RESUMEN
Here, we present lattice dynamics associated with the local chemical bonding hierarchy in Zintl compound TlInTe2 , which cause intriguing phonon excitations and strongly suppress the lattice thermal conductivity to an ultralow value (0.46-0.31â W m-1 K-1 ) in the 300-673â K. We established an intrinsic rattling nature in TlInTe2 by studying the local structure and phonon vibrations using synchrotron X-ray pair distribution function (PDF) (100-503â K) and inelastic neutron scattering (INS) (5-450â K), respectively. We showed that while 1D chain of covalently bonded I n T e 2 n - n transport heat with Debye type phonon excitation, ionically bonded Tl rattles with a frequency ca. 30â cm-1 inside distorted Thompson cage formed by I n T e 2 n - n . This highly anharmonic Tl rattling causes strong phonon scattering and consequently phonon lifetime reduces to ultralow value of ca. 0.66(6)â ps, resulting in ultralow thermal conductivity in TlInTe2 .
RESUMEN
Thermoelectric (TE) energy conversion demands high performance crystalline inorganic solids that exhibit ultralow thermal conductivity, high mechanical stability, and good TE device properties. Pb-free germanium telluride (GeTe)-based material has recently attracted significant attention in TE power generation in mid temperatures, but pristine GeTe possesses significantly higher lattice thermal conductivity (κlatt) compared to that of its theoretical minimum (κmin) of â¼0.3 W/mK. Herein, we have demonstrated the reduction of κlatt of (GeTe)1-2x(SnSe)x(SnS)x very near to its κmin. The (GeTe)1-2x(SnSe)x(SnS)x system behaves as a coexistence of point-defect rich solid solution and phase separation. Initially, the addition of equimolar SnSe and SnS in the GeTe reduces the κlatt by effective phonon scattering because of the excess point defects and rich microstructures. In the second step, introduction of Sb-doping leads to additional phonon scattering centers and optimizes the p-type carrier concentration. Notably, 10 mol % Sb-doped (GeTe)0.95(SnSe)0.025(SnS)0.025 exhibits ultralow κlatt of â¼0.30 W/mK at 300 K. Subsequently, 10 mol % Sb-doped (GeTe)0.95(SnSe)0.025(SnS)0.025 exhibits a high TE figure of merit (zT) of â¼1.9 at 710 K. The high-performance sample exhibits a Vickers microhardness (mechanical stability) value of â¼194 HV that is significantly higher compared to the pristine GeTe and other state-of-the-art thermoelectric materials. Further, we have achieved a high output power, â¼150 mW for the temperature difference of 462 K, in single leg TE device based on 10 mol % Sb-doped (GeTe)0.95(SnSe)0.025(SnS)0.025.
RESUMEN
Ultrathin ferroelectric semiconductors with high charge carrier mobility are much coveted systems for the advancement of various electronic and optoelectronic devices. However, in traditional oxide ferroelectric insulators, the ferroelectric transition temperature decreases drastically with decreasing material thickness and ceases to exist below certain critical thickness owing to depolarizing fields. Herein, we show the emergence of an ordered ferroelectric ground state in ultrathin (â¼2 nm) single crystalline nanosheets of Bi2O2Se at room temperature. Free-standing ferroelectric nanosheets, in which oppositely charged alternating layers are self-assembled together by electrostatic interactions, are synthesized by a simple, rapid, and scalable wet chemical procedure at room temperature. The existence of ferroelectricity in Bi2O2Se nanosheets is confirmed by dielectric measurements and piezoresponse force spectroscopy. The spontaneous orthorhombic distortion in the ultrathin nanosheets breaks the local inversion symmetry, thereby resulting in ferroelectricity. The local structural distortion and the formation of spontaneous dipole moment were directly probed by atomic resolution scanning transmission electron microscopy and density functional theory calculations.
RESUMEN
A challenge in thermoelectrics is to achieve intrinsically low thermal conductivity in crystalline solids while maintaining a high carrier mobility (µ). Topological quantum materials, such as the topological insulator (TI) or topological crystalline insulator (TCI) can exhibit high µ. Weak topological insulators (WTI) are of interest because of their layered hetero-structural nature which has a low lattice thermal conductivity (κlat ). BiTe, a unique member of the (Bi2 )m (Bi2 Te3 )n homologous series (m:n=1:2), has both the quantum states, TCI and WTI, which is distinct from the conventional strong TI, Bi2 Te3 (where m:n=0:1). Herein, we report intrinsically low κlat of 0.47-0.8â W m-1 K-1 in the 300-650â K range in BiTe resulting from low energy optical phonon branches which originate primarily from the localized vibrations of Bi bilayer. It has high µ≈516â cm2 V-1 s-1 and 707â cm2 V-1 s-1 along parallel and perpendicular to the spark plasma sintering (SPS) directions, respectively, at room temperature.
