Your browser doesn't support javascript.
loading
Mostrar: 20 | 50 | 100
Resultados 1 - 11 de 11
Filtrar
1.
Nature ; 601(7894): 542-548, 2022 01.
Artículo en Inglés | MEDLINE | ID: mdl-35082418

RESUMEN

Obtaining a burning plasma is a critical step towards self-sustaining fusion energy1. A burning plasma is one in which the fusion reactions themselves are the primary source of heating in the plasma, which is necessary to sustain and propagate the burn, enabling high energy gain. After decades of fusion research, here we achieve a burning-plasma state in the laboratory. These experiments were conducted at the US National Ignition Facility, a laser facility delivering up to 1.9 megajoules of energy in pulses with peak powers up to 500 terawatts. We use the lasers to generate X-rays in a radiation cavity to indirectly drive a fuel-containing capsule via the X-ray ablation pressure, which results in the implosion process compressing and heating the fuel via mechanical work. The burning-plasma state was created using a strategy to increase the spatial scale of the capsule2,3 through two different implosion concepts4-7. These experiments show fusion self-heating in excess of the mechanical work injected into the implosions, satisfying several burning-plasma metrics3,8. Additionally, we describe a subset of experiments that appear to have crossed the static self-heating boundary, where fusion heating surpasses the energy losses from radiation and conduction. These results provide an opportunity to study α-particle-dominated plasmas and burning-plasma physics in the laboratory.

3.
Phys Rev E ; 109(2-2): 025204, 2024 Feb.
Artículo en Inglés | MEDLINE | ID: mdl-38491565

RESUMEN

In this work we present the design of the first controlled fusion laboratory experiment to reach target gain G>1 N221204 (5 December 2022) [Phys. Rev. Lett. 132, 065102 (2024)10.1103/PhysRevLett.132.065102], performed at the National Ignition Facility, where the fusion energy produced (3.15 MJ) exceeded the amount of laser energy required to drive the target (2.05 MJ). Following the demonstration of ignition according to the Lawson criterion N210808, experiments were impacted by nonideal experimental fielding conditions, such as increased (known) target defects that seeded hydrodynamic instabilities or unintentional low-mode asymmetries from nonuniformities in the target or laser delivery, which led to reduced fusion yields less than 1 MJ. This Letter details design changes, including using an extended higher-energy laser pulse to drive a thicker high-density carbon (also known as diamond) capsule, that led to increased fusion energy output compared to N210808 as well as improved robustness for achieving high fusion energies (greater than 1 MJ) in the presence of significant low-mode asymmetries. For this design, the burnup fraction of the deuterium and tritium (DT) fuel was increased (approximately 4% fuel burnup and a target gain of approximately 1.5 compared to approximately 2% fuel burnup and target gain approximately 0.7 for N210808) as a result of increased total (DT plus capsule) areal density at maximum compression compared to N210808. Radiation-hydrodynamic simulations of this design predicted achieving target gain greater than 1 and also the magnitude of increase in fusion energy produced compared to N210808. The plasma conditions and hotspot power balance (fusion power produced vs input power and power losses) using these simulations are presented. Since the drafting of this manuscript, the results of this paper have been replicated and exceeded (N230729) in this design, together with a higher-quality diamond capsule, setting a new record of approximately 3.88MJ of fusion energy and fusion energy target gain of approximately 1.9.

4.
Phys Rev E ; 109(2-2): 025203, 2024 Feb.
Artículo en Inglés | MEDLINE | ID: mdl-38491694

RESUMEN

An indirect-drive inertial fusion experiment on the National Ignition Facility was driven using 2.05 MJ of laser light at a wavelength of 351 nm and produced 3.1±0.16 MJ of total fusion yield, producing a target gain G=1.5±0.1 exceeding unity for the first time in a laboratory experiment [Phys. Rev. E 109, 025204 (2024)10.1103/PhysRevE.109.025204]. Herein we describe the experimental evidence for the increased drive on the capsule using additional laser energy and control over known degradation mechanisms, which are critical to achieving high performance. Improved fuel compression relative to previous megajoule-yield experiments is observed. Novel signatures of the ignition and burn propagation to high yield can now be studied in the laboratory for the first time.

