Proposal for Unambiguous Electrical Detection of Spin-Charge Conversion in Lateral Spin Valves.

Efficient detection of spin-charge conversion is crucial for advancing our understanding of emergent phenomena in spin-orbit-coupled nanostructures. Here, we provide a proof of principle of an electrical detection scheme of spin-charge conversion that enables full disentanglement of competing spin-orbit coupling (SOC) transport phenomena in diffusive lateral channels, i.e., the inverse spin Hall effect and the spin galvanic effect. A suitable geometry in an applied oblique magnetic field is shown to provide direct access to SOC transport coefficients through a symmetry analysis of the output nonlocal resistance. The scheme is robust against tilting of the spin-injector magnetization, disorder, and spurious non-spin-related contributions to the nonlocal signal and can be used to probe spin-charge conversion effects in both spin-valve and hybrid optospintronic devices.

Electrocatalytic Proton Reduction by a Cobalt(III) Hydride Complex with Phosphinopyridine PN Ligands.

Cobalt complexes with 2-(diisopropylphosphinomethyl)pyridine (PN) ligands have been synthesized with the aim of demonstrating electrocatalytic proton reduction to dihydrogen with a well-defined hydride complex of an Earth-abundant metal. Reactions of simple cobalt precursors with 2-(diisopropylphosphino-methyl)pyridine (PN) yield [CoII(PN)2(MeCN)][BF4]2 1, [CoIII(PN)2(H)(MeCN)][PF6]2 2, and [CoIII(PN)2(H)(Cl)][PF6] 3. Complexes 1 and 3 have been characterized crystallographically. Unusually for a bidentate PN ligand, all three exhibit geometries with mutually trans phosphorus and nitrogen ligands. Complex 1 exhibits a distorted square-pyramidal geometry with an axial MeCN ligand in a low-spin electronic state. In complexes 2 and 3, the PN ligands lie in a plane leaving the hydride trans to MeCN or chloride, respectively. The redox behavior of the three complexes has been studied by cyclic voltammetry at variable scan rates and by spectroelectrochemistry. A catalytic wave is observed in the presence of trifluoroacetic acid (TFA) at an applied potential close to the Co(II/I) couple of 1. Bulk electrolysis of 1, 2, or 3 at a potential of ca. -1.4 V vs E(Fc+/Fc) in the presence of TFA yields H2 with Faradaic yields close to 100%. A catalytic mechanism is proposed in which the pyridine moiety of a PN ligand acts as a pendant proton donor following opening of the chelate ring. Additional mechanisms may also operate, especially in the presence of high acid concentration where speciation changes.

Exchange bias in Fe@Cr core-shell nanoparticles.

We have used X-ray magnetic circular dichroism and magnetometry to study isolated Fe@Cr core-shell nanoparticles with an Fe core diameter of 2.7 nm (850 atoms) and a Cr shell thickness varying between 1 and 2 monolayers. The addition of Cr shells significantly reduces the spin moment but does not change the orbital moment. At least two Cr atomic layers are required to stabilize a ferromagnetic/antiferromagnetic interface and generate the associated exchange bias and increase in coercivity.

Photonic Characterisation of Indium Tin Oxide as a Function of Deposition Conditions.

Indium tin oxide (ITO) has recently gained prominence as a photonic nanomaterial, for example, in modulators, tuneable metasurfaces and for epsilon-near-zero (ENZ) photonics. The optical properties of ITO are typically described by the Drude model and are strongly dependent on the deposition conditions. In the current literature, studies often make several assumptions to connect the optically measured material parameters to the electrical properties of ITO, which are not always clear, nor do they necessarily apply. Here, we present a comprehensive study of the structural, electrical, and optical properties of ITO and showed how they relate to the deposition conditions. We use guided mode resonances to determine the dispersion curves of the deposited material and relate these to structural and electrical measurements to extract all relevant material parameters. We demonstrate how the carrier density, mobility, plasma frequency, electron effective mass, and collision frequency vary as a function of deposition conditions, and that the high-frequency permittivity (쵰) can vary significantly from the value of 쵰 = 3.9 that many papers simply assume to be a constant. The depth of analysis we demonstrate allows the findings to be easily extrapolated to the photonic characterisation of other transparent conducting oxides (TCOs), whilst providing a much-needed reference for the research area.

Gate-Tunable Reversible Rashba-Edelstein Effect in a Few-Layer Graphene/2H-TaS2 Heterostructure at Room Temperature.

