Two color DNA barcode detection in photoluminescence suppressed silicon nitride nanopores.

Optical sensing of solid-state nanopores is a relatively new approach that can enable high-throughput, multicolor readout from a collection of nanopores. It is therefore highly attractive for applications such as nanopore-based DNA sequencing and genotyping using DNA barcodes. However, to date optical readout has been plagued by the need to achieve sufficiently high signal-to-noise ratio (SNR) for single fluorophore sensing, while still maintaining millisecond resolution. One of the main factors degrading the optical SNR in solid-state nanopores is the high photoluminescence (PL) background emanating from the silicon nitride (SiNx) membrane in which pores are commonly fabricated. Focusing on the optical properties of SiNx nanopores we show that the local membrane PL intensity is substantially reduced, and its spectrum is shifted toward shorter wavelengths with increasing e-beam dose. This phenomenon, which is correlated with a marked photocurrent enhancement in these nanopores, is utilized to perform for the first time single molecule fluorescence detection using both green and red laser excitations. Specifically, the reduction in PL and the concurrent measurement of the nanopore photocurrent enhancement allow us to maximize the background suppression and to detect a dual color, five-unit DNA barcode with high SNR levels.

The Effect of dye-dye interactions on the spatial resolution of single-molecule FRET measurements in nucleic acids.

We study the effect of dye-dye interactions in labeled double-stranded DNA molecules on the Förster resonance energy transfer (FRET) efficiency at the single-molecule level. An extensive analysis of internally labeled double-stranded DNA molecules in bulk and at the single-molecule level reveals that donor-acceptor absolute distances can be reliably extracted down to approximately 3-nm separation, provided that dye-dye quenching is accounted for. At these short separations, we find significant long-lived fluorescence fluctuations among discrete levels originating from the simultaneous and synchronous quenching of both dyes. By comparing four different donor-acceptor dye pairs (TMR-ATTO647N, Cy3-ATTO647N, TMR-Cy5, and Cy3-Cy5), we find that this phenomenon depends on the nature of the dye pair used, with the cyanine pair Cy3-Cy5 showing the least amount of fluctuations. The significance of these results is twofold: First, they illustrate that when dye-dye quenching is accounted for, single-molecule FRET can be used to accurately measure inter-dye distances, even at short separations. Second, these results are useful when deciding which dye pairs to use for nucleic acids analyses using FRET.

Optoelectronic control of surface charge and translocation dynamics in solid-state nanopores.

Nanopores can be used to detect and analyse biomolecules. However, controlling the translocation speed of molecules through a pore is difficult, which limits the wider application of these sensors. Here, we show that low-power visible light can be used to control surface charge in solid-state nanopores and can influence the translocation dynamics of DNA and proteins. We find that laser light precisely focused at a nanopore can induce reversible negative surface charge densities as high as 1 C m(-2), and that the effect is tunable on submillisecond timescales by adjusting the photon density. By modulating the surface charge, we can control the amount of electroosmotic flow through the nanopore, which affects the speed of translocating biomolecules. In particular, a few milliwatts of green light can reduce the translocation speed of double-stranded DNA by more than an order of magnitude and the translocation speed of small globular proteins such as ubiquitin by more than two orders of magnitude. The laser light can also be used to unclog blocked pores. Finally, we discuss a mechanism to account for the observed optoelectronic phenomenon.

Automated system for single molecule fluorescence measurements of surface-immobilized biomolecules.

Fluorescence Resonance Energy Transfer (FRET) microscopy has been widely used to study the structure and dynamics of molecules of biological interest, such as nucleic acids and proteins. Single molecule FRET (sm-FRET) measurements on immobilized molecules permit long observations of the system -effectively until both dyes photobleach- resulting in time-traces that report on biomolecular dynamics with a broad range of timescales from milliseconds to minutes. To facilitate the acquisition of large number of traces for statistical analyses, the process must be automated and the sample environment should be tightly controlled over the entire measurement time (approximately 12 hours). This is accomplished using an automated scanning confocal microscope that allows the interrogation of thousands of single molecules overnight, and a microfluidic cell that permits the controlled exchange of buffer, with restricted oxygen content and maintains a constant temperature throughout the entire measuring period. Here we show how to assemble the microfluidic device and how to activate its surface for DNA immobilization. Then we explain how to prepare a buffer to maximize the photostability and lifetime of the fluorophores. Finally, we show the steps involved in preparing the setup for the automated acquisition of time-resolved single molecule FRET traces of DNA molecules.

Modeling solid-state effects on NMR chemical shifts using electrostatic models.

This paper presents a comparison of the embedded ion method (EIM) and the surface charge representation of the electrostatic embedding potential (SCREEP) method, two methods which can be used to calculate solid-state effects on NMR chemical shifts. The results in a selected group of compounds with known single-crystal solid-state NMR data and neutron diffraction structures, confirm that these effects are important in both (13)C and (15)N chemical shifts. The solid-state effects calculated by both methods are similar and of equal statistical quality when compared with the experimental data.