RESUMEN
Indium arsenide (InAs) near surface quantum wells (QWs) are promising for the fabrication of semiconductor-superconductor heterostructures given that they allow for a strong hybridization between the two-dimensional states in the quantum well and the ones in the superconductor. In this work, we present results for InAs QWs in the quantum Hall regime placed in proximity of superconducting NbTiN. We observe a negative downstream resistance with a corresponding reduction of Hall (upstream) resistance, consistent with a very high Andreev conversion. We analyze the experimental data using the Landauer-Büttiker formalism, generalized to allow for Andreev reflection processes. We attribute the high efficiency of Andreev conversion in our devices to the large transparency of the InAs/NbTiN interface and the consequent strong hybridization of the QH edge modes with the states in the superconductor.
RESUMEN
There is an increasing interest in additive nanomanufacturing processes, which enable customizable patterning of functional materials and devices on a wide range of substrates. However, there are relatively few techniques with the ability to directly 3D print patterns of functional materials with sub-micron resolution. In this study, we demonstrate the use of additive electrohydrodynamic jet (e-jet) printing with an average line width of 312 nm, which acts as an inhibitor for area-selective atomic layer deposition (AS-ALD) of a range of metal oxides. We also demonstrate subtractive e-jet printing with solvent inks that dissolve polymer inhibitor layers in specific regions, which enables localized AS-ALD within those regions. The chemical selectivity and morphology of e-jet patterned polymers towards binary and ternary oxides of ZnO, Al2O3, and SnO2 were quantified using X-ray photoelectron spectroscopy, atomic force microscopy, and Auger electron spectroscopy. This approach enables patterning of functional oxide semiconductors, insulators, and transparent conducting oxides with tunable composition, Å-scale control of thickness, and sub-µm resolution in the x-y plane. Using a combination of additive and subtractive e-jet printing with AS-ALD, a thin-film transistor was fabricated using zinc-tin-oxide for the semiconductor channel and aluminum-doped zinc oxide as the source and drain electrical contacts. In the future, this technique can be used to print integrated electronics with sub-micron resolution on a variety of substrates.