RESUMO
The classical high-temperature synthesis process of Cu(In,Ga)Se2 (CIGS) solar cells limits their applications on high-temperature intolerant substrates. In this study, a novel low-temperature (400 °C) fabrication strategy of CIGS solar cells is reported using the bismuth (Bi)-doping method, and its growth-promoting mechanism is systematically studied. Different concentrations of Bi are incorporated into pure chalcopyrite quaternary target sputtered-CIGS films by controlling the thickness of the Bi layer. Bi induces considerable grain growth improvement, and an average of approximately 3% absolute efficiency enhancement is achieved for Bi-doped solar cells in comparison with the Bi-free samples. Solar cells doped with a 50 nm Bi layer yield the highest efficiency of 13.04% (without any antireflective coating) using the low-temperature technology. The copper-bismuth-selenium compounds (Cu-Bi-Se, mainly Cu1.6Bi4.8Se8) are crucial in improving the crystallinity of absorbers during the annealing process. These Bi-containing compounds are conclusively observed at the grain boundaries and top and bottom interfaces of CIGS films. The growth promotion is found to be associated with the superior diffusion capacity of Cu-Bi-Se compounds in CIGS films, and these liquid compounds function as carriers to facilitate crystallization. Bi atoms do not enter the CIGS lattices, and the band gaps (Eg) of absorbers remain unchanged. Bi doping reduces the number of CIGS grain boundaries and increases the copper vacancy content in CIGS films, thereby boosting the carrier concentrations. Cu-Bi-Se compounds in grain boundaries significantly enhance the conductivity of grain boundaries and serve as channels for carrier transport. The valence band, Fermi energy level (EF), and conduction band of Bi-doped CIGS films all move downward. This band shift strengthens the band bending of the CdS/CIGS heterojunction and eventually improves the open circuit voltage (Voc) of solar cells. An effective doping method and a novel mechanism can facilitate the low-temperature preparation of CIGS solar cells.
RESUMO
Drug resistance leads to tumor relapse and further progression during chemotherapy in lung cancer. Close homolog of L1 (CHL1) has been identified as a tumor suppressor in most malignancies. However, to the best of our knowledge, whether CHL1 mediates chemoresistance remains unknown. The present study observed that CHL1 was significantly downregulated in cisplatin (DDP)-resistant cells (A549/DDP) and paclitaxel (PTX)-resistant cells (A549/PTX) compared with A549 cells. When treated with or without DDP and PTX, silencing of CHL1 in A549 cells promoted the cell survival rate and clone formation, and decreased apoptosis. Whereas overexpression of CHL1 in A549/DDP and A549/PTX cells impeded the cell survival and clone formation and promoted apoptosis. Additionally, CHL1 overexpression enhanced the chemosensitivity of A549/DDP cells to DDP in vivo. Notably, the chemoresistance induced by CHL1 depletion was reversed by the Akt inhibitor SC66 in A549 cells. The results of the present study demonstrated that CHL1 enhanced sensitivity of lung cancer cells by suppressing the Akt pathway, which suggested that CHL1 may be a potential target for overcoming chemoresistance in lung cancer.
RESUMO
The Cu(In,Ga)Se2 (CIGS) thin film has been commercialized as solar cells with great success, but its application for photodetectors still faces some practical challenges, including low detectivity and long response time. In this paper, the structure of the Mo/CIGS/CdS/ZnO/ITO heterojunction has been fabricated, and satisfactory performances of high detectivity and fast response time have been achieved by suppressing the dark current and enhancing the carrier mobility. The controllable growth of CIGS grains is accomplished through optimizing the selenization process, demonstrating that bigger grain sizes resulted in higher carrier mobility and better response characteristics. Particularly, the high rise/decay speed of 3.40/6.46 µs is achieved. Furthermore, the interface of the CIGS/CdS heterojunction has been modified by the Al2O3 layer via the atomic-layer deposition (ALD) process. The dark current of the device is effectively suppressed by the ALD-Al2O3 layer, which remarkably drops from â¼10-7 to â¼10-9 A. As a consequence, the detectivity rises from 3.08 × 1011 to 1.84 × 1012 Jones. In addition, the ALD-Al2O3 layer shows a protective effect as well, which is positive for photoelectrical conversion. Besides, the wide linear dynamic range of 102.1 dB and large -3 dB bandwidth of 78 kHz are acquired. This work suggests that the CIGS-based heterojunction has great potential for high-performance thin-film photodetectors.
RESUMO
Kesterite Cu2ZnSn(S,Se)4 (CZTSSe) thin film is a promising material for optoelectronic devices. In this work, we fabricate Mo/CZTSSe/CdS/ZnO/ITO (ITO, indium tin oxide) heterojunction photodetectors with favorable self-powered characteristics. The photodetector exhibits exceptional high-frequency photoresponse performance whose -3 dB bandwidth and rise/decay time have reached 1 MHz and 240/340 ns, respectively. For further improvement, ultrathin Al2O3 layer prepared via atomic layer deposition (ALD) process is introduced at the Mo/CZTSSe interface. The influence of ALD-Al2O3 layer thickness and its role on the photoresponse performance are investigated in detail. The interfacial layer proved to serve as a protective layer preventing selenization of Mo electrode, resulting in the reduction of MoSe2 transition layer and the decrease of series resistance of the device. Accordingly, the -3 dB bandwidth is remarkably extended to 3.5 MHz while the rise/decay time is dramatically improved to 60/77 ns with 16 cycles of ALD-Al2O3 layer, which is 4-5 orders of magnitude faster than the other reported CZTSSe photodetectors. Simultaneously, it is revealed that the ALD-Al2O3 interfacial layer acts as an electron blocking layer which leads to the effective suppression of carrier recombination at the rear surface. Consequently, the responsivity and detectivity are enhanced in the entire range while the maximum values are up to 0.39 AW-1 and 2.04 × 1011 Jones with 8 cycles of ALD-Al2O3, respectively. Finally, the CZTSSe photodetector is successfully integrated into a visible light communication system and obtains a satisfying transfer rate of 2 Mbps. These results indicate the satisfying performance of CZTSSe-based thin film photodetectors with great potential applications for communication.