Dermato-cosmeceutical properties of Pseudobombax ellipticum (Kunth) Dugand: Chemical profiling, in vitro and in silico studies.

Plant extracts and their individual components have been used to manage skin aging for several decades. Recently, the discovery of new natural bioactive agents, that not only enhance the skin health but also offer protection against various deleterious factors, such as free radicals, ultraviolet radiation, and microbial infections, has been a potential target by many researchers. The aim of the current work was to investigate the phytochemical profile of an ethanol bark extract from Pseudobombax ellipticum, and to evaluate its antioxidant, antiaging and antibacterial activities in vitro. Molecular docking and molecular dynamics studies were adopted to estimate and confirm the binding affinity of several compounds and explain their binding pattern at the binding sites of four target enzymes associated with skin aging, namely collagenase, elastase, tyrosinase, and hyaluronidase. HPLC-MS/MS analysis led to the tentative identification of 35 compounds comprising phenolic acids, and their glycosides, procyanidins and flavonoid glycosides. The extract demonstrated a promising in vitro antioxidant activity in the DPPH and FRAP assays (IC50 56.45 and 15.34 µg/mL, respectively), and was able to inhibit the aforementioned key enzymes with comparable results to the reference drugs. In addition, the extract (6.25 mg/mL) inhibited the biofilm production of Pseudomonas aeruginosa and diminished the swimming and swarming motilities. The docked compounds revealed appreciable binding energy with the tested enzymes and were stable throughout the molecular dynamic simulations. In view of this data, P. ellipticum bark can be regarded as a good candidate for prospective application in derma-cosmeceutical preparations.

Cytotoxicity Activity of Graviola Fruit Extract with Carbamazepine and Valproic Acid Show Antagonistic and Indifferent Effects.

OBJECTIVE: Graviola is a tropical fruit with medicinal properties, used for treating various diseases such as inflammation, diabetes, and cancer. Histone deacetylase inhibitors (HDACIs), including carbamazepine (CBZ) and valproic acid (VPA), have been proven strong inhibitors against cancer cell growth. This study investigated the effect of Graviola fruit extract (GFE) on CBZ in healthy rat plasma using high-performance liquid chromatography (HPLC). In addition, the effect of GFE in combination with CBZ and VPA on two human cancer cell lines (PC3 and MCF-7) was explored. METHODS: The CBZ levels were analyzed using a simple validated HPLC method. The linearity was achieved at a 0.9998 coefficient of determination over a range of 75-5000 ng/mL CBZ. The MTT assay was used to quantify the percentage of viable cells. RESULT: The maximum plasma concentration (Cmax) and area under the curve (AUC) for CBZ alone were 4,631 ng/mL and 49,225 ng. h/mL, respectively. However, in the presence of GFE, the values reduced significantly to 2,994 ng/mL and 26,587 ng. h/mL, while the p-value was <0.05. The 3-(4,5-dimethylthiazolyl-2)-2, 5-diphenyltetrazolium bromide (MTT) assay results for VPA showed a weak cytotoxicity activity on PC3 and MCF-7 cell lines. CONCLUSION: A simple and validated HPLC method was used to determine CBZ levels in rats' plasma. The plasma CBZ levels (Cmax) were significantly reduced in the presence of GFE, indicating the importance of drug-herb interactions. For in vitro studies, two human cancer cell lines, MCF-7 (breast cancer cells) and PC3 (prostate cancer cells), were used to screen the cytotoxicity activity of GFE, CBZ, and VPA. We observed an antagonism effect for GFE and CBZ combination in both cell lines with FIC values > 4. On the contrary, the combination of GFE and VPA showed an additive or indifferent effect.

BTEX indoor air characteristic values in rural areas of Jordan: Heaters and health risk assessment consequences in winter season.

