Surface carboxylation or PEGylation decreases CuO nanoparticles' cytotoxicity to human cells in vitro without compromising their antibacterial properties.

Clinical use of CuO nanoparticles (NPs) as antibacterials can be hampered by their toxicity to human cells. We hypothesized that certain surface functionalizations of CuO NPs may render NPs toxic to bacteria, but still be relatively harmless to human cells. To control this hypothesis, the toxicity of differently functionalized CuO NPs to bacteria Escherichia coli vs human cells (THP-1 macrophages and HACAT keratinocytes) was compared using similar conditions and end points. CuO NPs functionalized with polyethylene glycol (CuO-PEG), carboxyl (CuO-COOH, anionic), ammonium (CuO-NH4+, cationic) and unfunctionalized CuO NPs and CuSO4 (controls) were tested. In general, the toxicity of Cu compounds decreased in the following order: CuO-NH4+ > unfunctionalized CuO > CuSO4 > CuO-COOH > CuO-PEG. Positively charged unfunctionalized CuO and especially CuO-NH4+ proved most toxic (24-h EC50 = 21.7-47 mg/l) and had comparable toxicity to bacterial and mammalian cells. The multivariate analysis revealed that toxicity of these NPs was mostly attributed to their positive zeta potential, small hydrodynamic size, high Cu dissolution, and induction of reactive oxygen species (ROS) and TNF-α. In contrast, CuO-COOH and CuO-PEG NPs had lower toxicity to human cells compared to bacteria despite efficient uptake of these NPs by human cells. In addition, these NPs did not induce TNF-α and ROS. Thus, by varying the NP functionalization and Cu form (soluble salt vs NPs), it was possible to "target" the toxicity of Cu compounds, whereas carboxylation and PEGylation rendered CuO NPs that were more toxic to bacteria than to human cells envisaging their use in medical antibacterial products.

Synergistic antibacterial effect of copper and silver nanoparticles and their mechanism of action.

Bacterial infections are one of the leading causes of death worldwide. In the case of topical bacterial infections such as wound infections, silver (Ag) has historically been one of the most widely used antibacterials. However, scientific publications have demonstrated the adverse effects of silver on human cells, ecotoxicity and insufficient antibacterial effect for the complete elimination of bacterial infections. The use of Ag in the form of nanoparticles (NPs, 1-100 nm) allows to control the release of antibacterial Ag ions but is still not sufficient to eliminate infection and avoid cytotoxicity. In this study, we tested the potency of differently functionalized copper oxide (CuO) NPs to enhance the antibacterial properties of Ag NPs. The antibacterial effect of the mixture of CuO NPs (CuO, CuO-NH2 and CuO-COOH NPs) with Ag NPs (uncoated and coated) was studied. CuO and Ag NP combinations were more efficient than Cu or Ag (NPs) alone against a wide range of bacteria, including antibiotic-resistant strains such as gram-negative Escherichia coli and Pseudomonas aeruginosa as well as gram-positive Staphylococcus aureus, Enterococcus faecalis and Streptococcus dysgalactiae. We showed that positively charged CuO NPs enhanced the antibacterial effect of Ag NPs up to 6 times. Notably, compared to the synergy of CuO and Ag NPs, the synergy of respective metal ions was low, suggesting that NP surface is required for the enhanced antibacterial effect. We also studied the mechanisms of synergy and showed that the production of Cu+ ions, faster dissolution of Ag+ from Ag NPs and lower binding of Ag+ by proteins of the incubation media in the presence of Cu2+ were the main mechanisms of the synergy. In summary, CuO and Ag NP combinations allowed increasing the antibacterial effect up to 6 times. Thus, using CuO and Ag NP combinations enables to retain excellent antibacterial effects due to Ag and synergy and enhances beneficial effects, since Cu is a vital microelement for human cells. Thus, we suggest using combinations of Ag and CuO NPs in antibacterial materials, such as wound care products, to increase the antibacterial effect of Ag, improve safety and prevent and cure topical bacterial infections.

Antibacterial and Antiviral Effects of Ag, Cu and Zn Metals, Respective Nanoparticles and Filter Materials Thereof against Coronavirus SARS-CoV-2 and Influenza A Virus.

