RESUMEN
Although, in general, the application of coated capillaries is recommended for the separation of intact proteins, bare silica capillary is still the most often used capillary due to its simplicity and cheapness. In this work, the performance of bare fused silica capillary for intact protein analysis was compared to that of different (dynamically coated polybrene (PB) and permanently coated linear polyacrylamide (LPA)) coated capillaries using capillary zone electrophoresis - mass spectrometry (CZE-MS). In cases where low pH (pH=1.8) was used in bare silica capillaries, good precision (0.56-0.78 RSD% and 1.7-6.5 RSD% for migration times and peak areas, respectively), minimal adsorption and separation efficiency (N= 27 000/m - 322 000/m) similar to or even better than those obtained with the coated capillaries (created by an intricate multi-step process) was achieved. The PB and the LPA capillaries demonstrated their slightly better resolving power in terms of separating the different forms/variants of the same protein (e.g., hemoglobin subunits). Among the studied capillaries the one with LPA coating showed the most stable separations in the long term (n=25: 0.18-0.49 RSD% and 3.1-4.9 RSD% for migration times and peak areas, respectively). For the separation of a few proteins or even a larger number of proteins in biological samples (e.g., snake venom) the application of the simple and cheap bare fused silica capillary can be considered as an efficient choice.
Asunto(s)
Técnicas de Química Analítica , Electroforesis Capilar , Espectrometría de Masas , Proteínas , Resinas Acrílicas/química , Técnicas de Química Analítica/instrumentación , Técnicas de Química Analítica/métodos , Electroforesis Capilar/instrumentación , Bromuro de Hexadimetrina/química , Proteínas/química , Proteínas/aislamiento & purificaciónRESUMEN
The applicability of capillary zone electrophoresis (CZE) for the separation of the deamidated forms of insulin has been studied. 50 mM NH4Ac (pH=9) with 20 % v/v isopropylalcohol was found optimal for efficient separation of insulin from its even 10 deamidated forms. The developed method was efficiently applied for monitoring the degradation rate of insulin and the formation of different deamidation isoforms. Two months after the acidification more than thirty peaks can be observed in the electropherogram, because degradation products other than deamidated components were formed as well. The recorded mass spectra enabled us to assign the exact mass of the components, and thus the identification of insulin isoforms could be accomplished. We think that this study provides useful information on how the determination of several deamidation forms can be carried out with CE-MS, but the identification of the exact position of deamidation sites in the insulin molecule remains a challenge.