5.
Nat Commun ; 15(1): 2975, 2024 Apr 06.
Artículo en Inglés | MEDLINE | ID: mdl-38582938

RESUMEN

Indirect Drive Inertial Confinement Fusion Experiments on the National Ignition Facility (NIF) have achieved a burning plasma state with neutron yields exceeding 170 kJ, roughly 3 times the prior record and a necessary stage for igniting plasmas. The results are achieved despite multiple sources of degradations that lead to high variability in performance. Results shown here, for the first time, include an empirical correction factor for mode-2 asymmetry in the burning plasma regime in addition to previously determined corrections for radiative mix and mode-1. Analysis shows that including these three corrections alone accounts for the measured fusion performance variability in the two highest performing experimental campaigns on the NIF to within error. Here we quantify the performance sensitivity to mode-2 symmetry in the burning plasma regime and apply the results, in the form of an empirical correction to a 1D performance model. Furthermore, we find the sensitivity to mode-2 determined through a series of integrated 2D radiation hydrodynamic simulations to be consistent with the experimentally determined sensitivity only when including alpha-heating.

6.
Phys Rev E ; 106(2-2): 025202, 2022 Aug.
Artículo en Inglés | MEDLINE | ID: mdl-36109932

RESUMEN

An inertial fusion implosion on the National Ignition Facility, conducted on August 8, 2021 (N210808), recently produced more than a megajoule of fusion yield and passed Lawson's criterion for ignition [Phys. Rev. Lett. 129, 075001 (2022)10.1103/PhysRevLett.129.075001]. We describe the experimental improvements that enabled N210808 and present the first experimental measurements from an igniting plasma in the laboratory. Ignition metrics like the product of hot-spot energy and pressure squared, in the absence of self-heating, increased by ∼35%, leading to record values and an enhancement from previous experiments in the hot-spot energy (∼3×), pressure (∼2×), and mass (∼2×). These results are consistent with self-heating dominating other power balance terms. The burn rate increases by an order of magnitude after peak compression, and the hot-spot conditions show clear evidence for burn propagation into the dense fuel surrounding the hot spot. These novel dynamics and thermodynamic properties have never been observed on prior inertial fusion experiments.

7.
Phys Rev E ; 106(2-2): 025201, 2022 Aug.
Artículo en Inglés | MEDLINE | ID: mdl-36110025

RESUMEN

We present the design of the first igniting fusion plasma in the laboratory by Lawson's criterion that produced 1.37 MJ of fusion energy, Hybrid-E experiment N210808 (August 8, 2021) [Phys. Rev. Lett. 129, 075001 (2022)10.1103/PhysRevLett.129.075001]. This design uses the indirect drive inertial confinement fusion approach to heat and compress a central "hot spot" of deuterium-tritium (DT) fuel using a surrounding dense DT fuel piston. Ignition occurs when the heating from absorption of α particles created in the fusion process overcomes the loss mechanisms in the system for a duration of time. This letter describes key design changes which enabled a ∼3-6× increase in an ignition figure of merit (generalized Lawson criterion) [Phys. Plasmas 28, 022704 (2021)1070-664X10.1063/5.0035583, Phys. Plasmas 25, 122704 (2018)1070-664X10.1063/1.5049595]) and an eightfold increase in fusion energy output compared to predecessor experiments. We present simulations of the hot-spot conditions for experiment N210808 that show fundamentally different behavior compared to predecessor experiments and simulated metrics that are consistent with N210808 reaching for the first time in the laboratory "ignition."

8.
Vet Comp Orthop Traumatol ; 24(5): 398-401, 2011.
Artículo en Inglés | MEDLINE | ID: mdl-21792474

RESUMEN

A 10-month-old Yorkshire Terrier was referred for evaluation of an intermittent right thoracic limb lameness that acutely progressed to non-weight-bearing. A diagnosis of bilateral bone cysts of the humeral condyles with a pathologic fracture of the lateral aspect of the right humeral condyle was given following radiographic and histopathologic examination. Bilateral pathology necessitated consideration of treatment modalities other than amputation of the limb, as previously reported. Arthrodesis of the right elbow using a 2.0 mm locking bone plate was performed. The dog did not experience any complications associated with the procedure or the contralateral bone cyst.


