[Quantitative Detection of Iron in Soybean Oils with Laser Induced Breakdown Spectroscopy and Simple Regression Methods].

LIBS (laser-induced breakdown spectroscopy) was used to detect Fe element content in soybean oil quantitatively. In this experiment, a series of soybean oil samples with different concentrations of Fe were used; LIBS spectra were collected with a two-channel high precision spectrometer. According to the LIBS spectrum of samples, two characteristic wavelength of Fe (404.58 and 406.36 nm) were determined, and different simple regression methods (exponential regression, linear regression and quadratic regression) were used to establish the quantitative analysis models of Fe content using each characteristic spectral line. The results indicate that the average relative error of Fe I 404.58 and Fe I 406.36 in simple exponential regression, linear regression and quadratic regression models were 29.49%, 8.93%, 8.70% and 28.95%, 8.63%, 8.44%, respectively. The results of Fe I 406.36 regression models is better than that of Fe I 404.58, and the quadratic regression model is optimal among the three regression models. According to these results, LIBS technology has certain feasibility for detecting Fe in soybean oil; the quadratic linear regression model can improve the prediction accuracy of Fe element effectively.

Detection of Chromium Content in Soybean Oil by Laser Induced Breakdown Spectroscopy and UVE Method.

In order to monitor chromium (Cr) content in soybean oil, laser induced breakdown spectroscopy (LIBS) was used to detect Cr content in this research. Pine wood chips was used to enrich heavy metal of Cr, and the spectra of pine wood chips were acquired in the wavelength range of 206.28~481.77 nm by a two-channel high-precision spectrometer. Then, uninformative variable elimination (UVE) method was used to select sensitive wavelength variables for heavy metal of Cr, and calibration model of Cr in soybean oil was developed with partial least squares (PLS) regression, the performance of the calibration model was compared to univariate and full PLS calibration models. The results indicate that the performance of UVE-PLS calibration model is better than that of univariate and full PLS calibration models, the correlation coefficient, root mean square error of calibration (RMSEC), root mean square error of cross validation (RMSECV), root mean square error of prediction (RMSEP) are 0.990, 0.045 mg·g-1, 0.050 mg·g-1 and 0.054 mg·g-1, respectively. After UVE variable selection, the number of wavelength variables in UVE-PLS calibration model is about 2% of wavelength variables in full PLS calibration model. This means UVE is an effective variable selection method which can select correlative variables for heavy metal of Cr.

Optical waveguides in TiO2 formed by He ion implantation.

We report on the formation and the optical properties of the planar and ridge optical waveguides in rutile TiO2 crystal by He+ ion implantation combined with micro-fabrication technologies. Planar optical waveguides in TiO2 are fabricated by high-energy (2.8 MeV) He+-ion implantation with a dose of 3 × 10¹6 ions/cm² and triple low energies (450, 500, 550) keV He+-ion implantation with all fluences of 2 × 10¹6 ions/cm² at room temperature. The guided modes were measured by a modal 2010 prism coupler at wavelength of 1539 nm. There are damage profiles in ion-implanted waveguides by Rutherford backscattering (RBS)/channeling measurements. The refractive-index profile of the 2.8 MeV He+-implanted waveguide was analyzed based on RCM (Reflected Calculation Method). Also ridge waveguides were fabricated by femtosecond laser ablation on 2.8 MeV ion implanted planar waveguide and Ar ion beam etching on the basis of triple keV ion implanted planar waveguide, separately. The loss of the ridge waveguide was estimated. The measured near-field intensity distributions of the planar and ridge modes are all shown.

Analysis of Si+-implanted Nd:YVO4 crystal: the relation between lattice damage and waveguide formation.

We report the lattice damage and annealing properties of the 500 keV Si+ ions implanted Nd:YVO4 crystal with different doses. The Rutherford backscattering spectrometry/channeling technique was used to analyze the damage profiles of ion-implanted samples. A series of post-implant annealing was performed at temperatures from 250 °C to 400 °C to investigate the relation between lattice damage profile and the waveguide formation. Implantations at doses of more than 5×10(14) ions/cm2 can result in high damage ratio in the near-surface region and the lattice structure cannot be restored even after annealing at 400 °C. Such seriously damaged lattice is relatively stable and contributes to the waveguide structure. Convergence of the refractive index at the surface region after ion implantation is believed mainly due to the elastic collisions with the target atoms caused by nuclear energy loss.

Using two-step cluster analysis to classify inpatients with primary biliary cholangitis based on autoantibodies: A real-world retrospective study of 537 patients in China.

