Persistence of Human Norovirus (GII) in Surface Water: Decay Rate Constants and Inactivation Mechanisms.

Human norovirus (HuNoV) is an important cause of acute gastroenteritis and can be transmitted by water exposures, but its persistence in water is not well understood. Loss of HuNoV infectivity in surface water was compared with persistence of intact HuNoV capsids and genome segments. Surface water from a freshwater creek was filter-sterilized, inoculated with HuNoV (GII.4) purified from stool, and incubated at 15 or 20 °C. We measured HuNoV infectivity via the human intestinal enteroid system and HuNoV persistence via reverse transcription-quantitative polymerase chain reaction assays without (genome segment persistence) or with (intact viral capsid persistence) enzymatic pretreatment to digest naked RNA. For infectious HuNoV, results ranged from no significant decay to a decay rate constant ("k") of 2.2 day-1. In one creek water sample, genome damage was likely a dominant inactivation mechanism. In other samples from the same creek, loss of HuNoV infectivity could not be attributed to genome damage or capsid cleavage. The range in k and the difference in the inactivation mechanism observed in water from the same site could not be explained, but variable constituents in the environmental matrix could have contributed. Thus, a single k may be insufficient for modeling virus inactivation in surface waters.

Plasmon-enabled degradation of organic micropollutants in water by visible-light illumination of Janus gold nanorods.

The development of sustainable methods for the degradation of pollutants in water is an ongoing critical challenge. Anthropogenic organic micropollutants such as pharmaceuticals, present in our water supplies in trace quantities, are currently not remediated by conventional treatment processes. Here, we report an initial demonstration of the oxidative degradation of organic micropollutants using specially designed nanoparticles and visible-wavelength sunlight. Gold "Janus" nanorods (Au JNRs), partially coated with silica to enhance their colloidal stability in aqueous solutions while also maintaining a partially uncoated Au surface to facilitate photocatalysis, were synthesized. Au JNRs were dispersed in an aqueous solution containing peroxydisulfate (PDS), where oxidative degradation of both simulant and actual organic micropollutants was observed. Photothermal heating, light-induced hot electron-driven charge transfer, and direct electron shuttling under dark conditions all contribute to the observed oxidation chemistry. This work not only provides an ideal platform for studying plasmonic photochemistry in aqueous medium but also opens the door for nanoengineered, solar-based methods to remediate recalcitrant micropollutants in water supplies.

Measuring temperature heterogeneities during solar-photothermal heating using quantum dot nanothermometry.

Small metallic nanoparticles with appropriate surface plasmon resonance frequencies can be extremely efficient absorbers of solar radiation. This efficient absorption can lead to localized heating and highly heterogeneous temperatures. These unique optical properties have inspired research into the development of environmentally relevant solar-to-heat conversion technologies that are based on the light absorption of nanomaterials. The development of robust, reliable, and straight-forward techniques for measuring spatially resolved temperatures in photothermally heated systems can be an indispensable tool to aid future work in this area. Herein, we consider the application of a fluorescent technique that can measure spatially resolved temperatures in solar photothermal systems using CdSe quantum dots (<10 nm diameter). The local temperature of the quantum dot can be determined by monitoring the shift in its fluorescence wavelength resulting from the dilatation of the lattice with increasing temperature. To exploit this property, we fabricated Au nanorod-quantum dot architectures using linkers of varying lengths, and measured the light induced temperature change increasing more rapidly closer to the surface of an Au nanorod. We also compared the effect of Au nanorod coatings and found that silica coating leads to higher overall temperatures compared to organic stabilized Au nanorods.

Sunlight Inactivation of Human Norovirus and Bacteriophage MS2 Using a Genome-Wide PCR-Based Approach and Enzyme Pretreatment.

Human norovirus (hNoV) is an important etiology of gastrointestinal illness and can be transmitted via ingestion of contaminated water. Currently impractical to culture, hNoV detection is reliant on real-time polymerase chain reaction (RT-PCR)-based methods. This approach cannot distinguish between infective and inactivated viruses because intact regions of the RNA genome can amplify even if the damage is present in other regions of the genome or because intact genetic material is not contained within an infectious virion. Herein, we employ a multiple long-amplicon RT-qPCR extrapolation approach to assay genome-wide damage and an enzymatic pretreatment to study the impact of simulated sunlight on the infectivity of hNoV in clear, sensitizer-free water. Using MS2 coliphage as an internal control, the genome-wide damage extrapolation approach, previously successfully applied for UV-254 inactivation, vastly overestimated sunlight inactivation, suggesting key differences in photoinactivation under different spectral conditions. hNoV genomic RNA was more susceptible to simulated sunlight degradation per base compared to MS2 genomic RNA, while enzymatic pretreatment indicated that hNoV experienced more capsid damage than MS2. This work provides practical and mechanistic insight into the endogenous sunlight inactivation of single-stranded RNA bacteriophage MS2, a widely used surrogate, and hNoV GII.4 Sydney, an important health-relevant virus, in clear sensitizer-free water.