We report the observation of current-induced spin polarization, the Rashba-Edelstein effect (REE), and its Onsager reciprocal phenomenon, the spin galvanic effect (SGE), in a few-layer graphene/2H-TaS2 heterostructure at room temperature. Spin-sensitive electrical measurements unveil full spin-polarization reversal by an applied gate voltage. The observed gate-tunable charge-to-spin conversion is explained by the ideal work function mismatch between 2H-TaS2 and graphene, which allows for a strong interface-induced Bychkov-Rashba interaction with a spin-gap reaching 70 meV, while keeping the Dirac nature of the spectrum intact across electron and hole sectors. The reversible electrical generation and control of the nonequilibrium spin polarization vector, not previously observed in a nonmagnetic material, are elegant manifestations of emergent two-dimensional Dirac Fermions with robust spin-helical structure. Our experimental findings, supported by first-principles relativistic electronic structure and transport calculations, demonstrate a route to design low-power spin-logic circuits from layered materials.

Interface Engineered Room-Temperature Ferromagnetic Insulating State in Ultrathin Manganite Films.

Ultrathin epitaxial films of ferromagnetic insulators (FMIs) with Curie temperatures near room temperature are critically needed for use in dissipationless quantum computation and spintronic devices. However, such materials are extremely rare. Here, a room-temperature FMI is achieved in ultrathin La0.9Ba0.1MnO3 films grown on SrTiO3 substrates via an interface proximity effect. Detailed scanning transmission electron microscopy images clearly demonstrate that MnO6 octahedral rotations in La0.9Ba0.1MnO3 close to the interface are strongly suppressed. As determined from in situ X-ray photoemission spectroscopy, O K-edge X-ray absorption spectroscopy, and density functional theory, the realization of the FMI state arises from a reduction of Mn eg bandwidth caused by the quenched MnO6 octahedral rotations. The emerging FMI state in La0.9Ba0.1MnO3 together with necessary coherent interface achieved with the perovskite substrate gives very high potential for future high performance electronic devices.

I18--the microfocus spectroscopy beamline at the Diamond Light Source.

The design and performance of the microfocus spectroscopy beamline at the Diamond Light Source are described. The beamline is based on a 27 mm-period undulator to give an operable energy range between 2 and 20.7 keV, enabling it to cover the K-edges of the elements from P to Mo and the L(3)-edges from Sr to Pu. Micro-X-ray fluorescence, micro-EXAFS and micro-X-ray diffraction have all been achieved on the beamline with a spot size of approximately 3 microm. The principal optical elements of the beamline consist of a toroid mirror, a liquid-nitrogen-cooled double-crystal monochromator and a pair of bimorph Kirkpatrick-Baez mirrors. The performance of the optics is compared with theoretical values and a few of the early experimental results are summarized.

The effect of prehabilitation on the range of motion and functional outcomes in patients following the total knee or hip arthroplasty: A pilot randomized trial.

OBJECTIVE: The study investigated the effect of prehabilitation on the quality of life and function in patients having total knee replacement (TKR)/total hip replacement (THR). METHODS: A pilot randomized controlled trial with concealed allocation, assessor blinding, and intention-to-treat analysis was conducted. Sixty-four people undergoing elective lower-limb arthroplasty were included. Prehabilitation included one-hour twice-weekly sessions for at least three and a maximum of four weeks prior to surgery. Control participants did not complete any pre-surgical programs. Health utility and quality of life as measured by the EQ-5D-3L and the patient-specific functional scale were the primary outcomes measured before allocation and eight weeks post-operatively. RESULTS: No between-group differences were evident in health utility (main effect of the group -0.04 (95% Confidence Interval [CI] -0.16 to 0.08, p = 0.50) or patient-specific functional scale (main effect of the group -0.59 (95% CI -1.8 to 0.6, p = 0.73), but the group-by-joint interaction effects for the timed up and go (TUG) (7.6 (95% CI -0.9 to 16.1, p = 0.08)) and the EQ-5D VAS (-18.3 (95% CI -41.1 to 4.5), p = 0.11) were larger. Prehabilitation participants' knee flexion improved by 12.6 degrees (95% CI 5.2-20, p = 0.001). CONCLUSIONS: Prehabilitation improved knee flexion, but this did not translate into improved functional mobility or quality of life.

Self-assembled metallic nanowires on a dielectric support: Pd on rutile TiO2(110).

Palladium nanoparticles supported on rutile TiO(2)(110)-1 x 1 have been studied using the complementary techniques of scanning tunneling microscopy and X-ray photoemission electron microscopy. Two distinct types of palladium nanoparticles are observed, namely long nanowires up to 1000 nm long, and smaller dotlike features with diameters ranging from 80-160 nm. X-ray photoemission electron microscopy reveals that the nanoparticles are composed of metallic palladium, separated by the bare TiO(2)(110) surface.