RESUMEN
Biomimetic membranes assembled from block copolymers attract considerable interest because they exhibit greater stability and longetivity compared to lipid bilayers, and some enable the reconstitution of functional transmembrane biomolecules. Yet to-date, block copolymer membranes have not been achieved using the droplet interface bilayer (DIB) method, which uniquely allows assembling single- and multi-membrane networks between water droplets in oil. Herein, we investigate the formation of poly(ethylene oxide)-b-poly(dimethyl siloxane)-b-poly(ethylene oxide) triblock copolymer-stabilized interfaces (CSIs) between polymer-coated aqueous droplets in solutions comprising combinations of decane, hexadecane and AR20 silicone oil. We demonstrate that triblock-coated droplets do not spontaneously adhere in these oils because all are thermodynamically good solvents for the hydrophobic PDMS middle block. However, thinned planar membranes are reversibly formed at the interface between droplets upon the application of a sufficient transmembrane voltage, which removes excess solvent from between droplets through electrocompression. At applied voltages above the threshold required to initiate membrane thinning, electrowetting causes the area of the CSI between droplets to increase while thickness remains constant; the CSI electrowetting response is similar to that encountered with lipid-based DIBs. In combination, these results reveal that stable membranes can be assembled in a manner that is completely reversible when an external pressure is used to overcome a barrier to adhesion caused by solvent-chain interactions, and they demonstrate new capability for connecting and disconnecting aqueous droplets via polymer-stabilized membranes.
Asunto(s)
Materiales Biomiméticos , Membranas Artificiales , Solventes , Membrana Dobles de Lípidos , Aceites , AguaRESUMEN
The ability to widely tune the design of macromolecular bottlebrushes provides access to self-assembled nanostructures formed by microphase segregation in melt, thin film and solution that depart from structures adopted by simple linear copolymers. A series of random bottlebrush copolymers containing poly(3-hexylthiophene) (P3HT) and poly(d,l-lactide) (PLA) side chains grafted on a poly(norbornene) backbone were synthesized via ring-opening metathesis polymerization (ROMP) using the grafting through approach. P3HT side chains induce a physical aggregation of the bottlebrush copolymers upon solvent removal by vacuum drying, primarily driven by attractive π-π interactions; however, the amount of aggregation can be controlled by adjusting side chain composition or by adding linear P3HT chains to the bottlebrush copolymers. Coarse-grained molecular dynamics simulations reveal that linear P3HT chains preferentially associate with P3HT side chains of bottlebrush copolymers, which tends to reduce the aggregation. The nanoscale morphology of microphase segregated thin films created by casting P3HT-PLA random bottlebrush copolymers is highly dependent on the composition of P3HT and PLA side chains, while domain spacing of nanostructures is mainly determined by the length of the side chains. The selective removal of PLA side chains under alkaline conditions generates nanoporous P3HT structures that can be tuned by manipulating molecular design of the bottlebrush scaffold, which is affected by molecular weight and grafting density of the side chains, and their sequence. The ability to exploit the unusual architecture of bottlebrushes to fabricate tunable nanoporous P3HT thin film structures may be a useful way to design templates for optoelectronic applications or membranes for separations.