Anomalous Resistivity and Electron Heating by Lower Hybrid Drift Waves during Magnetic Reconnection with a Guide Field.

The lower hybrid drift wave (LHDW) has been a candidate for anomalous resistivity and electron heating inside the electron diffusion region of magnetic reconnection. In a laboratory reconnection layer with a finite guide field, quasielectrostatic LHDW (ES-LHDW) propagating along the direction nearly perpendicular to the local magnetic field is excited in the electron diffusion region. ES-LHDW generates large density fluctuations (δn_{e}, about 25% of the mean density) that are correlated with fluctuations in the out-of-plane electric field (δE_{Y}, about twice larger than the mean reconnection electric field). With a small phase difference (∼30°) between two fluctuating quantities, the anomalous resistivity associated with the observed ES-LHDW is twice larger than the classical resistivity and accounts for 20% of the mean reconnection electric field. After we verify the linear relationship between δn_{e} and δE_{Y}, anomalous electron heating by LHDW is estimated by a quasilinear analysis. The estimated electron heating is about 2.6±0.3 MW/m^{3}, which exceeds the classical Ohmic heating of about 2.0±0.2 MW/m^{3}. This LHDW-driven heating is consistent with the observed trend of higher electron temperatures when the wave amplitude is larger. Presented results provide the first direct estimate of anomalous resistivity and electron heating power by LHDW, which demonstrates the importance of wave-particle interactions in magnetic reconnection.

Using Direct Laboratory Measurements of Electron Temperature Anisotropy to Identify the Heating Mechanism in Electron-Only Guide Field Magnetic Reconnection.

Anisotropic electron heating during electron-only magnetic reconnection with a large guide magnetic field is directly measured in a laboratory plasma through in situ measurements of electron velocity distribution functions. Electron heating preferentially parallel to the magnetic field is localized to one separatrix, and anisotropies of 1.5 are measured. The mechanism for electron energization is identified as the parallel reconnection electric field because of the anisotropic nature of the heating and spatial localization. These characteristics are reproduced in a 2D particle-in-cell simulation and are also consistent with numerous magnetosheath observations. A measured increase in the perpendicular temperature along both separatrices is not reproduced by our 2D simulations. This work has implications for energy partition studies in magnetosheath and laboratory reconnection.

Laboratory Observations of Electron Heating and Non-Maxwellian Distributions at the Kinetic Scale during Electron-Only Magnetic Reconnection.

Non-Maxwellian electron velocity distribution functions composed of a warm bulk population and a cold beam are directly measured during electron-only reconnection with a strong out-of-plane (guide) magnetic field in a laboratory plasma. Electron heating is localized to the separatrix, and the electron temperature increases continuously along the separatrix. The measured gain in enthalpy flux is 70% of the incoming Poynting flux. The electron beams are oppositely directed on either side of the X point, and their velocities are comparable to, and scale with, the electron Alfvén speed. Particle-in-cell simulations are consistent with the measurements. The experimental results are consistent with, and go beyond, recent observations in the magnetosheath.

Multi-dimensional incoherent Thomson scattering system in PHAse Space MApping (PHASMA) facility.

A multi-dimensional incoherent Thomson scattering diagnostic system capable of measuring electron temperature anisotropies at the level of the electron velocity distribution function (EVDF) is implemented on the PHAse Space MApping facility to investigate electron energization mechanisms during magnetic reconnection. This system incorporates two injection paths (perpendicular and parallel to the axial magnetic field) and two collection paths, providing four independent EVDF measurements along four velocity space directions. For strongly magnetized electrons, a 3D EVDF comprised of two characteristic electron temperatures perpendicular and parallel to the local magnetic field line is reconstructed from the four measured EVDFs. Validation of isotropic electrons in a single magnetic flux rope and a steady-state helicon plasma is presented.

Laboratory plasma devices for space physics investigation.

In the past decades, laboratory experiments have contributed significantly to the exploration of the fundamental physics of space plasmas. Since 1908, when Birkeland invented the first terrella device, numerous experimental apparatuses have been designed and constructed for space physics investigations, and beneficial achievements have been gained using these laboratory plasma devices. In the present work, we review the initiation, development, and current status of laboratory plasma devices for space physics investigations. The notable experimental apparatuses are categorized and discussed according to the central scientific research topics they are related to, such as space plasma waves and instabilities, magnetic field generation and reconnection, and modeling of the Earth's and planetary space environments. The characteristics of each device, including the plasma configuration, plasma generation, and control method, are highlighted and described in detail. In addition, their contributions to reveal the underlying physics of space observations are also briefly discussed. For the scope of future research, various challenges are discussed, and suggestions are provided for the construction of new and enhanced devices. The objective of this work is to allow space physicists and planetary scientists to enhance their knowledge of the experimental apparatuses and the corresponding experimental techniques, thereby facilitating the combination of spacecraft observation, numerical simulation, and laboratory experiments and consequently promoting the development of space physics.

Incoherent Thomson scattering system for PHAse space MApping (PHASMA) experiment.

