Emission of volatile organic compounds (VOCs) from application of commercial pesticides in China.

Applying pesticides can result in emissions of volatile organic compounds (VOCs), but little is known about VOC emission characteristics and the quantities in particular regions. We investigated the use of pesticides in China based on a large-scale survey of 330 counties in 31 provinces and evaluated the national pesticide VOC emission potentials based on thermogravimetric analysis of 1930 commercial pesticides. The results showed that herbicides were the most extensively used pesticide category in China, accounting for 43.47%; emulsifiable concentrate (EC), suspension concentrate, and wettable powder were the dominant pesticide formulations, with proportions of 26.75%, 17.68%, and 17.31%, respectively. The VOC emission potential coefficient (EP) of the liquid formulations was higher than the solid formulations, and the maximum mean EP was 45.59% for EC and the minimum was 0.76% for WP. Among 437 high-VOC pesticide products used in China, EC accounted for 83.52%, and 16.93% of those contained abamectin. The total VOC emissions derived from commercial pesticides in China were 280 kt (kilotons) in 2018, and 65.35% of the contribution was derived from EC. Shandong, Hunan, and Henan were the three provinces with the highest pesticide VOC emissions (>21 kt/y). The emission rate of VOCs from pesticides was 24.80 t/d in China, which was higher than in San Joaquin Valley, California. These findings suggest that some comprehensive measures (e.g., perfecting pesticide management policy, strict supervision for pesticide production and use, and strengthening pesticide reduction publicity) should be taken to reduce VOC emissions from pesticide applications.

[Research Progress on Pollution Characteristics, Degradation, and Transformation of Typical PPCPs in the Process of Wastewater Treatment].

Pharmaceuticals and personal care products (PPCPs) have received extensive attention as a new type of pollutant inin the 21st century, and the ecological and health risks caused by PPCPs have gradually been recognized by government regulatory agencies. Daily use of PPCPs has led to their frequent detection and high concentrations in the influent, effluent, and sludge of wastewater treatment plants, but traditional wastewater treatment processes can't remove them effectively. Most research about enhancing the removal of PPCPs through microbial degradation, photodegradation, and ozonation is still in the laboratory research stage, and the removal effects are not satisfactory when applied to actual sewage treatment. Therefore, the effective removal of PPCPs from domestic wastewater is a critical technical problem that urgently needs to be studied and solved in the coming years. At present, many scholars do not have a comprehensive understanding about the degradation and transformation behaviors of microbes, ultraviolet, and ozone for typical PPCPs in the wastewater treatment process, so it is necessary to conduct a systematic analysis and discussion. In this study, 16 typical PPCPs frequently detected in sewage treatment plants were selected as research objects through a literature review. The occurrence, removal characteristics, and sludge adsorption properties of typical PPCPs in wastewater treatment plants were analyzed and summarized. The degradation and transformation behavior of typical PPCPs under microbial, ultraviolet, and ozone treatments in the wastewater treatment process were also discussed. Finally, based on current research gaps, some research directions for the removal and transformation of PPCPs in wastewater were proposed:① investigation into the removal characteristics of PPCPs by actual biochemical treatment; ② study on the mechanism of microbial degradation and transformation of typical PPCPs during biochemical treatment; ③ study on the degradation and transformation mechanism of typical PPCPs by UV/ozone in an actual sewage system; and ④ research on the application technology of removing PPCPs from sewage via microbial degradation, photodegradation, ozone oxidation, etc. The relevant results of this study can provide a reference for the pollution control of typical PPCPs in the sewage treatment process.

[Sorption Characteristics and Site Energy Distribution Theory of Typical Estrogens on Microplastics].

Microplastics (MPs) and estrogens are high-profile emerging contaminants at present, and MPs might become the carrier of estrogens in the environment and induce combined pollution. To study the adsorption behavior of polyethylene (PE) microplastics to typical estrogens, the adsorption isothermal properties of the six estrogens[estrone (E1), 17α-estradiol (17α-E2), 17ß-estradiol (17ß-E2), estriol (E3), diethylstilbestrol (DES), and ethinylestradiol (17α-EE2)] in single-solute and mixed-solute systems were studied through batch equilibrium adsorption experiments, in which the PE microplastics before and after adsorption were characterized by X-ray photoelectron spectroscopy (XPS) and Fourier transform infrared spectroscopy (FTIR). Then, the site energy distribution theory of the adsorption of six estrogens on PE microplastics was further analyzed based on the Freundlich model. The results showed that the adsorption process of selected estrogens with two concentrations (100 µg·L-1 and 1000 µg·L-1) on PE were more consistent with the pseudo-second order kinetic model. The increase in initial concentration reduced the equilibrium time of adsorption and increased the adsorbing capacity of estrogens on PE. In the single system (one estrogen) or mixed system (six estrogens) with different concentrations (10 µg·L-1-2000 µg·L-1), the Freundlich model showed the best fitting effect for the adsorption isotherm data (R2>0.94). The results of isothermal adsorption experiments and XPS and FTIR spectra showed that the adsorption of estrogens on PE in the two systems was heterogeneous adsorption, and hydrophobic distribution and van der Waals forces were the principal factors in the process of adsorption. The occurrence of C-O-C (in only the DES and 17α-EE2 systems) and O-C[FY=,1]O (in only the 17α-EE2 system) indicated that the adsorption of synthetic estrogens on PE was affected slightly by chemical bonding function, but no obvious effects were observed for natural estrogens. The results of site energy distribution analysis showed that, compared with the single system, the adsorption site energy of each estrogen shifted to the high-energy region in its entirety in the mixed system, and the site energy increased by 2.15%-40.98%. The energy change in DES was the most significant among all of the estrogens, indicating its competitive advantage in the mixed system. The above results of this study can provide some reference for the study of adsorption behavior, mechanism of action, and environmental risks under the coexisting condition of organic pollutants and MPs.

