Is There a Seasonal Influence on Orthopaedic Surgical Wound Infection Rates?

Postoperative surgical wound infections are a significant cause of morbidity in orthopaedic surgical cases. To date, there has been no large, single-institution study evaluating orthopaedic surgical wound infection rates and their correlation with seasonality. The hypothesis of this study was that there would be more infections in the warmer months of the year. A retrospective review of all orthopaedic surgery cases at the authors' institution from 1992 to 2012 was performed of all patients with postoperative wound infections. Patients were placed into two groups on the basis of the date of initial surgical fixation: those occurring in warm months (May-September) and those occurring in cold months (October-April). From July 2010 to June 2012, there was not a statistically significant increase in total infection rate during the months of May to September compared with the months of October to April (0.8% and 0.6%, respectively; p = .131). The hypothesis was rejected: there was no significant increase in post-operative infections during the warmer months. Although previous studies have demonstrated such an increase, the results of this study, which were from a much larger cohort, disagree.

Can acetabular dysplasia be measured on axial CT? A measurement for trauma surgeons.

BACKGROUND: Acetabular dysplasia has been theorized as a risk factor instability amongst common acetabular fractures, such as posterior wall (PW) fractures. However, common radiographic measurements often cannot be acquired in trauma patients. We evaluated axial computed tomography (CT) scans to identify novel, easily-obtained measurements that correlate with acetabular dysplasia for use in surgical indications and planning. METHODS: Patients with known acetabular dysplasia undergoing elective periacetabular osteotomy were selected. A different group of patients without pelvic ring or acetabular fractures from an institutional trauma registry were selected as a comparison group. Standard indices of dysplasia were collected, such as center-edge angle (CEA). Acetabular geometric measurements were taken at three axial levels: 0 - cranial CT slice at the dome; 1 - cranial CT where the dome is an incomplete circle; 2 - cranial CT with femoral head visible. Distances between levels were also calculated: Levels 0-1 (Dome Height; DH), Levels 1-2 (Head Height; HH), and Dome-Head Difference (DH - HH = DHD). RESULTS: DH, HH, and DHD were all significantly correlated with CEA, Tonnis angle, and Sharp's angle in dysplastic hips. All dysplastic hips had DH ≤ 2.5 mm and HH ≥ 1.25 mm. DHD ≤ 0 mm was most specific (93.6 % sensitive, 77.3 % specific) for predicting dysplasia. CONCLUSION: DH ≤ 2.5 mm, HH ≥ 1.25 mm, and DHD ≤ 0 mm were independently associated with dysplasia on axial CT scans. These measurements may be quickly and easily used by trauma surgeons to assess a trauma-based axial CT scan for acetabular dysplasia.

Acetabular dysplasia and posterior wall fractures: The missing link?

BACKGROUND: Traumatologists are unable to predict hip instability based on CT scans and standard radiographs in posterior wall (PW) fractures comprising <50-60 % of the wall, necessitating an examination under anesthesia (EUA). Risk factors for instability have not been clarified, but acetabular dysplasia has been theorized as a potential etiology. Unfortunately, dysplasia is difficult to evaluate in the traumatic setting. The purpose of this study was to compare acetabular morphology between unstable and stable fractures with a novel method to detect dysplasia. METHODS: Patients ≥ 18 years old with a PW fracture that underwent an EUA from 2013 to 2023 were retrospectively identified. For our experimental measurements, the axial distances on CT between the acetabular dome, lateral acetabular opening, and femoral head vertex were recorded. Acetabular geometry was quantified at these levels. Conventional dysplasia metrics (e.g., Tonnis angle) were obtained. Variables were compared between stable and unstable fractures. RESULTS: 58 patients met inclusion criteria with 42 stable versus 16 unstable fractures. Unstable fractures had higher distances between the acetabular dome and femoral head vertex (p > 0.05). They had more cranial fracture exit points (p = 0.0015), lower femoral head coverage (p = 0.0102), and lower posterior acetabular sector angles (p = 0.0281). No other differences in acetabular geometry, demographics, injury characteristics, or other markers of dysplasia were identified. CONCLUSIONS: Unstable hips demonstrated a more recessed acetabular dome when compared to stable hips. Posterior acetabular femoral head coverage and cranial fracture exit point may be related to hip instability. A larger sample size is needed to validate these findings.

State of the Union: Timeliness to Antibiotics in Open Fractures.