RESUMEN
Successful applications of a thermoelectric material require simultaneous development of compatible n- and p-type counterparts. While the thermoelectric performance of p-type GeTe has been improved tremendously in recent years, it has been a challenge to find a compatible n-type GeTe counterpart due to the prevalence of intrinsic Ge vacancies. Herein, we have shown that alloying of AgBiSe2 with GeTe results in an intriguing evolution in its crystal and electronic structures, resulting in n-type thermoelectric properties. We have demonstrated that the ambient rhombohedral structure of pristine GeTe transforms into cubic phase in (GeTe)100-x(AgBiSe2)x for x ≥ 25, with concurrent change from its p-type electronic character to n-type character in electronic transport properties. Such change in structural and electronic properties is confirmed from the nonmonotonic variation of band gap, unit cell volume, electrical conductivity, and Seebeck coefficient, all of which show an inflection point around x â¼ 20, as well as from the temperature variations of synchrotron powder X-ray diffractions and differential scanning calorimetry. First-principles density functional theoretical (DFT) calculations explain that the shift toward n-type electronic character with increasing AgBiSe2 concentration arises due to increasing contribution of Bi p orbitals in the conduction band edge of (GeTe)100-x(AgBiSe2)x. This cubic n-type phase has promising thermoelectric properties with a band gap of â¼0.25 eV and ultralow lattice thermal conductivity that ranges between 0.3 and 0.6 W/mK. Further, we have shown that (GeTe)100-x(AgBiSe2)x has promising thermoelectric performance in the mid-temperature range (400-500 K) with maximum thermoelectric figure of merit, zT, reaching â¼1.3 in p-type (GeTe)80(AgBiSe2)20 at 467 K and â¼0.6 in n-type (GeTe)50(AgBiSe2)50 at 500 K.
RESUMEN
Realization of high thermoelectric performance in n-type semiconductors is of imperative need on account of the dearth of efficient n-type thermoelectric materials compared to the p-type counterpart. Moreover, development of efficient thermoelectric materials based on Te-free compounds is desirable because of the scarcity of Te in the Earth's crust. Herein, we report the intrinsic ultralow thermal conductivity and high thermoelectric performance near room temperature in n-type BiSe, a Te-free solid, which recently has emerged as a weak topological insulator. BiSe possesses a layered structure consisting of a bismuth bilayer (Bi2) sandwiched between two Bi2Se3 quintuple layers [Se-Bi-Se-Bi-Se], resembling natural heterostructure. High thermoelectric performance of BiSe is realized through the ultralow lattice thermal conductivity (κlat of â¼0.6 W/mK at 300 K), which is significantly lower than that of Bi2Se3 (κlat of â¼1.8 W/mK at 300 K), although both of them belong to the same layered homologous family (Bi2) m(Bi2Se3) n. Phonon dispersion calculated from first-principles and the experimental low-temperature specific heat data indicate that soft localized vibrations of bismuth bilayer in BiSe are responsible for its ultralow κlat. These low energy optical phonon branches couple strongly with the heat carrying acoustic phonons, and consequently suppress the phonon mean free path leading to low κlat. Further optimization of thermoelectric properties of BiSe through Sb substitution and spark plasma sintering (SPS) results in high ZT â¼ 0.8 at 425 K along the pressing direction, which is indeed remarkable among Te-free n-type thermoelectric materials near room temperature.