Asunto(s)
Artrodesis/veterinaria , Quistes Óseos/veterinaria , Enfermedades de los Perros/cirugía , Articulación del Codo/cirugía , Fracturas Espontáneas/veterinaria , Animales , Quistes Óseos/patología , Quistes Óseos/cirugía , Enfermedades de los Perros/diagnóstico por imagen , Perros , Femenino , Miembro Anterior/diagnóstico por imagen , Miembro Anterior/patología , Fracturas Espontáneas/cirugía , Radiografía
9.
J Am Podiatr Med Assoc ; 84(9): 463-9, 1994 Sep.
Artículo en Inglés | MEDLINE | ID: mdl-7965696

RESUMEN

Selection of an appropriate wound dressing, to potentiate healing, demands knowledge about varying classes of dressings. With the growing number of wound dressings available, health care providers must understand both the principles of dressing development as well as the qualities of each individual product. The author compares five classes of wound dressings: hydrocolloids, hydrogels, films, foams, and sodium/calcium alginates. Also, principles of dressing selection and long-term wound management guidelines are presented.


Asunto(s)
Vendajes , Cicatrización de Heridas , Humanos
10.
Aust Vet J ; 90(7): 256-63, 2012 Jul.
Artículo en Inglés | MEDLINE | ID: mdl-22731945

RESUMEN

BACKGROUND: Hinged circular external skeletal fixator constructs are used to perform sequential correction of angular limb deformities, often with resultant limb segment lengthening, via distraction osteogenesis. Although there are several reports describing the use of these constructs for correction of antebrachial deformities in dogs, there is little information regarding their use on other limb segments. This report describes the use of hinged circular fixator constructs for the correction of acquired crural deformities in three skeletally immature dogs. CASE REPORTS: Two dogs had purely frontal plane deformities (one valgus, one varus) and the third dog had frontal (valgus) and sagittal (recurvatum) components to its deformity. At the time of long-term evaluation, frontal plane angulation relative to the contralateral limb improved from 40° to 22° of valgus, 30° to 5° of valgus, and 20° to 1° of varus in the three individual dogs. Tibial length discrepancies of 12% and 22% that were initially present in two dogs were improved to 6% and 10%, respectively, of the contralateral tibial length at the time of final evaluation; both dogs had compensatory growth of the ipsilateral femur and all dogs had an excellent functional outcome. CONCLUSION: These cases illustrate the value of using hinged circular fixator constructs for correction of crural angular deformities, particularly when length discrepancies of the tibia are present.


Asunto(s)
Enfermedades del Desarrollo Óseo/veterinaria , Enfermedades de los Perros/cirugía , Fijadores Externos/veterinaria , Fémur/anomalías , Diferencia de Longitud de las Piernas/veterinaria , Osteogénesis por Distracción/veterinaria , Animales , Enfermedades del Desarrollo Óseo/cirugía , Perros , Femenino , Fémur/cirugía , Diferencia de Longitud de las Piernas/cirugía , Deformidades Congénitas de las Extremidades Inferiores/cirugía , Deformidades Congénitas de las Extremidades Inferiores/veterinaria , Masculino , Osteogénesis por Distracción/instrumentación , Osteogénesis por Distracción/métodos , Osteotomía/veterinaria , Tibia/anomalías , Tibia/cirugía , Resultado del Tratamiento
11.
J Clin Psychol ; 45(2): 324-30, 1989 Mar.
Artículo en Inglés | MEDLINE | ID: mdl-2723089

RESUMEN

This study examined differences between conjugally abused and nonabused female employees at a state-supported ICF/MR residential facility in relation to the potential for client abuse, absenteeism rates, and performance ratings. The research was conducted at a rural institution for mentally retarded persons at which approximately 72% of the workforce was female. A survey package composed of demographic questions, the Child Abuse Potential Inventory (Milner, 1980), and other self-report questions that concerned abuse was distributed to all permanent female employees. The survey return rate was 31.7%. Analysis of the data indicated a significant difference between CAP scores for emotionally and physically abused women and their nonabused counterparts (p less than .01). When a CAP score of 215 was used as a cut-off, 44% of the abused women were classified into the potential abuser category. No significant differences were revealed between categories of abuse and measures of absenteeism or performance appraisal scores.


Asunto(s)
Absentismo , Educación de las Personas con Discapacidad Intelectual , Evaluación del Rendimiento de Empleados , Satisfacción en el Trabajo , Administración de Personal , Maltrato Conyugal/psicología , Adulto , Niño , Maltrato a los Niños/psicología , Femenino , Humanos , Relaciones Profesional-Paciente , Pruebas Psicológicas , Factores de Riesgo
SELECCIÓN DE REFERENCIAS
DETALLE DE LA BÚSQUEDA