SARS-CoV-2 RNA in Wastewater Settled Solids Is Associated with COVID-19 Cases in a Large Urban Sewershed.

Wastewater-based epidemiology may be useful for informing public health response to viral diseases like COVID-19 caused by SARS-CoV-2. We quantified SARS-CoV-2 RNA in wastewater influent and primary settled solids in two wastewater treatment plants to inform the preanalytical and analytical approaches and to assess whether influent or solids harbored more viral targets. The primary settled solids samples resulted in higher SARS-CoV-2 detection frequencies than the corresponding influent samples. Likewise, SARS-CoV-2 RNA was more readily detected in solids using one-step digital droplet (dd)RT-PCR than with two-step RT-QPCR and two-step ddRT-PCR, likely owing to reduced inhibition with the one-step ddRT-PCR assay. We subsequently analyzed a longitudinal time series of 89 settled solids samples from a single plant for SARS-CoV-2 RNA as well as coronavirus recovery (bovine coronavirus) and fecal strength (pepper mild mottle virus) controls. SARS-CoV-2 RNA targets N1 and N2 concentrations correlated positively and significantly with COVID-19 clinically confirmed case counts in the sewershed. Together, the results demonstrate that measuring SARS-CoV-2 RNA concentrations in settled solids may be a more sensitive approach than measuring SARS-CoV-2 in influent.

Water Disinfection in Rural Areas Demands Unconventional Solar Technologies.

Providing access to safe drinking water is a prerequisite for protecting public health. Vast improvements in drinking water quality have been witnessed during the last century, particularly in urban areas, thanks to the successful implementation of large, centralized water treatment plants and the distribution of treated water via underground networks of pipes. Nevertheless, infection by waterborne pathogens through the consumption of biologically unsafe drinking water remains one of the most significant causes of morbidity and mortality in developing rural areas. In these areas, the construction of centralized water treatment and distribution systems is impractical due to high capital costs and lack of existing infrastructure. Improving drinking water quality in developing rural areas demands a paradigm shift to unconventional, innovative water disinfection strategies that are low cost and simple to implement and maintain, while also requiring minimal infrastructure. The implementation of point-of-use (POU) disinfection techniques at the household- or community-scale is the most promising intervention strategy for producing immediate health benefits in the most vulnerable rural populations. Among POU techniques, solar-driven processes are considered particularly instrumental to this strategy, as developing rural areas that lack safe drinking water typically receive higher than average surface sunlight irradiation. Materials that can efficiently harvest sunlight to produce disinfecting agents are pivotal for surpassing the disinfection performance of conventional POU techniques. In this account, we highlight recent advances in materials and processes that can harness sunlight to disinfect water. We describe the physicochemical properties and molecular disinfection mechanisms for four categories of disinfectants that can be generated by harvesting sunlight: heat, germicidal UV radiation, strong oxidants, and mild oxidants. Our recent work in developing materials-based solar disinfection technologies is discussed in detail, with particular focus on the materials' mechanistic functions and their modes of action for inactivation of three common types of waterborne pathogens (i.e., bacteria, virus, and protozoa). We conclude that different solar disinfection technologies should be applied depending on the source water quality and target pathogen due to significant variations on susceptibility of microbial components to disparate disinfectants. In addition, we expect that ample research opportunities exist on reactor design and process engineering for scale-up and improved performance of these solar materials, while accounting for the infrastructure demand and capital input. Although the practical implementation of new treatment techniques will face social and economic challenges that cannot be overlooked, novel technologies such as these can play a pivotal role in reducing water borne disease burden in rural communities in the developing world.

Nanoparticle Enhanced Interfacial Solar Photothermal Water Disinfection Demonstrated in 3-D Printed Flow-Through Reactors.