RESUMEN
GeTe and its derivatives constituting Pb-free elements have been well known as potential thermoelectric materials for the last five decades, which offer paramount technological importance. The main constraint in the way of optimizing thermoelectric performance of GeTe is the high lattice thermal conductivity (κlat). Herein, we demonstrate low κlat (â¼0.7 W/m·K) and a significantly high thermoelectric figure of merit (ZT = 2.1 at 630 K) in the Sb-doped pseudoternary (GeTe)1-2x(GeSe)x(GeS)x system by two-step strategies. The (GeTe)1-2x(GeSe)x(GeS)x system provides an excellent podium to investigate competition between an entropy-driven solid solution and enthalpy-driven phase separation. In the first step, small concentrations of Se and S were substituted simultaneously in the position of Te in GeTe to reduce the κlat by phonon scattering due to mass fluctuations and point defects. When the Se/S concentration increases significantly, the system deviates from a solid solution, and phase separation of the GeS1-xSex (5-20 µm) precipitates in the GeTe1-xSex matrix occurs, which does not participate in phonon scattering. In the second stage, κlat of the optimized sample is further reduced to 0.7 W/m·K by Sb alloying and spark plasma sintering (SPS), which introduce additional phonon scattering centers such as excess solid solution point defects and grain boundaries. The low κlat in Sb-doped (GeTe)1-2x(GeSe)x(GeS)x is attributed to phonon scattering by entropically driven solid solution point defects rather than conventional endotaxial nanostructuring. As a consequence, the SPS-processed Ge0.9Sb0.1Te0.9Se0.05S0.05 sample exhibits a remarkably high ZT of 2.1 at 630 K, which is reproducible and stable over temperature cycles. Moreover, Sb-doped (GeTe)1-2x(GeSe)x(GeS)x exhibits significantly higher Vickers microhardness (mechanical stability) compared to that of pristine GeTe.
RESUMEN
Waste heat sources are generally diffused and provide a range of temperatures rather than a particular temperature. Thus, thermoelectric waste heat to electricity conversion requires a high average thermoelectric figure of merit (ZTavg ) of materials over the entire working temperature along with a high peak thermoelectric figure of merit (ZTmax ). Herein an ultrahigh ZTavg of 1.4 for (GeTe)80 (AgSbSe2 )20 [TAGSSe-80, T=tellurium, A=antimony, G=germanium, S=silver, Se=selenium] is reported in the temperature range of 300-700â K, which is one of the highest values measured amongst the state-of-the-art Pb-free polycrystalline thermoelectric materials. Moreover, TAGSSe-80 exhibits a high ZTmax of 1.9 at 660â K, which is reversible and reproducible with respect to several heating-cooling cycles. The high thermoelectric performance of TAGSSe-x is attributed to extremely low lattice thermal conductivity (κlat ), which mainly arises due to extensive phonon scattering by hierarchical nano/meso-structures in the TAGSSe-x matrix. Addition of AgSbSe2 in GeTe results in κlat of ≈0.4â W mK-1 in the 300-700â K range, approaching to the theoretical minimum limit of lattice thermal conductivity (κmin ) of GeTe. Additionally, (GeTe)80 (AgSbSe2 )20 exhibits a higher Vickers microhardness (mechanical stability) value of ≈209â kgf mm-2 compared to the other state-of-the-art metal chalcogenides, making it an important material for thermoelectrics.
RESUMEN
High thermoelectric performance is generally achieved through either electronic structure modulations or phonon scattering enhancements, which often counteract each other. A leap in performance requires innovative strategies that simultaneously optimize electronic and phonon transports. We demonstrate high thermoelectric performance with a near room-temperature figure of merit, ZT ~ 1.5, and a maximum ZT ~ 2.6 at 573 kelvin, by optimizing atomic disorder in cadmium-doped polycrystalline silver antimony telluride (AgSbTe2). Cadmium doping in AgSbTe2 enhances cationic ordering, which simultaneously improves electronic properties by tuning disorder-induced localization of electronic states and reduces lattice thermal conductivity through spontaneous formation of nanoscale (~2 to 4 nanometers) superstructures and coupling of soft vibrations localized within ~1 nanometer around cadmium sites with local strain modulation. The strategy is applicable to most other thermoelectric materials that exhibit inherent atomic disorder.
RESUMEN
Bi2Se3 is a well-established topological insulator (TI) having spin momentum locked Dirac surface states at room temperature and predicted to exhibit high spin to charge conversion efficiency (SCCE) for spintronics applications. The SCCE in TIs is characterized by an inverse Edelstein effect length (λIREE). We report an λIREE of â¼0.36 nm, which is the highest ever observed in Bi2Se3. Here, we performed spin pumping and inverse spin Hall effect (ISHE) in an electron beam-evaporated Bi2Se3/CoFeB bilayer. The Bi2Se3 thickness dependence of λIREE, perpendicular surface anisotropy (KS), spin mixing conductance, and spin Hall angle confirmed that spin to charge conversion is due to spin momentum locked Dirac surface states. We propose that the role of surface states in SCCE can be understood by the evaluation of KS. The SCCE is found to be high when the value of KS is small.