Benzene, toluene, ethylbenzene, and xylene isomers (BTEX) are known to affect environmental air and health quality. In this study, the levels of BTEX compounds were determined in indoor air environments during the winter generated by several different heaters: diesel pot-bellied heater with chimney (DH); electric heater (EH); unfluted gas heater (GH); kerosene heater (KH); and wood pot-bellied heater with chimney (WH). The samples were collected using a diffusion passive adsorbent (activated charcoal) and then analyzed by gas chromatography-mass spectrometry (GC-MS). The results showed that the heaters differ in the quantity of BTEX released during operation. The KH was the most polluted heater based on BTEX measurement, followed by DH. The ∑BTEX for heaters were observed as follows: KH (290 µg m-3); DH (120 µg m-3); GH (84 µg m-3); WH (31 µg m-3); EH (16 µg m-3). Toluene was the predominant compound in all air samples. In KH and DH, the toluene to benzene ratios (T/B) were higher than 4 due to fuel evaporation, while GH had a T/B ratio of 3.9, indicating that the combustion of liquefied petroleum gas (LPG) was the main source. Moreover, a risk assessment was performed to evaluate where the cancer risks (CR) for benzene and ethylbenzene exceeded the critical values (10-6). KH was found to be the most harmful heater for residents, followed by DH and GH. For non-carcinogenic compounds, hazard quotients (HQ) were found to be less than one and thus unlikely to cause health problems.

A single-step extraction method for the determination of nicotine and cotinine in Jordanian smokers' blood and urine samples by RP-HPLC and GC-MS.

A simple, rapid, reliable, and low cost one-step extraction method is developed and validated for the determination of nicotine and cotinine in human plasma and urine in smokers using reversed-phase high-performance liquid chromatography (RP-HPLC) and gas chromatography-mass spectrometry (GC-MS). The run times are 16 and 10 min for HPLC and GC-MS, respectively. The method is validated over a wide linear range of 1-5000 ng/mL with correlation coefficients being consistently greater than 0.9985. The criteria considered for validation are: limit of quantitation, linearity, accuracy, precision, recovery, specificity, and selectivity. This study is aimed to estimate the nicotine and cotinine in Jordanian smokers' blood and urine samples; to study the relationship between the concentration of nicotine in urine and plasma samples; and to investigate the effect of pH on the extraction of nicotine and cotinine in urine samples. In the presented study, one hundred blood and urine samples are collected from eighty smokers and twenty nonsmokers. Samples are taken from the same volunteer at the same time after each volunteer fills in a questionnaire. Results of nicotine concentrations in smokers' plasma are in the range of 181-3702 ng/mL with an average of 1263.1 ng/mL, whereas nicotine in urine samples is in the range of 1364-1972 ng/mL, with an average of 1618 ng/mL. Cotinine concentrations in smokers' plasma are in the range of 21-4420 ng/mL with an average of 379.4 ng/mL, whereas cotinine in urine is in the range of 6-3946 ng/mL with an average of 865 ng/mL. Statistical analysis indicates highly significant differences in nicotine and cotinine concentrations in smoker samples compared with nonsmoker samples (p<0.05).

A simple one-pot dehydration process to convert N-acetyl-D-glucosamine into a nitrogen-containing compound, 3-acetamido-5-acetylfuran.

An efficient process for converting N-acetyglucosamine (NAG) into 3-acetamido-5-acetylfuran (3A5AF) is reported. 3A5AF is proposed as an N-containing platform chemical, which contains renewable nitrogen. In the reported method NAG, in the presence of boric acid (B(OH)3) and sodium chloride (NaCl), produces 58 % yield 3A5AF in dimethylacetamide under microwave irradiation (220 °C, 15 min). A maximum yield of 62 % was obtained in the presence of 4 equivalent NaCl. Performing ICP-MS analysis on NAG from different chemical suppliers highlighted the importance of Cl and B levels in this process. Trace impurities are, therefore, important considerations in biomass transformations. This solution-phase process produces approximately 30 times more 3A5AF than a pyrolysis route reported previously.