High-resolution reconstruction of atmospheric deposition of trace metals and metalloids since AD 1400 recorded by ombrotrophic peat cores in Hautes-Fagnes, Belgium.

The objective of our study was to determine the trace metal accumulation rates in the Misten bog, Hautes-Fagnes, Belgium, and assess these in relation to established histories of atmospheric emissions from anthropogenic sources. To address these aims we analyzed trace metals and metalloids (Pb, Cu, Ni, As, Sb, Cr, Co, V, Cd and Zn), as well as Pb isotopes, using XRF, Q-ICP-MS and MC-ICP-MS, respectively in two 40-cm peat sections, spanning the last 600 yr. The temporal increase of metal fluxes from the inception of the Industrial Revolution to the present varies by a factor of 5-50, with peak values found between AD 1930 and 1990. A cluster analysis combined with Pb isotopic composition allows the identification of the main sources of Pb and by inference of the other metals, which indicates that coal consumption and metallurgical activities were the predominant sources of pollution during the last 600 years.

Heavy metal behaviour in peat--a mineralogical perspective.

The mineralogical composition of a 40 cm subsurface layer of transitional mire 'Bagno Bruch' (southern Poland) polluted with atmospheric dust was studied using scanning electron microscopy. The mire is located 9 km to the east of a zinc smelter on the northern limit of industrial Upper Silesia in southern Poland. Concentrations of zinc, lead and cadmium reach values of 494, 238 and 16 mg kg(-1), respectively, in the peat layer. Inorganic particles in the peat were grouped into two main categories based on their origin: air dust particles of anthropogenic- and natural sources, and authigenic minerals that originated within the mire. Anthropogenic particles comprise an important part of the inorganic particles in the peat. As they are typically enriched in heavy metals, their stability is critical to controlling metal mobilities. Spheroidal aluminosilicate fly-ash particles are the most common- and most stable anthropogenic pollutants. Partially dissolved Pb-bearing particles (sulphides, chlorides and oxides) and ZnS occur as trace components throughout the peat profile. The prolonged existence of the particles made them susceptible to gravitational relocation in the peat and limits the biogeochemical cycling of the constituent elements. The least resistant Fe (hydro)oxides release Zn and minor amounts of Mn, Mg and Sn due to reductive dissolution. The released Zn is immobilized in the form of ZnS spherules, 1-3 µm in diameter, approximately 10 cm further down in the profile. The investigation shows that the behaviour of trace elements in polluted peatland is controlled by mineral dissolution/precipitation processes. The formation of authigenic minerals (ZnS, barite, gypsum) indicates complex redox conditions and element redistribution in the transitional mire.

Anthropogenic impacts in North Poland over the last 1300 years--a record of Pb, Zn, Cu, Ni and S in an ombrotrophic peat bog.

Lead pollution history over Northern Poland was reconstructed for the last ca. 1300 years using the elemental and Pb isotope geochemistry of a dated Polish peat bog. The data show that Polish Pb-Zn ores and coal were the main sources of Pb, other heavy metals and S over Northern Poland up until the industrial revolution. After review of the potential mobility of each element, most of the historical interpretation was based on Pb and Pb isotopes, the other chemical elements (Zn, Cu, Ni, S) being considered secondary indicators of pollution. During the last century, leaded gasoline also contributed to anthropogenic Pb pollution over Poland. Coal and Pb-Zn ores, however, remained important sources of pollution in Eastern European countries during the last 50 years, as demonstrated by a high (206)Pb/(207)Pb ratio (1.153) relative to that of Western Europe (ca. 1.10). The Pb data for the last century were also in good agreement with modelled Pb inventories over Poland and the Baltic region.