skelecton. The results showed that ADM could be performed as a base to support the stem cells to survive the environment, and it also could play a role in osteogenic differentiation of stem cells from apical papilla.

FAM20A-Associated Amelogenesis Imperfecta: Gene Variants with Functional Verification and Histological Features.

OBJECTIVE: To investigate FAM20A gene variants and histological features of amelogenesis imperfecta and to further explore the functional impact of these variants. METHODS: Whole-exome sequencing (WES) and Sanger sequencing were used to identify pathogenic gene variants in three Chinese families with amelogenesis imperfecta. Bioinformatics analysis, in vitro histological examinations and experiments were conducted to study the functional impact of gene variants, and the histological features of enamel, keratinised oral mucosa and dental follicle. RESULTS: The authors identified two nonsense variants c. 406C > T (p.Arg136*) and c.826C > T (p.Arg176*) in a compound heterozygous state in family 1, two novel frameshift variants c.936dupC (p.Val313Argfs*67) and c.1483dupC (p.Leu495Profs*44) in a compound heterozygous state in family 2, and a novel homozygous frameshift variant c.530_531insGGTC (p.Ser178Valfs*21) in family 3. The enamel structure was abnormal, and psammomatoid calcifications were identified in both the gingival mucosa and dental follicle. The bioinformatics and subcellular localisation analyses indicated these variants to be pathogenic. The secondary and tertiary structure analysis speculated that these five variants would cause structural damage to FAM20A protein. CONCLUSION: The present results broaden the variant spectrum and clinical and histological findings of diseases associated with FAM20A, and provide useful information for future genetic counselling and functional investigation.

Designing customized temporomandibular fossa prosthesis based on envelope surface of condyle movement: validation via in silico musculoskeletal simulation.

Objective: This study presents an innovative articular fossa prosthesis generated by the envelope surface of condyle movement, and compares its mandible movements, muscle activities, and joint reaction forces with two temporomandibular joint (TMJ) prostheses using multibody musculoskeletal simulation. Methods: A healthy 23-year-old female was recruited for this study. Cone-beam computed tomographic (CBCT) was performed to reconstruct the mandibular bone geometry. A customized TMJ fossa prosthesis was designed based on the subject-specific envelope surface of condyle movement (ESCM). Mandibular kinematics and jaw-closing muscle electromyography (EMG) were simultaneously recorded during maximum jaw opening-closing movements. To validate our prosthesis design, a mandibular musculoskeletal model was established using flexible multibody dynamics and the obtained kinematics and EMG data. The Biomet fossa prosthesis and the ellipsoidal fossa prosthesis designed by imitating the lower limb prostheses were used for comparison. Simulations were performed to analyze the effects of different fossa prostheses on jaw opening-closing motions, mandibular muscle activation, and contact forces. Results: The maximum opening displacement for the envelope-based fossa prosthesis was greater than those for Biomet and ellipsoidal prostheses (36 mm, 35 mm, and 33 mm, respectively). The mandibular musculoskeletal model with ellipsoidal prosthesis led to dislocation near maximal jaw opening. Compared to Biomet, the envelope-based fossa reduced the digastric and lateral pterygoid activation at maximal jaw opening. It also reduced the maximal resistance to condylar sliding on the intact side by 63.2 N. Conclusion: A customized TMJ fossa prosthesis was successfully developed using the ESCM concept. Our study of musculoskeletal multibody modeling has highlighted its advantages and potential. The artificial fossa design successfully achieved a wider condylar range of motion. It also reduced the activation of jaw opening muscles on the affected side and resistance on the intact side. This study showed that an ESCM-based approach may be useful for optimizing TMJ fossa prostheses design.

[Application of Dextroscope virtual reality in anatomical research of the mandible part of maxillary artery].

OBJECTIVE: To evaluate the application of virtual reality technology in anatomical study of the mandible part of the maxillary artery and to provide anatomical basis in case of intraoperative damage. METHODS: The experiment was divided into two groups, virtual group and corpus group, 15 cases in each group. In virtual group, images data of cadaver heads were loaded into Dextroscope workstation and dissecting of mandible part of the maxillary artery was simulated. In corpus group, actual dissecting on the cadaver heads was examined under microscope correspondingly. RESULTS: The distance from the maxillary artery to posterior margin of the ramus, to sigmoid notch, to apex of condyle, to the apex of the articular eminence, and the distance from the starting point of the maxillary artery to apex of condyle and the diameter of the starting point of the maxillary artery were (6.12 ± 0.78)mm, (5.29 ± 0.69)mm, (20.68 ± 0.95)mm, (4.60 ± 0.60)mm, (22.48 ± 1.18)mm, (3.74 ± 0.57)mm in corpus group and (6.22 ± 0.63)mm, (5.40 ± 0.51)mm, (20.80 ± 0.88)mm, (4.55 ± 0.56)mm, (22.70 ± 1.11)mm, (3.69 ± 0.60)mm in virtual group. CONCLUSION: The data measured in virtual group was highly coincided with the data in corpus group verified by statistics. Virtual anatomy of the mandible part of the maxillary artery by virtual reality technology is reliable.

