RESUMEN
The Drinking Water Directive (EU) 2020/2184 includes the parameter microcystin LR, a cyanotoxin, which drinking water producers need to analyze if the water source has potential for cyanobacterial blooms. In light of the increasing occurrences of cyanobacterial blooms worldwide and given that more than 50 percent of the drinking water in Sweden is produced from surface water, both fresh and brackish, the need for improved knowledge about cyanotoxin occurrence and cyanobacterial diversity has increased. In this study, a total of 98 cyanobacterial blooms were sampled in 2016-2017 and identified based on their toxin production and taxonomical compositions. The surface water samples from freshwater lakes throughout Sweden including brackish water from eight east coast locations along the Baltic Sea were analyzed for their toxin content with LC-MS/MS and taxonomic composition with 16S rRNA amplicon sequencing. Both the extracellular and the total toxin content were analyzed. Microcystin's prevalence was highest with presence in 82% of blooms, of which as a free toxin in 39% of blooms. Saxitoxins were found in 36% of blooms in which the congener decarbamoylsaxitoxin (dcSTX) was detected for the first time in Swedish surface waters at four sampling sites. Anatoxins were most rarely detected, followed by cylindrospermopsin, which were found in 6% and 10% of samples, respectively. As expected, nodularin was detected in samples collected from the Baltic Sea only. The cyanobacterial operational taxonomic units (OTUs) with the highest abundance and prevalence could be annotated to Aphanizomenon NIES-81 and the second most profuse cyanobacterial taxon to Microcystis PCC 7914. In addition, two correlations were found, one between Aphanizomenon NIES-81 and saxitoxins and another between Microcystis PCC 7914 and microcystins. This study is of value to drinking water management and scientists involved in recognizing and controlling toxic cyanobacteria blooms.
Asunto(s)
Cianobacterias , Lagos , Toxinas Marinas , Microcistinas , Suecia , Cianobacterias/genética , Cianobacterias/aislamiento & purificación , Microcistinas/análisis , Lagos/microbiología , Toxinas Marinas/análisis , Saxitoxina/análisis , Monitoreo del Ambiente , ARN Ribosómico 16S/genética , Toxinas Bacterianas/análisis , Toxinas de Cianobacterias , Espectrometría de Masas en TándemRESUMEN
Food authorities aim to safeguard our food. This requires sensitive analyses to guarantee detection of both banned and regulated substances at low concentrations. At the same time, broad screening methods are needed to identify new emerging risks. For this purpose, effect-based bioassays combined with mass spectrometric analyses offer an advantage. During the regular monitoring of dioxins in agricultural products, a discrepancy was observed between the results of the DR CALUX (Dioxin-Responsive Chemical Activated Luciferase gene Expression) bioassay and the confirmatory gas chromatographic high resolution mass spectrometric (GC-HRMS) analysis in egg and broiler fat samples. The response in the bioassay was high, suggesting a clear exceedance of the maximum limits of dioxins in these samples, yet regulated dioxins or dl-PCBs were not detected by GC/HRMS analysis. Ultimately, a broad screening analysis using GC-HRMS resulted in the identification of 2,3,7,8-tetrabromo-dibenzofuran (2,3,7,8-TBDF) in both egg and broiler fat. To investigate the potential source of this brominated furan contaminant, different samples were analyzed: bedding material, poultry feed, feed additives (choline chloride and l-lysine), and seaweed. The poultry feed and feed additives all contained 2,3,7,8-TBDF. Using a feed-to-food transfer model, it became clear that the poultry feed was probably the source of 2,3,7,8-TBDF in broilers and eggs through a feed additive like L-lysine or choline chloride. This study underlines the importance of using a combination of effect-based screening assays with sensitive analytical methods to detect potential new and emerging risks.