OBJECTIVE: In open fractures, early administration of systemic antibiotics has recently been recognized as a universal recommendation, with the current American College of Surgeons Trauma Center Verification recommendation for administration within 1 hour of facility arrival. We sought to quantify the baseline rate of timely antibiotic administration and the various factors associated with delay. METHODS: Data from the National Trauma Data Bank were obtained for all patients treated for open fractures in 2019. 65,552 patients were included. Univariate and multivariate analyses were performed, first for patient, prehospital, and hospital factors compared with rate of antibiotic administration within 1 hour of hospital arrival, then with a multivariate analysis of factors affecting these times. RESULTS: The overall rate of antibiotic administration within 1 hour of arrival was 47.6%. Patient factors associated with lower rates of timely antibiotics include increased age, Medicare status, and a higher number of comorbidities. Associated prehospital factors included non-work-related injuries, fixed-wing air or police transport, and walk-in arrival method. Patients with lower extremity open fractures were more likely to receive antibiotics within 1 hour of arrival than those with upper extremity open fractures. Traumatic amputations had a higher rate of timely administration (67.3%). ACS trauma Level II (52.5%) centers performed better than Level III (48.3%), Level I (45.5%), and Level IV (34.5%) centers. Multivariate analysis confirmed the findings of the univariate analysis. CONCLUSIONS: Despite current clinical standards, rates of adherence to rapid antibiotic administration are low. Certain patient, facility, and environmental factors are associated with delays in antibiotic administration and can be a focus for quality improvement processes. We plan to use these data to evaluate how focus on antibiotic administration as this quality standard changes practice over time. LEVEL OF EVIDENCE: Prognostic Level III. See Instructions for Authors for a complete description of levels of evidence.

Bone cutting efficiency and heat generation using a traditional fluted Burr and a novel fluteless resurfacing tool.

BACKGROUND: Powered instrumentation is often used for bone preparation and/or removal in many orthopaedic procedures but does risk thermogenesis. This study compares biomechanical properties of a fluted burr and a novel fluteless resurfacing tool. METHODS: Twenty cadaveric metatarsals were tested with four predetermined cutting forces to evaluate heat generation and cutting rate for the fluted burr and fluteless resurfacing tool over 40 s or until a depth of 4 mm was reached. Cutting rate was calculated from displacement transducer data. Heat generation was measured by thermocouples placed in the bone adjacent to the burring site. Assuming a body temperature of 37 °C, a 10 °C increase in heat was used as the threshold of inducing osteonecrosis. FINDINGS: At 1.0 N and 1.7 N, the thermal osteonecrosis threshold was reached at comparable times between burrs, while the bone removed by the resurfacing tool was on average five times greater than fluted burr at 1.0 N and over twice as great at 1.7 N. Statistical analysis of these common cutting forces showed the resurfacing tool had significantly higher cutting rates (P < 0.01). As a result, the fluted burr produced higher temperatures for the same amount of bone removal (P < 0.01). INTERPRETATION: In a cadaveric study, the fluteless resurfacing tool demonstrated higher bone cutting rates and lower heat generation for the same amount of bone removed than a traditional fluted burr.

Associations between upper extremity injury patterns in side impact motor vehicle collisions with occupant and crash characteristics.

INTRODUCTION: Side impact motor vehicle collisions (MVC) represent a significant burden of mortality and morbidity caused by automotive injury within the United States. The objective of this study was to evaluate the relationship between upper extremity (UE) injury patterns and contact sources in side impact MVC with occupant and crash variables. METHODS: Crash Injury Research and Engineering Network data obtained from 1998 to 2012 were used to evaluate UE injuries in side impact crashes. First row drivers and passengers that were at least 16 years old with complete crash information were included. Side impact crashes were defined to have an area of deformation to the side of the vehicle and a principal direction of force between 60° and 120° or 240° and 300°. Injuries were stratified by type, anatomic location, and Abbreviated Injury Scale (AIS) severity. Occupant variables included age, sex, height, weight, body mass index, and Injury Severity Score. Vehicle and crash variables included in the analysis were change in vehicle velocity at the time of impact, maximum door intrusion, maximum B-pillar intrusion, seat track position, belt use, vehicle type, impact type, and injury source. Statistical analysis of the UE injury data included descriptive statistics, linear regression analyses with occupant variables, and logistic regression analyses with vehicle and crash variables. RESULTS: There were 903 UE injuries among 408 case occupants. The most common injury type was soft tissue injury (72.5%). The majority of fractures were proximal to and including the humerus (70.3%) with the clavicle being the most common fracture location (N = 89). AIS 2+ UE injuries were associated with a significantly higher mean occupant Injury Severity Score than AIS 1 UE injuries (p = 0.01). Contact with the door was the leading cause of UE injury (34.2%). The odds (OR [95% confidence interval], p-value) of an AIS 2+ UE injury due to contact with the B-pillar (5.3 [3.1, 9.1], <0.0001), door (1.9 [1.3, 2.7], 0.0006), and steering wheel/assembly (2.7 [1.1, 6.3], 0.03) were significantly higher than all other injury sources combined. Scapula fractures were significantly associated with rearward seat track positions (1.46 [1.04, 2.05], 0.03). CONCLUSIONS: This study provides insight into UE injury patterns in side impact MVC. The clavicle was the most common UE fracture location. Contact with the door resulted in the highest number of UE injuries and the B-pillar resulted in the most severe injuries. Additionally, exposure to greater B-pillar intrusion was associated with increased odds of scapula and clavicle fractures in side impacts.