Heat treatment, i.e., boiling or pasteurization, is the most widely recognized and practiced form of household water treatment. Considering recent advances in the development of light harvesting nanoparticles for solar-to-heat conversion, we envision that a nanomaterial enhanced water heating treatment system could obviate the need to use fuels or electricity to heat water by replacing the energy source with sunlight. In this study, we demonstrate that functional disinfection temperatures can be easily achieved with unconcentrated sunlight using a single layer interfacial photothermal film in direct contact with a tortuous flowing water channel. Photothermal films were fabricated by dispersing high concentrations of light harvesting nanoparticles, carbon black and Au nanorods, into a highly transparent curable polymer. Bench-scale 3-D printed reactors were employed to determine the effect of different parameters on reactor performance, such as channel height, retention time, flow rate, initial water temperature, and light intensity. Simulations demonstrate the scalability of the treatment system, predicting that a reactor footprint of 45 × 45 cm would be required for a photothermal treatment system that could produce 8 L of water per day with 8 h of sunlight at 1 Sun intensity.

The Technology Horizon for Photocatalytic Water Treatment: Sunrise or Sunset?

Advanced oxidation processes via semiconductor photocatalysis for water treatment have been the subject of extensive research over the past three decades, producing many scientific reports focused on elucidating mechanisms and enhancing kinetics for the treatment of contaminants in water. Many of these reports imply that the ultimate goal of the research is to apply photocatalysis in municipal water treatment operations. However, this ignores immense technology transfer problems, perpetuating a widening gap between academic advocation and industrial application. In this Feature, we undertake a critical examination of the trajectory of photocatalytic water treatment research, assessing the viability of proposed applications and identifying those with the most promising future. Several strategies are proposed for scientists and engineers who aim to support research efforts to bring industrially relevant photocatalytic water treatment processes to fruition. Although the reassessed potential may not live up to initial academic hype, an unfavorable assessment in some areas does not preclude the transfer of photocatalysis for water treatment to other niche applications as the technology retains substantive and unique benefits.

Dynamics of carbon substrate competition among heterotrophic microorganisms.

Growing evidence suggests that interactions among heterotrophic microorganisms influence the efficiency and rate of organic matter turnover. These interactions are dynamic and shaped by the composition and availability of resources in their surrounding environment. Heterotrophic microorganisms inhabiting marine environments often encounter fluctuations in the quality and quantity of carbon inputs, ranging from simple sugars to large, complex compounds. Here, we experimentally tested how the chemical complexity of carbon substrates affects competition and growth dynamics between two heterotrophic marine isolates. We tracked cell density using species-specific polymerase chain reaction (PCR) assays and measured rates of microbial CO2 production along with associated isotopic signatures (13C and 14C) to quantify the impact of these interactions on organic matter remineralization. The observed cell densities revealed substrate-driven interactions: one species exhibited a competitive advantage and quickly outgrew the other when incubated with a labile compound whereas both species seemed to coexist harmoniously in the presence of more complex organic matter. Rates of CO2 respiration revealed that coincubation of these isolates enhanced organic matter turnover, sometimes by nearly 2-fold, compared to their incubation as mono-cultures. Isotopic signatures of respired CO2 indicated that coincubation resulted in a greater remineralization of macromolecular organic matter. These results demonstrate that simple substrates promote competition whereas high substrate complexity reduces competitiveness and promotes the partitioning of degradative activities into distinct niches, facilitating coordinated utilization of the carbon pool. Taken together, this study yields new insight into how the quality of organic matter plays a pivotal role in determining microbial interactions within marine environments.

[2]Pseudorotaxanes, [2]rotaxanes and metal-organic rotaxane frameworks containing tetra-substituted dibenzo[24]crown-8 wheels.

[2]Pseudorotaxanes, [2]rotaxanes and metal-organic rotaxane framework materials that utilise DB24C8 as the wheel component are well known and structural variations based on changing the axle component are common. Studies in which the DB24C8 wheel is structurally modified are much more limited. Herein, is described the synthesis of symmetrical DB24C8 analogues containing four CH(2)OR (R = CH(2)CH(2)CH(3), CH(2)(C(6)H(5)), C(6)H(5) and C(6)H(4)(4-COOEt)) substituents on the 4 and 5 positions of the aromatic rings. The effect of these molecular appendages on the stability and structures of the interpenetrated and interlocked molecules derived from these new wheels is described. The major effects are an increase in association constants for the formation of [2]pseudorotaxanes relative to DB24C8, the crystal packing of [2]rotaxanes and a change on the internal structure of a 2D MORF (R = C(6)H(5)) compared to DB24C8.