Background: A variety of autoantibodies have been detected in primary biliary cholangitis (PBC), while the presence of autoantibody clusters and their clinical significance have not been fully understood. We aimed at defining autoantibody clusters and to better understand the clinical features and prognosis of PBC patients based on autoantibody clusters under real-world conditions. Methods: We retrospectively analyzed 788 inpatients with PBC evaluated between October 2008 and July 2019, and included 537 patients. Nineteen autoantibodies which were measured routinely were investigated for cluster analysis. Two-step clustering, Kaplan-Meier survival, and Cox regression analyses were used. Results: Five clusters were defined. A cluster of antinuclear antibodies (ANA) and anti-gp210 positive patients were identified with a high rate of cirrhosis at baseline and low survival rate; a cluster of ANA, anti-centromere antibodies (ACA) and/or anti-CENP-B female dominant patients with older disease onset, low level of platelet count at baseline, high rate of hepatic decompensation, and low survival rate was also characterized; and another cluster of anti-mitochondrial antibodies (AMA) and/or AMA-M2, anti-Ro52 and a high rate of anti-gp210 positive patients were identified with a high proportion of male patients and low survival rate. A subgroup of patients with anti-SSA and/or anti-SSB coexists with SjS was also identified; patients with only AMA and/or AMA-M2-positive with a benign clinical outcome and relatively high complication of non-alcoholic fatty liver disease (NAFLD) were also identified. Only anti-gp210 was considered as a significant predictor for poor outcomes especially in patients with cirrhosis. Conclusion: Clustering methods allow the identification of distinct autoantibody profiles of PBC that form clinical subsets and can be useful for personalized approaches to diagnosis, clinical management, and the prediction of clinical outcomes. Anti-gp210 was the strongest predictive factor for poor outcomes especially in PBC patients with cirrhosis under real-world conditions.

Disease predisposition of human leukocyte antigen class II genes influences the gut microbiota composition in patients with primary biliary cholangitis.

Background: The human leukocyte antigen (HLA) susceptibility gene is the main genetic risk factor for primary biliary cholangitis (PBC). The prognosis of patients with PBC is linked to gut microbiota dysbiosis. However, whether the HLA alleles are associated with the gut microbiota distribution and disease severity remains unknown. Methods: A cohort of 964 Chinese patients with PBC was enrolled at Beijing YouAn Hospital, Beijing, China. High-resolution genotyping of the HLA class I and class II loci from 151 of these patients was performed using sequence-based PCR. Stool samples were collected from 43 of the 151 fully HLA-typed patients to analyze their microbiota compositions via 16S RNA gene sequencing. Results: Of the 964 patients, the male:female ratio was 114:850, and 342 of these patients (35.5%) had already developed liver cirrhosis (LC) before enrollment. Patients with PBC showed a significantly higher frequency of HLA DRB1*08:03 than did the controls (21.2% vs. 9.0%, P=0.0001). HLA-DRB1*03:01, DRB1*07:01, DRB1*14:05, and DRB1*14:54 frequencies were also increased but did not reach significance after Bonferroni's correction. Conversely, the DQB1*03:01 frequency was significantly lower in patients with PBC than in the controls (24.5% vs. 39.2%, P=0.0010). The patients' gut microbiota were analyzed from four perspectives. The microbial community abundances were significantly lower in FHRAC-positive patients (patients with a combination of five HLA DRB1 high-risk alleles) than in FHRAC-negative patients (P<0.05). Of the top 10 microbial genera, Lachnospiraceae_incertae_sedis was higher in the FHRAC-positive patients than in the FHRAC-negative patients (P<0.05). linear discriminant analysis (LDA) effect-size (LEfSe) analysis showed different microbes at different levels in the FHRAC-negative patients but not in the FHRAC-positive patients. DQB1*03:01-positive patients contained mostly Lactobacillaceae at the family level. A comparison of the FHRAC-positive patients with and without liver cirrhosis showed that the abundances of Veillonella were significantly higher in patients with cirrhosis and FHRAC than in those without cirrhosis and are FHRAC-negative. Conclusion: The HLA class II genes may influence the gut microbiota compositions in patients with PBC. Differential gut microbiota were expressed at different taxonomic levels. Some bacterial abundances may be increased in FHRAC-positive patients with PBC and cirrhosis.

Optical properties of a single mode planar waveguide in Nd:YVO4 fabricated by multienergy He ion implantation.

