RESUMEN
Mode-locking of single-section Fabry-Pérot InAs/InP edge emitting quantum dash based lasers at 1.56 µm under continuous wave operation is studied by second-harmonic generation frequency resolved optical gating. Self-starting pulses of a width down to 374 fs can be observed after external chirp compensation using standard single-mode fiber (SMF-28). Pulse compression using different lengths of SMF-28 and pulse shape as well as phase dependence on bias conditions are investigated. Consistency with stepped-heterodyne technique for advanced pulse characterization is shown.
RESUMEN
Here we report for the first time a passive mode-locking of single section Fabry-Perot (FP) lasers based on InAs quantum dots(QDs) grown on (113)B InP substrate. Devices under study are a 1 and 2 mm long laser diodes emitting around 1.58 µm. Self-starting pulses with repetition rates around 23 and 39 GHz and pulse widths down to 1.5 ps are observed after propagation through a suitable length of single-mode fiber for intracavity dispersion compensation. A RF spectral width as low as 20 kHz has been obtained leading to a low timing jitter RMS.
RESUMEN
Mode locking features of single section quantum dash based lasers are investigated. Particular interest is given to the static spectral phase profile determining the shape of the mode locked pulses. The phase profile dependence on cavity length and injection current is experimentally evaluated, demonstrating the possibility of efficiently using the wide spectral bandwidth exhibited by these quantum dash structures for the generation of high peak power sub-picosecond pulses with low radio frequency linewidths.
RESUMEN
We report for the first time on the systematic measurement of timing jitter of 40-GHz self-pulsating Fabry-Perot laser based on InAs/InP quantum dashes emitting at 1.55 microm. Two different methods, one based on optical cross-correlation and one on electrical spectrum sideband integration are used and show a good agreement, yielding a jitter of 0.86 ps in the 1 MHz---20 MHz frequency range with a potential of 280 fs for optimized driving conditions. Amplitude noise and high-frequency timing jitter contributions are also discussed.
RESUMEN
We report on subpicosecond pulse generation using passively mode locked lasers (MLL) based on a low optical confinement single InGaAsP/InP quantum well active layer grown in one epitaxial step. Systematic investigation of the performances of two-section MLLs emitting at 1.54 microm evidenced pulse width of 860 fs at 21.31 GHz repetition rate, peak power of approximately 500 mW and a time-bandwith product of 0.57. A 30 kHz linewidth of the photodetected radio-frequency electrical spectrum is further demonstrated at 21 GHz which is, to our knowledge, the lowest value ever reported for a quantum well device.
RESUMEN
Optical feedback tolerance is experimentally investigated on a 600-mum-long quantum-dash based Fabry-Pérot laser emitting at 1.57mum. While quantum-dashes are structurally intermediate to quantum-wells and quantum-dots, the observed behaviour is distinctly like that of a quantum-well based laser but with greater stability. Coherence collapse and low-frequency fluctuation regimes are observed and are reported here. The onset of the coherence collapse regime is experimentally determined and is found to vary from -29 dB to -21 dB external feedback level when increasing the current from twice to nine times the threshold current.
RESUMEN
We apply a novel phase-amplitude characterization method to a one-section quantum dash-based passively mode-locked laser at a 42.2 GHz repetition rate. The method relies on the measurement of the spectral phase of the longitudinal modes by the successive analysis of the correlation signal of a group of three adjacent modes. It provides both the temporal shape of the intensity and the phase of the emitted signal. A pulse of 1.5 ps of width is measured, and a pedestal is exhibited. Extinction ratio limitation is explained by investigating the origin of this pedestal. The accuracy of the method is estimated by comparing the measured autocorrelation signal and the calculated one from the phase analysis.