Synthesis, Structure, and Electric Conductivity of Higher Hydrides of Ytterbium at High Pressure.

While most of the rare-earth metals readily form trihydrides, due to increased stability of the filled 4f electronic shell for Yb(II), only YbH2.67, formally corresponding to YbII(YbIIIH4)2 (or Yb3H8), remains the highest hydride of ytterbium. Utilizing the diamond anvil cell methodology and synchrotron powder X-ray diffraction, we have attempted to push this limit further via hydrogenation of metallic Yb and Yb3H8. Compression of the latter has also been investigated in a neutral pressure-transmitting medium (PTM). While the in situ heating of Yb facilitates the formation of YbH2+x hydrides, we have not observed clear qualitative differences between the systems compressed in H2 and He or Ne PTM. In all of these cases, a sequence of phase transitions occurred within ca. 13-18 GPa (P3̅1m-I4/m phase) and around 27 GPa (to the I4/mmm phase). The molecular volume of the systems compressed in H2 PTM is ca. 1.5% larger than of those compressed in inert gases, suggesting a small hydrogen uptake. Nevertheless, hydrogenation toward YbH3 is incomplete, and polyhydrides do not form up to the highest pressure studied here (ca. 75 GPa). As pointed out by electronic transport measurements, the mixed-valence Yb3H8 retains its semiconducting character up to >50 GPa, although the very low remnant activation energy of conduction (<5 meV) suggests that metallization under further compression should be achievable. Finally, we provide a theoretical description of a hypothetical stoichiometric YbH3.

Charge doping to flat AgF2 monolayers in a chemical capacitor setup.

Flat monolayers of silver(II) fluoride, which could be obtained by epitaxial deposition on an appropriate substrate, have been recently predicted to exhibit very strong antiferro-magnetic superexchange and to have large potential for ambient pressure superconductivity if doped to an optimal level. It was shown that AgF2 could become a magnetic glue-based superconductor with a critical superconducting temperature approaching 200 K at optimum doping. In the current work we calculate the optimum doping to correspond to 14% of holes per formula unit, i.e. quite similar to that for oxocuprates(II). Furthermore, using DFT calculations we show that flat [AgF2] single layers can indeed be doped to a controlled extent using a recently proposed "chemical capacitor" setup. Hole doping associated with the formation of Ag(III) proves to be difficult to achieve in the setup explored in this work as it falls at the verge of charge stability of fluoride anions and does not affect the d(x2 - y2) manifold. However, in the case of electron doping, manipulation of different factors - such as the number of dopant layers and the thickness of the separator - permits fine tuning of the doping level (and concomitantly TC) all the way from the underdoped to overdoped regime (in a similar manner to chemical doping for the Nd2CuO4 analogue).

Defect Trapping and Phase Separation in Chemically Doped Bulk AgF2.

We report a computational survey of chemical doping of silver(II) fluoride, which has recently attracted attention as an analogue of La2CuO4-a known precursor of high-temperature superconductors. By introducing fluorine defects (vacancies or interstitial adatoms) into the crystal structure, we obtain nonstoichiometric, electron- and hole-doped polymorphs of AgF2±x. We find that the ground-state solutions show a strong tendency for localization of defects and of the associated electronic states, and the resulting doped phases exhibit insulating or semiconducting properties. Furthermore, the distribution of Ag(I)/Ag(III) sites which appear in the crystal structure points to the propensity of the AgF2 system for phase separation upon chemical doping, which is in line with observations from previous experimental attempts. Overall, our results indicate that chemical modification may not be a feasible way to achieve doping in bulk silver(II) fluoride, which is considered essential for the emergence of high-Tc superconductivity.

Separation-Controlled Redox Reactions.

In the era of molecular devices and nanotechnology, precise control over electron-transfer processes is strongly desired. However, redox reactions are usually characterized by reaction equilibrium constants strongly departing from unity. This leads to strong favoring of either reactants or products and does not permit subtle control of transferred charge (doping). Here we propose, based on theoretical studies for periodic systems, how charge transfer between reactants could be finely manipulated in the epitaxially grown system composed of extremely strong oxidizer, reducing agent, and an inert separator-the key factor of control.

Preparative Electrosynthesis of Strong Oxidizers at Boron-Doped Diamond Electrode in Anhydrous HF.

The use of the boron-doped diamond electrode as a sufficiently stable electrode for electrochemical measurements/synthesis in liquid anhydrous hydrogen fluoride medium is reported. Electrooxidation of silver(I) has been studied in this solvent by using classical transient electrochemical methods and impedance spectroscopy. It has been found that faradaic currents related to silver(I) oxidation and the fluorine evolution reaction are reasonably separated at the potential scale, which allows efficient electrosynthesis of AgII F2 , a powerful oxidizer. Impedance spectroscopy measurements provide insight into complex mechanism of AgF2 formation. The procedure for electrosynthesis is provided for the first time in both galvanostatic and potentiostatic condition.

Persistence of Mixed and Non-intermediate Valence in the High-Pressure Structure of Silver(I,III) Oxide, AgO: A Combined Raman, X-ray Diffraction (XRD), and Density Functional Theory (DFT) Study.

