Heat capacity of microgram oxide samples by fast scanning calorimetry.

Quantitative scanning calorimetry on microgram-sized samples opens a broad, new range of opportunities for studying the thermodynamic properties of quantity-limited materials, including those produced under extreme conditions or found as rare accessory minerals in nature. We calibrated the Mettler Toledo Flash DSC 2+ calorimeter to obtain quantitative heat capacities in the range 200-350 °C, using samples weighing between 2 and 11.5 µg. Our technique is applied to a new set of oxide materials to which it has never been used before, without the need for melting, glass transitions, or phase transformations. Heat capacity data were obtained for silica in the high pressure stishovite (rutile) structure, dense post-stishovite glass, standard fused quartz, and for TiO2 rutile. These heat capacities agree within 5%-15% with the literature values reported for rutile, stishovite, and fused SiO2 glass. The heat capacity of post-stishovite glass, made by heating stishovite to 1000 °C, is a newly reported value. After accurate calibrations, measured heat capacities were then used to calculate masses for samples in the microgram range, a substantial improvement over measurement in conventional microbalances, which have uncertainties approaching 50%-100% for such small samples. Since the typical uncertainty of heat capacities measured on 10-100 mg samples in conventional differential scanning calorimetry is typically 7% (1%-5% with careful work), flash differential scanning calorimetry, using samples a factor of 1000 smaller, increases the uncertainty of heat capacity measurements by a factor of <3, opening the door for meaningful measurements on ultra-small, high-pressure samples and other quantity-limited materials.

Hard x-ray methods for studying the structure of amorphous thin films and bulk glassy oxides.

High-energy photon diffraction minimizes many of the corrections associated with laboratory x-ray diffractometers, and enables structure factor measurements to be made over a wide range of momentum transfers. The method edges us closer toward an ideal experiment, in which coordination numbers can be extracted without knowledge of the sample density. Three case studies are presented that demonstrate new hard x-ray methods for studying the structure of glassy and amorphous materials. First, the methodology and analysis of high-energy grazing incidence on thin films is discussed for the case of amorphous In2O3. The connectivity of irregular InO6polyhedra are shown to exist in face-, edge- and corner-shared configurations in the approximate ratio of 1:2:3. Secondly, the technique of high-energy small and wide angle scattering has been carried out on laser heated and aerodynamically levitated samples of silica-rich barium silicate (20BaO:80SiO2), from the single phase melt at 1500oC to the phase separated glass at room temperature. Based on Ba-O coordination numbers of 6 to 7, it is argued that the although the potential of Ba is ionic, it is weak enough to cause the liquid-liquid immiscibility to become metastable. Lastly, high-energy small and wide angle scattering has also been applied to high water content (up to 12 wt.%) samples of hydrous SiO2glass quenched from 1500oC at 4 GPa. An increase of Si1-O2correlations at 4.3 Å is found to be consistent with an increase in the population of three-membered SiO4rings at the expense of larger rings.

Intermediate-range order in permanently densified GeO2 glass.

Information about the partial structure factors of densified GeO2 glass has been obtained from neutron and x-ray diffraction measurements. Densification causes a reduction in the length scale of the intermediate range order (IRO). The difference structure factors obtained by combining the x-ray and neutron data so as to eliminate one partial structure factor at a time shows the greatest effects when the Ge-Ge correlations are eliminated and least when O-O correlations are eliminated. This implies that the reduced length scale results from a decrease in the next-nearest neighbor Ge-O and O-O distance caused by a rotation about the Ge-O-Ge bonds and a distortion of the GeO4 tetrahedra.

High-pressure bulk synthesis of crystalline C(6)N(9)H(3).HCl: a novel c(3)n(4) graphitic derivative.

A novel carbon nitride compound, structurally related to the proposed graphitic phase of C(3)N(4), has been synthesized in a bulk well-crystallized form. The new material, with stoichiometry C(6)N(9)H(4)Cl, was prepared through a solid-state reaction of 2,4,6-triamino-1,3,5-triazine with 2,4,6-trichloro-1,3,5-triazine at 1.0-1.5 GPa and 500-550 degrees C and also through a self-reaction of 2-amino-4,6-dichloro-1,3,5-triazine at similar conditions. X-ray and electron diffraction measurements on the yellowish compound indicate a hexagonal space group (P6(3)/m) with cell parameters of a = 8.4379(10) A and c = 6.4296(2) A. This new compound possesses a two-dimensional C(6)N(9)H(3) framework that is structurally related to the hypothetical P6m2 graphitic phase of C(3)N(4), but with an ordered arrangement of C(3)N(3) voids. The large voids in the graphene sheets are occupied by chloride ions with an equivalent number of nitrogen atoms on the framework protonated for charge balance. The composition of the sample was determined by bulk chemical analysis and confirmed by electron energy loss (EELS) spectroscopy. The chemical and structural model is consistent with bulk density measurements and with the infrared and (13)C NMR spectra. This work represents the first bulk synthesis of a well-characterized and highly crystalline material containing a continuous network of alternating carbon and nitrogen atoms.