Characterisation of 40 mg/ml and 100 mg/ml tobramycin formulations for aerosol therapy with adult mechanical ventilation.

BACKGROUND: Preservative-free tobramycin is commonly used as aerosolized therapy for ventilator associated pneumonia. The comparative delivery profile of the formulations of two different concentrations (100 mg/ml and 40 mg/ml) is unknown. This study aims to evaluate the aerosol characteristics of these tobramycin formulations in a simulated adult mechanical ventilation model. METHODS: Simulated adult mechanical ventilation set up and optimal settings were used in the study. Inhaled mass study was performed using bacterial/viral filters at the tip of the tracheal tube and in the expiratory limb of circuit. Laser diffractometer was used for characterising particle size distribution. The physicochemical characteristics of the formulations were described and nebulization characteristics compared using two airways, an endotracheal tube (ET) and a tracheostomy tube (TT). For each type of tube, three internal tube diameters were studied, 7 mm, 8 mm and 9 mm. RESULTS: The lung dose was significantly higher for 100 mg/ml solution (mean 121.3 mg vs 41.3 mg). Viscosity was different (2.11cp vs 1.58cp) for 100 mg/ml vs 40 mg/ml respectively but surface tension was similar. For tobramycin 100 mg/ml vs 40 mg/ml, the volume median diameter (2.02 vs 1.9 µm) was comparable. The fine particle fraction (98.5 vs 85.4%) was higher and geometric standard deviation (1.36 vs 1.62 µm) was significantly lower for 100 mg/ml concentration. Nebulization duration was longer for 100 mg/ml solution (16.9 vs 10.1 min). The inhaled dose percent was similar (30%) but the exhaled dose was higher for 100 mg/ml solution (18.9 vs 10.4%). The differences in results were non-significant for type of tube or size except for a small but statistically significant reduction in inhaled mass with TT compared to ET (0.06%). CONCLUSION: Aerosolized tobramycin 100 mg/ml solution delivered higher lung dose compared to tobramycin 40 mg/ml solution. Tracheal tube type or size did not influence the aerosol characteristics and delivery parameters.

Albuminated Glycoenzymes: Enzyme Stabilization through Orthogonal Attachment of a Single-Layered Protein Shell around a Central Glycoenzyme Core.

Here we demonstrate an approach to stabilize enzymes through the orthogonal covalent attachment of albumin on the single-enzyme level. Albuminated glycoenzymes (AGs) based upon glucose oxidase and catalase from Aspergillus niger were prepared in this manner. Gel filtration chromatography and dynamic light scattering support modification, with an increase in hydrodynamic radius of ca. 60% upon albumination. Both AGs demonstrate a marked resistance to aggregation during heating to 90 °C, but this effect is more profound in albuminated catalase. The functional characteristics of albuminated glucose oxidase vary considerably with exposure type. The AG's thermal inactivation is reduced more than 25 times compared to native glucose oxidase, and moderate stabilization is observed with one month storage at 37 °C. However, albumination has no effect on operational stability of glucose oxidase.

The paradox of artificial sweeteners in managing obesity.

The role of artificial sweeteners in the management of obesity is controversial. Observational data have suggested that nonnutritive sweeteners (NNSs) may promote weight gain through poorly understood mechanisms of cravings, reward phenomenon, and addictive behavior via opioid receptors. Interventional studies suggest the opposite that substitution of NNS for sugar-sweetened beverages (SSBs) results in reduced caloric intake and modest degrees of weight loss. Whether the use of NNS provides benefit toward weight reduction in the individual patient may depend on the characteristics of their baseline diet, associated changes, or dietary compensation involved with ingestion of NNS, and the degree of compliance with a more complete weight loss program.

Preclinical Evaluation of Poly(HEMA-co-acrylamide) Hydrogels Encapsulating Glucose Oxidase and Palladium Benzoporphyrin as Fully Implantable Glucose Sensors.

BACKGROUND: Continuous glucose monitors (CGMs) require percutaneous wire probes to monitor glucose. Sensors based on luminescent hydrogels are being explored as fully implantable alternatives to traditional CGMs. Our previous work investigated hydrogel matrices functionalized with enzymes and oxygen-quenched phosphors, demonstrating sensitivity to glucose, range of response, and biofouling strongly depend on the matrix material. Here, we further investigate the effect of matrix composition on overall performance in vitro and in vivo. METHODS: Sensors based on three hydrogels, a poly(2-hydroxyethyl methacrylate) (pHEMA) homopolymer and 2 poly(2-hydroxyethyl methacrylate-co-acrylamide) (pHEMA-co-AAm) copolymers, were compared. These were used to entrap glucose oxidase (GOx), catalase, and an oxygen-sensitive benzoporphyrin phosphor. All sensor formulations were evaluated for glucose response and stability at physiological temperatures. Selected sensors were then evaluated as implanted sensors in a porcine model challenged with glucose and insulin. The animal protocol used in this study was approved by an IACUC committee at Texas A&M University. RESULTS: PHEMA-co-AAm copolymer hydrogels (75:25 HEMA:AAm) yielded the most even GOx and dye dispersion throughout the hydrogel matrix and best preserved GOx apparent activity. In response to in vitro glucose challenges, this formulation exhibited a dynamic range of 12-167 mg/dL, a sensitivity of 1.44 ± 0.46 µs/(mg/dL), and tracked closely with reference capillary blood glucose values in vivo. CONCLUSIONS: The hydrogel-based sensors exhibited excellent sensitivity and sufficiently rapid response to the glucose levels achieved in vivo, proving feasibility of these materials for use in real-time glucose tracking. Extending the dynamic range and assessing long-term effects in vivo are ongoing efforts.