Due to the high prevalence of infectious diseases and their concurrent outbreaks, there is a high interest in developing novel materials with antimicrobial properties. Antibacterial and antiviral properties of a range of metal-based nanoparticles (NPs) are a promising means to fight airborne diseases caused by viruses and bacteria. The aim of this study was to test antimicrobial metals and metal-based nanoparticles efficacy against three viruses, namely influenza A virus (H1N1; A/WSN/1933) and coronaviruses TGEV and SARS-CoV-2; and two bacteria, Escherichia coli and Staphylococcus aureus. The efficacy of ZnO, CuO, and Ag NPs and their respective metal salts, i.e., ZnSO4, CuSO4, and AgNO3, was evaluated in suspensions, and the compounds with the highest antiviral efficacy were chosen for incorporation into fibers of cellulose acetate (CA), using electrospinning to produce filter materials for face masks. Among the tested compounds, CuSO4 demonstrated the highest efficacy against influenza A virus and SARS-CoV-2 (1 h IC50 1.395 mg/L and 0.45 mg/L, respectively), followed by Zn salt and Ag salt. Therefore, Cu compounds were selected for incorporation into CA fibers to produce antiviral and antibacterial filter materials for face masks. CA fibers comprising CuSO4 decreased SARS-CoV-2 titer by 0.38 logarithms and influenza A virus titer by 1.08 logarithms after 5 min of contact; after 1 h of contact, SARS-COV-2 virus was completely inactivated. Developed CuO- and CuSO4-based filter materials also efficiently inactivated the bacteria Escherichia coli and Staphylococcus aureus. The metal NPs and respective metal salts were potent antibacterial and antiviral compounds that were successfully incorporated into the filter materials of face masks. New antibacterial and antiviral materials developed and characterized in this study are crucial in the context of the ongoing SARS-CoV-2 pandemic and beyond.

Cubic Iron Core-Shell Nanoparticles Functionalized to Obtain High-Performance MRI Contrast Agents.

Nanoparticles with SiO2 coating were synthesized to have a cubic iron core. These were found to have saturation magnetization very close to the highest possible value of any iron-containing nanoparticles and the bulk iron saturation magnetization. The in vitro toxicology studies show that they are highly biocompatible and possess better MRI contrast agent potential than iron oxide NPs.

Antimicrobial potency of differently coated 10 and 50 nm silver nanoparticles against clinically relevant bacteria Escherichia coli and Staphylococcus aureus.

Silver nanoparticles (nanoAg) are effective antimicrobials and promising alternatives to traditional antibiotics. This study aimed at evaluating potency of different nanoAg against healthcare infections associated bacteria: Gram-negative Escherichia coli and Gram-positive Staphylococcus aureus. A library of differently coated nanoAg of two different sizes (10 and 50 nm) were prepared using coating agents poly-L-Lysine (PLL), cetyltrimethyl-ammonium bromide (CTAB), citrate (CIT), polyvinyl-pyrrolidone (PVP), polysorbate 80 (Tween 80), and dioctyl-sodium sulfosuccinate (AOT). Stability evaluation by means of agglomeration and dissolution behaviour was performed for all nanoAg under conditions relevant for this study. Antibacterial properties of nanoAg were addressed by determining their minimal bactericidal concentrations (MBC) in deionised (DI) water to minimise the influence of silver speciation on its bioavailability. In parallel, AgNO3 was analysed as an ionic control. Studied nanoAg were efficient antimicrobials being remarkably more potent towards E. coli than to S. aureus (4 h MBC values for different nanoAg ranged from 0.08 to 5.0 mg Ag/L and 1.0-10 mg Ag/L, respectively). The toxicity of all nanoAg to S. aureus (but not to E. coli) increased with exposure time (4 h vs 24 h). 10 nm sized nanoAg released more Ag-ions and were more toxic than 50 nm nanoAg. Coating-dependent toxicity was more prominent for 50 nm nanoAg coated with Tween 80 or CTAB rendering the least toxic nanoAg. Obtained results showed that the antimicrobial effects of nanoAg were driven by shed Ag-ions, depended on target bacteria, exposure time and were the interplay of NP size, solubility and surface coating.

Antimicrobial Activity of Polyoxometalate Ionic Liquids against Clinically Relevant Pathogens.