Anatomy and clinical application of suprascapular nerve to accessory nerve transfer.

BACKGROUND: Loss of motor function in the trapezius muscle is one complication of radical neck dissection after cutting the accessory nerve (AN) during surgery. Nerve repair is an effective method to restore trapezius muscle function, and includes neurolysis, direct suture, and nerve grafting. The suprascapular nerve (SCN) and AN are next to each other in position. The function of the AN and SCN in shoulder elevation and abduction movement is synergistic. SCN might be considered by surgeons for AN reanimation. AIM: To obtain anatomical and clinical data for partial suprascapular nerve-to-AN transfer. METHODS: Ten sides of cadavers perfused with formalin were obtained from the Department of Human Anatomy, Histology and Embryology, Peking University Health Science Center. The SCN (n = 10) and AN (n = 10) were carefully dissected in the posterior triangle of the neck, and the trapezius muscle was dissected to fully display the accessory nerve. The length of the SCN from the origin of the brachial plexus (a point) to the scapular notch (b point) and the distance of the SCN from the origin point (a point) to the point (c point) where the AN entered the border of the trapezius muscle were measured. The length and branches of the AN in the trapezius muscle were measured. A female patient aged 55 years underwent surgery for partial SCN to AN transfer at Department of Oral and Maxillofacial Surgery, Peking University School and Hospital of Stomatology. The patient suffered from recurrent upper gingival cancer. Radical neck dissection was performed on the right side, and the right AN was removed at the intersection between the nerve and the posterior border of the SCM muscle. One-third of the diameter of the SCN was cut off, and combined epineurial and perineurial sutures were applied between the distal end of the cut-off fascicles of the SCN and the proximal end of the AN without tension. Both subjective and objective evaluations were performed before, three months after, and nine months after surgery. For the subjective evaluation, the questionnaire included the Neck Dissection Impairment Index (NDII) and the Constant Shoulder Scale. Electromyography was used for the objective examination. Data were analyzed using t tests with SPSS 19.0 software to determine the relationship between the length of the SCN and the linear distance. A P value of < 0.05 was considered as statistically significant. RESULTS: The whole length of the AN in the trapezius muscle was 16.89 cm. The average numbers of branches distributed in the descending, horizontal and ascending portions were 3.8, 2.6 and 2.2, respectively. The diameter of the AN was 1.94 mm at the anterior border of the trapezius. The length of the suprascapular nerve from the origin of the brachial plexus to the scapular notch was longer than the distance of the suprascapular nerve from the origin point to the point where the accessory nerve entered the upper edge of the trapezius muscle. The amplitude of trapezius muscle electromyography indicated that both the horizontal and ascending portions of the trapezius muscle on the right side had better function than the left side nine months after surgery. The results showed that the right-sided supraspinatus and infraspinatus muscles did not lose more function than the left side. CONCLUSION: Based on anatomical data and clinical application, partial suprascapular nerve-to-AN transfer could be achieved and may improve innervation of the affected trapezius muscle after radical neck dissection.

Comparative Study of Temporomandibular Articular Fossa Bone Surface and the Envelope Surface of the Condyle Movement.

OBJECTIVE: To investigate the differences between temporomandibular articular fossa bone surface and the envelope surface of the mandibular condyle movement. METHODS: Thirty-four healthy adults underwent skull base and mandible scans using CBCT and performed mandibular border movement using the mandibular movement recording system. Landmarks of the fossa and tubercle were indicated and distance and angle parameters were measured on the 3D models reconstructed from the CBCT. The condyle movement envelope surfaces were formed according to models reconstructed from CBCT and the mandibular movement trajectory using computer simulation. The highest and lowest points of the envelope surface were indicated to create parameters. The data were analysed using a paired t test in SPSS (version 24.0, IBM, Armonk, NY, USA). RESULTS: The mandibular fossa bone surface was statistically different to the envelope surface for the height of the first peak of the envelope surface (3.280 ± 1.319 mm) and depth of the mandibular fossa (6.338 ± 2.389 mm) (the ratio was 51.75%), the height of the second peak of the envelope surface (1.463 ± 0.745 mm) and the height of the tubercle (2.000 ± 0.968 mm) (the ratio was 73.15%), and the downwards angle of the envelope surface (25.933 ± 7.539 degrees) and the posterior slope angle of the articular tubercle (35.059 ± 5.224 degrees) (the ratio was 73.97%). CONCLUSION: The downwards angle of the envelope surface was statistically significantly smaller than the posterior slope angle of the articular tubercle, suggesting that the condyle movement is flatter than the mandibular fossa bone surface.