A new incoherent Thomson scattering system measures the evolution of electron velocity distribution functions perpendicular and parallel to the ambient magnetic field during kinking of a single flux rope and merging of two flux ropes through magnetic reconnection. The Thomson scattering system provides sub-millimeter spatial resolution, sufficient to diagnose the several millimeters sized magnetic reconnection electron diffusion region in the PHAse Space MAppgin experiment. Due to the relatively modest plasma density ∼1019 m-3 and electron temperature ∼1 eV, stray light suppression is critical for these measurements. Two volume Bragg gratings are used in series as a notch filter with a spectral bandwidth <0.1 nm in the collection branch. A CCD with a Gen III intensifier with peak quantum efficiency >47% is used as the detector in a 1.3 m spectrometer. Preliminary results of gun plasma electron temperature will be reported and compared with measurements obtained from a triple Langmuir probe.

Formation of field-reversed configuration using an in-vessel odd-parity rotating magnetic field antenna in a linear device.

A Field-Reversed Configuration (FRC) is formed by an in-vessel odd-parity rotating magnetic field (RMF) antenna in a tandem mirror device, Keda mirror with axisymmetricity. The 40-cm diameter antenna is fed independently by four IGBT-based power units with an output current of 1500 A each at 84 kHz, and their phases are adjustable to launch odd or even parity RMFs. A medium-sized washer gun is utilized to generate a highly ionized seed hydrogen plasma. Driven by RMF, the resultant FRC is formed with a separatrix radius of ∼17 cm, external field of ∼50 G, and trapped poloidal flux of ∼0.15 mWb. The formation process of FRCs is evidenced by the measurement of an array of internal two-dimensional probes; a comparison with the rigid rotor model is presented in this paper. In addition, substantial toroidal electron current is found to be driven, despite the partial RMF penetration. Moreover, the dependence of the driven current on the antenna current is reported and is found to be consistent with the RMF current driving model.

Characterization of a medium-sized washer-gun for an axisymmetric mirror.

A new medium-sized washer gun is developed for a plasma start-up in a fully axisymmetric mirror. The gun is positioned at the east end of the Keda Mirror with AXisymmetricity facility and operated in the pulsed mode with an arc discharging time of 1.2 ms and a typical arc current of 8.5 kA with 1.5 kV discharge voltage. To optimize the operation, a systematic scan of the neutral pressure, the arc voltage, the bias voltage on a mesh grid 6 cm in front of the gun and an end electrode located on the west end of mirror, and the mirror ratio was performed. The streaming plasma was measured with triple probes in the three mirror cells and a diamagnetic loop in the central cell. Floating potential measurements suggest that the plasma could be divided into streaming and mirror-confined plasmas. The floating potential for the streaming plasma is negative, with an electric field pointing inwards. The mirror-confined plasma has a typical lifetime of 0.5 ms.

A high voltage pulse generator based on silicon-controlled rectifier for field-reversed configuration experiment.

A high voltage pulse generator based on a silicon-controlled rectifier has been designed and implemented for a field reversed configuration experiment. A critical damping circuit is used in the generator to produce the desired pulse waveform. Depending on the load, the rise time of the output trigger signal can be less than 1 µs, and the peak amplitudes of trigger voltage and current are up to 8 kV and 85 A in a single output. The output voltage can be easily adjusted by changing the voltage on a capacitor of the generator. In addition, the generator integrates an electrically floating heater circuit so it is capable of triggering either pseudosparks (TDI-type hydrogen thyratron) or ignitrons. Details of the circuits and their implementation are described in the paper. The trigger generator has successfully controlled the discharging sequence of the pulsed power supply for a field reversed configuration experiment.

Ion cyclotron resonance heating (ICRH) systems for the Keda Mirror with AXisymmetry (KMAX).

In this paper, we describe the engineering work involved in constructing two ion cyclotron resonance heating (ICRH) systems for use in the Keda Mirror with AXisymmetry tandem mirror experiment. Because they offer an effective and robust heating method, ICRH systems have been widely used in a variety of plasma experiments. The goal of our system is to heat the hydrogen plasma contained in the central cell using the fundamental ion cyclotron frequency. Both systems can deliver a radiofrequency power of ∼120 kW with adjustable operating frequencies that are tuned to be slightly lower than their local ion cyclotron frequencies. Two types of antennas are installed in the central cell in an attempt to launch both slow and fast waves. The heating mechanism is reliant on the magnetic beach effect for slow waves.

Field-reversed configuration formed by in-vessel θ-pinch in a tandem mirror device.

We describe a field reversed configuration (FRC) experiment featuring in-vessel θ-pinch coils and open-field-line plasmas confined in a tandem mirror. Two FRCs, formed near the west and the east mirror throats of a central cell, are ejected toward the mid-plane for colliding and merging. Each FRC consists of four groups of pulsed power supplies and four groups of coils, having diameters 35, 35, 40, and 45 cm. The rise time of the main reversal field is 7.15 µs, and the maximum voltage is 40 kV with total currents of 416 kA, corresponding to a magnetic field of 1690 G. The total capacitive stored energy is 115.2 kJ. A fast pulse gas injection system was designed and tested to inject neutral gas into the FRC formation region with controlled directions. The successful installation of the θ-pinch coils inside the vacuum vessel offers greater freedom for diagnostics and control instruments as well as preserving magnetic tandem mirror configuration. The magnetic field reversal is confirmed by internal magnetic field measurements. The plasma temperature, density, and lifetime are, respectively, ∼100 eV, ∼3.0 × 1018 m-3, and ∼300 µs for the current operating conditions.