RESUMEN
The determination of chlorinated paraffins (CPs) has posed an intractable challenge in analytical chemistry for over three decades. The combination of an as yet unspecifiable number (tens - hundreds of thousands) of individual congeners in mass produced commercial CP mixtures and the steric interactions between them, contrive to defy efforts to characterise their residual occurrences in environmental compartments, food and human tissues. However, recent advances in instrumentation (mass spectrometric detectors and nuclear magnetic resonance), combined with interlaboratory studies, have allowed a better insight into the nature of the conundrums. These include the variability of results, even between experienced laboratories when there is insufficient matching between analytical standards and occurrence profiles, the poor (or no) response of some instrumentation to some CP congener configurations (multiple terminal chlorines or < four chlorines) and the occurrence of chlorinated olefins in commercial mixtures. The findings illustrate some limitations in the existing set of commercially available standards. These include cross-contamination of some standards (complex CP mixtures), an insufficient number of single chain standards (existing ones do not fully reflect food/biota occurrences), lack of homologue group standards and unsuitability of some configurationally defined CP congeners/labelled standards (poor instrument response and a smaller likelihood of occurrence in commercial mixtures). They also indicate an underestimation in reported occurrences arising from those CPs that are unresponsive during measurement. A more extensive set of standards is suggested and while this might not be a panacea for accurate CP determination, it would reduce the layers of complexity inherent in the analysis.
Asunto(s)
Hidrocarburos Clorados , Parafina , China , Cloro , Monitoreo del Ambiente , Humanos , Hidrocarburos Clorados/análisis , Espectrometría de Masas , Parafina/análisisRESUMEN
Chlorinated paraffins (CPs) are produced at more than one million tons per year. Technical CPs mixtures may contain impurities, which end up in consumer products. In the present study, 17 technical CPs mixtures were investigated for the potential occurrence of potential impurities. By applying the DR-CALUX bioassay, 3 out of 17 technical mixtures were shown to elicit responses at 4 h exposure time, but much lower at 48 h. Constitutional defined CPs materials did not show responses. Subsequently different groups of known AhR-agonists and compounds suspected to be present in technical CPs mixtures were investigated. Benzene, (poly)chlorobenzene, non-dioxin like polychlorinated naphthalenes (PCNs), and three-ringed polyaromatic hydrocarbons (PAHs) did not result in a significant response at 4 h or 48 h. TCDD, non-ortho PCBs, dioxin-like PCNs, four or five ringed PAHs and their chlorinated analogues resulted in a significant response. TCDD and the non-ortho PCBs showed the highest potency and stability, while dioxin-like PCNs, PAHs, and the chlorinated PAHs were clearly inactivated (metabolized) at longer incubation. Altogether, the present findings substantiate that AhR-mediated responses of CPs technical mixtures in the DR-CALUX bioassay are caused by impurities, most likely some intermediate stable AhR-agonists such as dioxin-like PCNs or (chlorinated) PAHs. The current study shows that impurities in CPs technical mixtures need to be investigated for assessing the safety of technical CPs mixtures.
Asunto(s)
Hidrocarburos Clorados/toxicidad , Parafina/toxicidad , Receptores de Hidrocarburo de Aril/agonistas , Animales , Bioensayo , Línea Celular , Seguridad de Productos para el Consumidor , RatasRESUMEN
A new, efficient method for analysis of organic micropollutants (OMPs) in water samples was developed, validated and applied in a nationwide survey. The goal with the survey was to identify common compounds with relatively high concentrations to be used as markers e.g. for routine monitoring of removal efficiencies. The method comprises sample concentration by evaporation, and large volume injection on a standard UHPLC-MS/MS system. The OMPs selected for this approach were mainly semi-polar and non-volatile, with molecular weights below 300 Da. Except one outlier, the limit of detection (LoD) ranged from 0.01 to 1 ng/L which is sufficient for most surface waters, and also useful for many ground waters. The method requires low manual labor and comparably small sample volumes, enabling a cost-efficient nationwide screening. Raw- and drinking water from 90 Swedish water treatment plants (WTPs) were investigated for occurrence of the selected OMPs. Carbamazepine and tramadol were the most widespread compounds, detected in around 50% of the surface waters. Ground water from rock aquifers were least contaminated, while soil aquifers were more similar to surface waters. Due to the frequent use of ground water in Sweden, many samples did not contain any of the investigated compounds (i.e. below LoD). In the positive samples, the median estimated concentrations of individual OMPs were generally <1 ng/L in raw water and <0.5 ng/L in drinking water. Swedish waters were in general less contaminated than those investigated in similar Brazilian, Chinese, pan-European and US studies. Altogether, the presented methodology gave a cost-efficient overview on the occurrence and estimated concentrations of OMPs in raw- and drinking water on a national level in Sweden. From the data, WTPs can find suitable OMPs to monitor at their site, for example for measuring removal efficiencies on a routine basis.