Endoscopic therapy for acute recurrent pancreatitis.

Endoscopy plays an important role in both the diagnosis and the initial management of recurrent acute pancreatitis, as well as the investigation of refractory disease, but it has known limitations and risks. Sound selective use of these therapies, complemented with other lines of investigation such as genetic testing, can dramatically improve frequency of attacks and associated quality of life. Whether endoscopic therapy can reduce progression to chronic pancreatitis, or reduce the risk of malignancy, is debatable, and remains to be proven.

Glycosylation site-targeted PEGylation of glucose oxidase retains native enzymatic activity.

Targeted PEGylation of glucose oxidase at its glycosylation sites was investigated to determine the effect on enzymatic activity, as well as the bioconjugate's potential in an optical biosensing assay. Methoxy-poly(ethylene glycol)-hydrazide (4.5kDa) was covalently coupled to periodate-oxidized glycosylation sites of glucose oxidase from Aspergillus niger. The bioconjugate was characterized using gel electrophoresis, liquid chromatography, mass spectrometry, and dynamic light scattering. Gel electrophoresis data showed that the PEGylation protocol resulted in a drastic increase (ca. 100kDa) in the apparent molecular mass of the protein subunit, with complete conversion to the bioconjugate; liquid chromatography data corroborated this large increase in molecular size. Mass spectrometry data proved that the extent of PEGylation was six poly(ethylene glycol) chains per glucose oxidase dimer. Dynamic light scattering data indicated the absence of higher-order oligomers in the PEGylated GOx sample. To assess stability, enzymatic activity assays were performed in triplicate at multiple time points over the course of 29 days in the absence of glucose, as well as before and after exposure to 5% w/v glucose for 24h. At a confidence level of 95%, the bioconjugate's performance was statistically equivalent to native glucose oxidase in terms of activity retention over the 29 day time period, as well as following the 24h glucose exposure. Finally, the bioconjugate was entrapped within a poly(2-hydroxyethyl methacrylate) hydrogel containing an oxygen-sensitive phosphor, and the construct was shown to respond approximately linearly with a 220±73% signal change (n=4, 95% confidence interval) over the physiologically-relevant glucose range (i.e., 0-400mg/dL); to our knowledge, this represents the first demonstration of PEGylated glucose oxidase incorporated into an optical biosensing assay.

A Design Full of Holes: Functional Nanofilm-Coated Microdomains in Alginate Hydrogels.

This study demonstrates the successful manufacture and functional characterization of alginate hydrogels containing a variety of encapsulates within polyelectrolyte multilayer-coated micropores. These microporous alginate (MPA) hydrogels are prepared via one-step internal ionotropic gelation of the alginate using polyelectrolyte multilayer-coated CaCO3 microspheres along with the weak acid glucono-δ-lactone. Here, successful encapsulation of a model macromolecule and fluorescent nanoparticles within microcapsules-distributed throughout the larger alginate hydrogel-is confirmed with confocal microscopy, while the porous morphology of the MPA hydrogels is examined with scanning electron microscopy. Hydrogels constructed with uncoated CaCO3 microspheres release their contents into the surrounding environment, while those constructed with polyelectrolyte multilayer-coated CaCO3 microspheres retain the materials within the pores. MPA hydrogels containing the model enzyme glucose oxidase retained activity and are capable of reacting with small molecules from the external environment. The ability to encapsulate an assortment of functional materials within a moldable, biocompatible alginate matrix gives this approach great flexibility and potential in a wide variety of biomedical applications.

Biofouling of polymer hydrogel materials and its effect on diffusion and enzyme-based luminescent glucose sensor functional characteristics.

BACKGROUND: Continuous glucose monitoring is crucial to developing a successful artificial pancreas. However, biofouling and host response make in vivo sensor performance difficult to predict. We investigated changes in glucose diffusivity and sensor response of optical enzymatic glucose sensors due to biological exposure. METHOD: Three hydrogel materials, poly(2-hydroxyethyl methacrylate) (pHEMA), poly(acrylamide) (pAM), and poly(2-hydroxyethyl methacrylate)-co-poly(acrylamide) (p(HEMA-co-AM)), were tested for glucose diffusivity before and after exposure to serum or implantation in rats for 1 month. Luminescent sensors based on these materials were measured to compare the response to glucose before and after serum exposure. RESULTS: Glucose diffusivity through the pHEMA [(8.1 ± 0.38) × 10(-8) cm(2)/s] slabs was much lower than diffusivity through pAM [(2.7 ± 0.15) × 10(-6) cm(2)/s] and p(HEMA-co-AM) [(2.5 ± 0.08) × 10(-6)]. As expected from these differences, sensor response was highly dependent on material type. The pHEMA sensors had a maximum sensitivity of 2.5%/(mg/dl) and an analytical range of 4.2-356 mg/dl, while the p(HEMA-co-AM) sensors had a higher sensitivity [14.9%/(mg/dl)] and a narrower analytical range (17.6-70.5 mg/dl). After serum exposure, the pHEMA sensors were unaffected, whereas the p(HEMA-co-AM) sensors exhibited significantly decreased sensitivity and increased analytical range. CONCLUSIONS: Decreases in glucose diffusivity in the polymers resulting from in vitro serum exposure and residence in vivo were shown to be similar, suggesting that serum incubation was a reasonable approximation of in vivo fouling. While biofouling is expected to affect the response of flux-based sensors, we have shown that this depended on the type of sensor and matrix used. Therefore, proper design and materials selection may minimize response alterations occurring upon implantation.