Effects of cadmium stress at different concentrations on the reproductive behaviors of beet armyworm Spodoptera exigua (Hübner).

Insects are exposed to cadmium stress since cadmium pollution has increasingly become a serious global environmental issue. However, until now few studies have paid attention to the effect of heavy metals on insect reproductive behaviors. In our study, the courtship behaviors, mating behaviors and fecundity of beet armyworm Spodoptera exigua (Lepidoptera: Noctuidae) exposed to different concentrations of cadmium in artificial diets at larval stage were studied. The results showed that cadmium stress changed the courtship rhythm by significantly advancing or delaying the courtship starting time. Low dose of cadmium (0.2 mg/kg) increased the courtship frequency in the first two scotophases, but in the fourth phase, the two cadmium treatments reduced the frequency. The total courtship duration was significantly shortened in the first six scotophases except high dose of cadmium treatment (51.2 mg/kg) in the sixth dark phase. Paired adults did not mate after the seventh scotophase under low cadmium exposure, while high cadmium stress made the paired adults just copulate in the first four scotophases. The daily mating rate and total mating rate decreased with the increase in cadmium concentration. The number of eggs of low cadmium treatment was higher than that of control, but the difference was not significant; the number of eggs in high cadmium treatment was lower than that of control and low cadmium treatment. Our results indicate that cadmium exposure can disrupt the courtship rhythm for females and has negative influences on copulation behavior and high cadmium stress can reduce fecundity. Hence, the insect population increase will be affected by heavy metal pollution. Our study will provide scientific reference for environmental risk assessment of heavy metal pollution.

Experimental and simulation investigation on suppressing thermal runaway in battery pack.

In order to address the issue of suppressing thermal runaway (TR) in power battery, a thermal generation model for power batteries was established and then modified based on experimental data. On the basis of simulation calculations, a scheme was designed to suppress thermal runaway of the battery module and battery pack, and samples were produced for testing. The results of the test and simulation calculations were very consistent, confirming the accuracy of the simulation calculation model. The results of thermal runaway test also demonstrate that the measures designed to suppress thermal runaway are effective and meet the design requirements.

In-Situ Synthesis, Microstructure, and Mechanical Properties of TiB2-Reinforced Fe-Cr-Mn-Al Steel Matrix Composites Prepared by Spark Plasma Sintering.

In-situ synthesis, microstructure, and mechanical properties of four TiB2-Reinforced Fe-Cr-Mn-Al Steel Matrix Composites have been researched in this work. The microstructure and phases of the prepared specimens have been characterized by using scanning electron microscopy (SEM), X-ray diffraction technique, and transmission electron microscopy (TEM). The sintered specimens consisted of Fe2AlCr, CrFeB-type boride, and TiB2. The mechanical properties, such as hardness and compression strength at room temperature (RT) and at elevated temperatures (600 °C and 800 °C) have been evaluated. The compressive strength and Vickers hardness of the sintered specimens increase with the volume fraction of TiB2 in the matrix, which are all much higher than those of the ex-situ TiB2/Fe-15Cr-20Mn-8Al composites and the reported TiB2/Fe-Cr composites with the same volume fraction of TiB2. The highest Vickers hardness and compressive strength at room temperature are 1213 ± 35 HV and 3500 ± 20 MPa, respectively. As the testing temperature increases to 600 °C, or even 800 °C, these composites still show relatively high compressive strength. Precipitation strengthening of CrFeB and in-situ synthesis of TiB2 as well as nanocrystalline microstructure produced by the combination of mechanical alloying (MA) and spark plasma sintering (SPS) can account for the high Vickers hardness and compressive strength.