The X-ray diffraction data collected up to ca. 56 GPa and the Raman spectra measured up to 74.8 GPa for AgO, or AgIAgIIIO2, which is a prototypical mixed valence (disproportionated) oxide, indicate that two consecutive phase transitions occur: the first-order phase transition occurs between 16.1 GPa and 19.7 GPa, and a second-order phase transition occurs at ca. 40 GPa. All polymorphic forms host the square planar [AgIIIO4] units typical of low-spin AgIII. The disproportionated Imma form persists at least up to 74.8 GPa, as indicated by Raman spectra. Theoretical hybrid density functional theory (DFT) calculations show that the first-order transition is phonon-driven. AgO stubbornly remains disproportionated up to at least 100 GPa-in striking contrast to its copper analogue-and the fundamental band gap of AgO is ∼0.3 eV at this pressure and is weakly pressure-dependent. Metallization of AgO is yet to be achieved.

High-Pressure Behavior of Silver Fluorides up to 40 GPa.

A combined experimental-theoretical study of silver(I) and silver(II) fluorides under high pressure is reported. For AgI, the CsCl-type structure is stable to at least 39 GPa; the overtone of the IR-active mode is seen in the Raman spectrum. Its AgIIF2 sibling is a unique compound in many ways: it is more covalent than other known difluorides, crystallizes in a layered structure, and is enormously reactive. Using X-ray diffraction and guided by theoretical calculations (density functional theory), we have been able to elucidate crystal structures of high-pressure polymorphs of AgF2. The transition from ambient pressure to an unprecedented nanotubular structure takes place via an intermediate orthorhombic layered structure, which lacks an inversion center. The observed phase transitions are discussed within the broader framework of the fluorite → cotunnite → Ni2In series, which has been seen for other metal difluorides.

Impact of X-ray irradiation as an equivalent alternative to gamma for sterilization of single-use bioprocessing polymers.

Irradiation sterilization of polymeric pharmaceutical processing systems and medical devices, an essential healthcare technology, is facing critical business continuity challenges, driving the need to qualify equivalent alternative irradiation technologies, such as X-ray. Whereas the underlying there is a paucity of cross-industry published data evaluating X-ray irradiation effects on plastics as compared to gamma irradiation. That leads to regulatory uncertainty in the levels of costly validation data regulators will require and overall apprehension in the rate of X-ray irradiation adoption. The present study evaluates the impact of X-ray versus gamma irradiation on a wide range of polymers with more than 36 single-use (SU) components, using a comprehensive set of industry aligned methods for characterization of bioprocess polymers. Whereas many of these techniques readily demonstrate changes in polymer properties following irradiation, all of the polymers evaluated demonstrated that the impact of X-ray irradiation was to the same degree or less as compared to gamma. Increased publication of studies evaluating the impact to polymers of X-ray versus gamma irradiation is critical to leveraging extensive, existing validation packages on bioprocess systems and medical devices obtained following gamma irradiation, and essential in qualifying X-ray irradiation as an equivalent technology (i.e., materials are impacted to the same extent or less than gamma) that can overcome business continuity challenges to ensure continued availability of critical patient therapies.

Stability of hypothetical AgIICl2 polymorphs under high pressure, revisited: a computational study.

A comparative computational study of stability of candidate structures for an as-yet unknown silver dichloride AgCl2 is presented. It is found that all considered candidates have a negative enthalpy of formation, but are unstable towards charge transfer and decomposition into silver(I) chloride and chlorine within the DFT and hybrid-DFT approaches in the entire studied pressure range. Within SCAN approach, several of the "true" AgIICl2 polymorphs (i.e. containing Ag(II) species) exhibit a region of stability below ca. 20 GPa. However, their stability with respect to aforementioned decomposition decreases with pressure by account of all three DFT methods, which suggests a limited possibility of high-pressure synthesis of AgCl2. Some common patterns in pressure-induced structural transitions observed in the studied systems also emerge, which further testify to an instability of hypothetical AgCl2 towards charge transfer and phase separation.

Dramatic enhancement of spin-spin coupling and quenching of magnetic dimensionality in compressed silver difluoride.

Meta-GGA calculations of the ambient and high-pressure polymorphs of silver difluoride indicate that the compression-induced structural changes lead to a 3.5-fold increase in the strength of antiferromagnetic spin-spin interactions resulting in coupling constant values higher than those found for record-holding oxocuprates(ii).

Ag2S2O8 meets AgSO4: the second example of metal-ligand redox isomerism among inorganic systems.

Valence (redox) isomerism based on electron exchange between a metal and a ligand is immensely rare in purely inorganic systems, with only one documented case, that of PbS2 which adopts two polymorphic forms corresponding to Pb(iv)(S2-)2 and Pb(ii)(S22-). Here we have taken advantage of metathetic reactions using salts of weakly coordinating anions and we have prepared for the first time Ag(i)2S2O8, silver(i) peroxydisulphate. The title compound crystallizes in the non-centrosymmetric Cc space group with partial disorder of the anionic sublattice. Ag(i)2S2O8 is a highly thermally unstable diamagnetic and colourless valence isomer of the antiferromagnetic and black Ag(ii)SO4, described by us in the past.