Effect comparisons of different conditioners and microbial agents on the degradation of estrogens during dairy manure composting.

To investigate the degradation efficiency of conditioners and commercial microbial agents on estrogens (E1, 17α-E2, 17ß-E2, E3, EE2, and DES) in the composting process of dairy manure, seven different treatments (RHB-BF, OSP-BF, SD-BF, MR-BF, MR-FS, MR-EM, and MR-CK) under forced ventilation conditions were composted and monitored regularly for 30 days. The results indicated that the removal rates of estrogens in seven treatments ranged from 95.35% to 99.63%, meanwhile the degradation effect of the composting process on 17ß-Estradiol equivalent (EEQ) was evaluated, and the removal rate of ΣEEQ ranged from 96.42% to 99.72%. With the combined addition of rice husk biochar (RHB) or oyster shell powder (OSP) and bio-bacterial fertilizer starter cultures (BF), namely RHB-BF and OSP-BF obviously promoted the rapid degradation of estrogens. 17ß-E2 was completely degraded on the fifth day of composting in OSP-BF. Microbial agents have some promotional effect and enhances the microbial degradation of synthetic estrogen (EE2, DES). According to the results of RDA, pH and EC were the main environmental factors affecting on the composition and succession of estrogen-related degrading bacteria in composting system. As predominant estrogens-degrading genera, Acinetobacter, Bacillus, and Pseudomonas effected obviously on the change of estrogens contents. The research results provide a practical reference for effective composting of dairy manure to enhancing estrogens removal and decreasing ecological risk.

Comparisons of pollution characteristics, emission situations, and mass loads for heavy metals in the manures of different livestock and poultry in China.

The application of livestock and poultry manures was the predominant source of heavy metals in agricultural soils, particularly in China. It is important to systematically compare the pollution characteristics, emission situations and mass loads for heavy metals in the manures of different livestock and poultry in China. According to analysis and estimation based on the reported concentration levels of eight heavy metals (Zn, Cu, Pb, Cd, Cr, Hg, As, and Ni) and the feed quantities of livestock (pig, cattle, and sheep) and poultry in 2017, the concentrations of Zn and Cu and the over-standard frequencies of Zn, Cu, Cd, and As were much higher than those of other heavy metals, especially in pig manure. In 2017, the total emission of livestock and poultry manure in China was 1.64 × 109 t (FW), which was mainly excreted from cattle (45.77%); while the total emission of heavy metals sourced from manures was 2.86 × 105 t (DW), with the predominant contribution originating from pig manure (71.52%). The highest mass loads of manures and heavy metals were observed in Shandong, Tianjin, Henan, and Shanghai, where heavy metal contamination may be occurring (especially for Zn and Cu). The heavy metal concentrations in livestock and poultry manures of China were similar to other countries; however, more heavy metals were discharged into agricultural land through manure (especially for Zn and Cu). For many countries, abundant Zn and Cu exist in agricultural soils, principally contributed by livestock and poultry manures. These heavy metals originate from their addition to livestock and poultry feeds. Therefore, reducing the addition of Zn and Cu in feeds is an effective measure to lower their input into agricultural soils.

[Discussion of Emissions and Health Risk of Polycyclic Aromatic Hydrocarbons (PAHs) from the Retreading Process of Waste Tires].

The emissions characteristics of 16 kinds of polycyclic aromatic hydrocarbons (PAHs) in ambient air during the waste tire retreading process (open-air storage, mixing, vulcanization, and grinding processes) and in workers' dormitory were analyzed. In addition, the occupational health risk of the workers was evaluated. Results showed that PAHs were detected in all retreading processes and in the workers' dormitory. The highest concentration site was the mixing process, followed by open-air storage and vulcanization process. The lowest concentration point was in the grinding process. The average concentration of PAHs in the workers' dormitory was 11.1 ng·m-3. The PAHs at all sampling points were largely phenanthrene (Phe), fluoranthene (Flu), anthracene (Ant), and pyrene (Pry), which also had a stronger linear correlation with the total PAH concentration. An analysis of the benzene rings showed that three ring and four ring were the majority, while two ring, five ring, and six ring components accounted for less than 10%. Results of the possible influencing factors of the PAHs revealed that the open-air storage and dormitory might be affected by a combustion source, but the mixing, vulcanization, and grinding processes might be affected by rubber oil. The principal component analysis (PCA) and cluster analysis showed that the spatial location of all sites would significantly influence the distribution of PAHs during the tire retreading process. The health risk assessment showed that occupational workers had a lower risk of lifelong cancer, and there was little influence on life expectancy.