RESUMEN
Compared to quantum well (QW) lasers, lower dimensional quantum dot (QD) or quantum dash (QDash) devices demonstrate superior performances, owing to their quantized energy levels and increased carrier confinement. Here, we report the systematic comparison of static and dynamic properties of long wavelength (1550 nm) QDash and QW lasers. For the QDash lasers, a higher maximum operating temperature and lower temperature dependence was achieved for long cavities, although the threshold current densities were larger than the QW reference devices. The lasing characteristics for QDashes are significantly improved following the application of a high reflectance (HR) coating on the rear facets. The QDash lasers also exhibit three orders lower dark current, of 45 µA/cm2 under -1 V reverse bias. Small signal modulation on the 4 × 550 µm2 Fabry-Perot cavities yields a modulation efficiency of 0.48 GHz/âmA and a maximum 3-dB bandwidth of 7.4 GHz for QDashes, slightly larger than that for the QW devices. Meanwhile, a stronger damping effect was observed for the QDash lasers due to their lower differential gain.
RESUMEN
We demonstrate a simple method to fabricate efficient, electrically driven, polarized, and phosphor-free white semipolar (20-21) InGaN light-emitting diodes (LEDs) by adopting a top blue quantum well (QW) and a bottom yellow QW directly grown on (20-21) semipolar bulk GaN substrate. At an injection current of 20 mA, the fabricated 0.1 mm2 size regular LEDs show an output power of 0.9 mW tested on wafer without any backside roughing, a forward voltage of 3.1 V and two emission peaks located at 427 and 560 nm. A high polarization ratio of 0.40 was measured in the semipolar monolithic white LEDs, making them promising candidates for backlighting sources in liquid crystal displays (LCDs). Furthermore, a 3dB modulation bandwidth of 410 MHz in visible light communication (VLC) was obtained in the micro-size LEDs (µLEDs) with a size of 20×20 µm2 and 40×40 µm2, which could overcome the limitation of slow frequency response of yellow phosphor in commercial white LEDs combing blue LEDs and yellow phosphor.
RESUMEN
The next generation of radar (radio detection and ranging) systems needs to be based on software-defined radio to adapt to variable environments, with higher carrier frequencies for smaller antennas and broadened bandwidth for increased resolution. Today's digital microwave components (synthesizers and analogue-to-digital converters) suffer from limited bandwidth with high noise at increasing frequencies, so that fully digital radar systems can work up to only a few gigahertz, and noisy analogue up- and downconversions are necessary for higher frequencies. In contrast, photonics provide high precision and ultrawide bandwidth, allowing both the flexible generation of extremely stable radio-frequency signals with arbitrary waveforms up to millimetre waves, and the detection of such signals and their precise direct digitization without downconversion. Until now, the photonics-based generation and detection of radio-frequency signals have been studied separately and have not been tested in a radar system. Here we present the development and the field trial results of a fully photonics-based coherent radar demonstrator carried out within the project PHODIR. The proposed architecture exploits a single pulsed laser for generating tunable radar signals and receiving their echoes, avoiding radio-frequency up- and downconversion and guaranteeing both the software-defined approach and high resolution. Its performance exceeds state-of-the-art electronics at carrier frequencies above two gigahertz, and the detection of non-cooperating aeroplanes confirms the effectiveness and expected precision of the system.
RESUMEN
Here we demonstrate an 8x4 multi-wavelength selective ring resonator based crossbar switch matrix implemented in a 220-nm silicon photonics foundry for interconnecting electronic packet switches in scalable data centers. This switch design can dynamically assign up to two wavelength channels for any port-port connection, providing almost full connectivity with significant reduction in latency, cost and complexity. The switch unit cell insertion loss was measured at 0.8 dB, with an out-of-band rejection of 32 dB at 400 GHz channel separation. All the ring resonator heaters were thermally tuned, with heaters controlled by a custom 64-channel DAC driver. Detailed measurements on the whole switch showed standard deviation of 2 dB in losses across different paths, standard deviation of 0.33 nm in resonant wavelength and standard deviation of 0.01 nm/mW in ring heater tuning efficiency. Data transmission experiments at 40 Gbps showed negligible penalty due to crosstalk paths through the switch.