We fabricated a single-mode planar waveguide in z-cut Nd:YVO(4) by multienergy He ion implantation in total fluence of 4.5×10(16) ions/cm(2) at room temperature and investigated optical properties of Nd:YVO(4) before and after He ion implantation by measuring transmission, confocal microluminescence, and confocal Raman spectra. Absorption bands and the photoluminescence features of the bulk Nd:YVO(4) crystal have been preserved after He ion implantation. In Raman spectra, most of the peak positions and peak widths had no obvious change before and after He ion implantation. The guiding mode and near-field image in the waveguide were measured by the prism coupling method and end-face coupling method, respectively. We investigated the damage behavior of a Nd:YVO(4) waveguide after implantation, annealing treatment by the Rutherford backscattering/channeling technique. The minimum yield of the virgin z-cut Nd:YVO(4) was 1.98%, which increased to 4.73% after He ion implantation and decreased to 3.20% after annealing at 600 K for 30 minutes.

Planar and ridge waveguides formed in LiNbO3 by proton exchange combined with oxygen ion implantation.

We report on the fabrication of planar and ridge waveguides in lithium niobate by proton exchange combined with oxygen ion implantation. The implanted energy ranges from 600 to 1400 keV with a dose of 1 x 10(15) ions/cm(2). The modes in proton exchanged waveguide can be modulated by O ion implantation. There are different damage profiles in proton-exchanged and ion-implanted waveguides in Rutherford backscattering/channeling spectra. The refractive index profile in single-mode waveguide in lithium niobate has been obtained based on Intensity Calculation Method. Also ridge waveguide was fabricated on the basis of planar waveguide by Ar ion beam etching. The measured near-field intensity distributions of the ridge waveguide modes show a reasonable agreement with the simulated ones. The estimated propagation loss was approximately 2.2 dB/cm.

Self-assembled micellar aggregates based monomethoxyl poly(ethylene glycol)-b-poly(ε-caprolactone)-b-poly(aminoethyl methacrylate) triblock copolymers as efficient gene delivery vectors.

Amphiphilic triblock copolymers monomethoxyl poly(ethylene glycol) (mPEG)-b-poly(ε-caprolactone) (PCL)-b-poly(aminoethyl methacrylate)s (PAMAs) (mPECAs) were synthesized as gene delivery vectors. They exhibited lower cytotoxicity and higher transfection efficiency in COS-7 cells in presence of serum compared to 25 kDa bPEI. The influence of mPEG and PCL segments in mPECAs was evaluated by comparing with corresponding diblock copolymers. The studies showed the incorporation of the hydrophobic PCL segment in triblock copolymers affected the binding capability to pDNA and surface charges of complexes due to the formation of micelles increasing the local charges. The presence of mPEG segment in gene vector decreased the surface charges of the complexes and increased the stability of the complexes in serum because of the steric hindrance effect. It was also found that the combination of PEG and PCL segments into one macromolecule might lead to synergistic effect for better transfection efficiency in serum.

[Effect of Temperature on Performance and Microbial Community Structure of Anaerobic Biofilter-Treated Domestic Wastewater].

Municipal wastewater methanogenesis is one of the ways to utilize municipal wastewater resources.In this study, a biofilter used to treat actual municipal wastewater was employed to investigate the methanogenesis in a pilot-scale reactor. The method of rapid start-up, the influence of temperature on the reactor performance, and the changes in the microbial structure were investigated in the pilot-scale study. The rapid start-up of the biofilter reactor was achieved by the combination of intermittent and continuous operations. The effluent concentration of SCOD was 60 mg ·L-1at the stable operation stage. The biofilter was operated steadily at a temperature higher than 14℃, the accumulation of volatile fatty acids (VFA) was low, and the effluent concentrations of SCOD and TCOD were 69 mg ·L-1and 90 mg ·L-1, respectively. In addition, the metabolism of hydrolysis and methanogenesis tended to balance off under such conditions. However, the abundance of microorganisms that can hydrolyze organic matter and produce methane decreased. The abundance of Peptostreptococcaceae increased even the temperature was lower than 10℃, which typically increases VFA production. Therefore, the concentrations of effluent VFA and TCOD increased, but methane production decreased. The effluent concentration of SCOD was relatively stable. The microbial abundance and diversity were the richest at 19℃ in the reactor. The acetolactic methanogens were the dominant methanogens at low temperatures. The anaerobic biological filter for the treatment of urban sewage starts quickly and can resist the impact of continuous temperature reduction. Moreover, it does not need backwashing after running for nine months, and it is not easily clogged.Therefore,the functions of biological contact oxidation and filtration retention of the biological filter can be more fully utilized.