The activity of a new class of antimicrobials-polyoxometalate ionic liquids (POM-ILs)-is systematically investigated. The prototype POM-ILs feature Keggin-type anions (α-SiW11 O39 8- ) and tetraalkylammonium ions as active cationic species. Antimicrobial tests of the POM-ILs against important human pathogens show that variation of the alkyl chain length of the cation leads to significant changes in antimicrobial activity against the medically relevant Gram-negative bacteria Escherichia coli and Pseudomonas aeruginosa, and especially against the Gram-positive Staphylococcus aureus. Owing to the unique materials properties of the POM-ILs, such as high viscosity and water immiscibility, applications of antimicrobial surface coatings against airborne pathogens or for water decontamination can be envisaged. Furthermore, the combination of antimicrobially active cations with POM anions might afford new POM-ILs with two active components.

Solubility-driven toxicity of CuO nanoparticles to Caco2 cells and Escherichia coli: Effect of sonication energy and test environment.

Due to small size and high surface energy nanoparticles (NPs) tend to agglomerate and precipitate. To avoid/diminish that, sonication of NPs stock suspensions prior toxicity testing is often applied. Currently, there is no standardized particle sonication protocol available leading to inconsistent toxicity data, especially if toxicity is driven by NPs' dissolution that may be enhanced by sonication. In this study we addressed the effect of sonication on hydrodynamic size (Dh), dissolution and toxicity of copper oxide (CuO) NPs to mammalian cell line Caco-2 in vitro and bacteria Escherichia coli in the respective test environments (cell culture MEM medium, bacterial LB medium and deionised (DI) water). NPs were suspended using no sonication, water bath and probe sonication with different energy intensities. Increased sonication energy (i) decreased the Dh of CuO NPs in all three test environments; (ii) increased dissolution of NPs in MEM medium and their toxicity to Caco-2; (iii) increased dissolution of NPs in LB medium and their bioavailability to E. coli; and (iv) had no effect on dissolution and antibacterial effects of NPs in DI water. Thus, to reduce variations in dissolution and toxicity, we recommend sonication of NPs in DI water following the dilution into suitable test media.

Antibodies to Lactobacilli and Bifidobacteria in young children with different propensity to develop islet autoimmunity.

The intestinal microbiota is essential to the maturation and homeostasis of the immune system. Immunoblot assays were used to establish the prevalence of serum IgG, IgM, and IgA antibodies specific for Bifidobacterium adolescentis, Bifidobacterium longum, and Lactobacillus rhamnosus GG proteins in young children presenting with or without type 1 diabetes (T1D). We demonstrated that children between the ages of 6 and 12 months had a substantial increase in the frequency of IgG antibodies specific for L. rhamnosus GG proteins. We measured IgG, IgM, and IgA class antibody reactivity against B. adolescentis DSM 20083, B. adolescentis DSM 20086, and B. longum DSM 20088 proteins demonstrating significantly higher IgA responses against B. adolescentis DSM 20083 strain proteins in children who developed islet autoimmunity and T1D later in life. B. adolescentis strains showed more IgM type antibodies in children who developed T1D later in life, but the difference was not statistically significant. B. longum proteins were recognized by IgG and IgA antibodies to a higher extent compared to other bacteria studied. These results confirm that differences in immune reactivity against some commensal strains in young children may represent a different risk factor for developing T1D.

Comparison of serum exosome isolation methods for microRNA profiling.

OBJECTIVES: Exosomes are small membrane bound vesicles secreted by most cell types. Exosomes contain various functional proteins, mRNAs and microRNAs (miRNAs) that could be used for diagnostic and therapeutic purposes. Currently, a standard method for serum exosome isolation is differential ultracentrifugation, but a search for alternative, less time-consuming and labour extensive exosomal isolation method for use in clinical settings is ongoing. The effect of serum exosome isolation method on obtained miRNA profile is not yet clear. The aim of this study was to determine to which extent selected exosome isolation methods influence the serum exosomal miRNA profile. DESIGN AND METHODS: Exosomes were isolated from blood serum of healthy individuals by ultracentrifugation and ExoQuick Precipitation methods. The expression profile of 375 miRNAs was determined by real time PCR using Exiqon miRCURY LNA™ microRNA Human panel I assays. RESULTS: Although a strong correlation of exosomal miRNA profiles was observed between the two isolation methods, distinct clusters of miRNA levels between the used methods were identified. The detected levels of two miRNAs, miR-92a and miR-486-5p, were significantly influenced by the exosome isolation method used. CONCLUSIONS: Both exosome isolation methods are suitable for serum exosomal miRNA profiling. Differences found in miRNA patterns between the two methods indicate that the observed exosomal miRNA profile is slightly affected by the extracellular vesicle isolation method.