RESUMEN
An indium phosphide (InP)-based photonic integrated circuit (PIC) transmitter for free space optical communications was demonstrated. The transmitter consists of a sampled grating distributed Bragg reflector (SGDBR) laser, a high-speed semiconductor optical amplifier (SOA), a Mach-Zehnder modulator, and a high-power output booster SOA. The SGDBR laser tunes from 1521 nm to 1565 nm with >45 dB side mode suppression ratio. The InP PIC was also incorporated into a free space optical link to demonstrate the potential for low cost, size, weight and power. Error-free operation was achieved at 3 Gbps for an equivalent link length of 180 m (up to 300 m with forward error correction).
RESUMEN
An innovative and effective architecture for lidar systems is presented and experimentally demonstrated. The proposed scheme can also be easily exploited for optical communications. In particular, the system includes an innovative lidar software-defined architecture based on optically coherent detection, overcoming current drawbacks of time of flight incoherent systems. The experiments demonstrate the ability to perform long range detection resorting to the waveform compression on the continuous wave approach, obtaining a range resolution of 15 cm with a sensitivity of -95 dBm. Beside the bulk implementation, the system has been also implemented in a photonic integrated circuit using complementary metal-oxide-semiconductor-compatible silicon on insulator technology with an extremely reduced footprint of 1.5 mm×3.5 mm. The testing of the integrated device confirms the effectiveness of this proof-of-concept realization.
RESUMEN
We propose and demonstrate a technique for the generation of an optical comb with tunable line spacing in a periodically poled lithium niobate (PPLN) waveguide. The technique is implemented with four input continuous waves (CWs), which generate a 19-line comb tuned to the spacing of 25 and 20 GHz. We show that each additional CW switched on out of the quasi phase-matching band at the PPLN waveguide input generates the growth of six new lines. The performance of the comb is tested modulating the lines with a 40 Gb/s differential quadrature phase shift keying data, demonstrating error-free operation. Nonuniform spacing of the input seed CWs improves the efficiency of the line generation process.
RESUMEN
We propose and demonstrate a technique for the generation of a coherent optical comb, with tunable line spacing in a periodically poled lithium niobate (PPLN) waveguide. A single continuous wave laser is modulated to generate three phase-locked seed lines, which are injected into a PPLN waveguide, to obtain line multiplication. The line spacing is set acting on the frequency of the electrical signal driving the modulator. The quality of the comb is verified measuring the autocorrelation, the phase noise, and the linewidth of the generated lines. With the same scheme, we demonstrate optical multicasting. From a single quadrature phase shift keying signal, modulated at 12.5 and 25 GBaud, five replicas are generated, with spacing 25 and 37.5 GHz. The performance of each signal replica is measured after transmission through 80 km of a single-mode fiber, demonstrating operation with a bit error rate value lower than the forward error correction threshold.
RESUMEN
As the improvement of radar systems claims for digital approaches, photonics is becoming a solution for software defined high frequency and high stability signal generation. We report on our recent activities on the photonic generation of flexible wideband RF signals, extending the proposed architecture to the independent optical beamforming of multiple signals. The scheme has been tested generating two wideband signals at 10 GHz and 40 GHz, and controlling their independent delays at two antenna elements. Thanks to the multiple functionalities, the proposed scheme allows to improve the effectiveness of the photonic approach, reducing its cost and allowing flexibility, extremely wide bandwidth, and high stability.
RESUMEN
We propose and characterize a simple, integrable, and wavelength-preserving scheme able to groom a 40 Gbps (D)QPSK signal with a 20 Gbps OOK one into a 20 Gbaud (60 Gbps) 8-APSK signal. The proposed all-optical scheme is based on the second-order nonlinear signal-depletion effect in a single periodically poled lithium niobate (PPLN) waveguide. Performance of the device, characterized by means of BER measurements, attests error-free operation and a power penalty below 4.1 dB.