RESUMEN
The CeB6(001) single crystal used as a cathode in a low-emittance electron gun and operated at the free-electron laser facility SACLA was investigated using cathode lens electron microscopy combined with X-ray spectroscopy at SPring-8 synchrotron radiation facility. Multilateral analysis using thermionic emission electron microscopy, low-energy electron microscopy, ultraviolet and X-ray photoemission electron microscopy and hard X-ray photoemission spectroscopy revealed that the thermionic electrons are emitted strongly and evenly from the CeB6 surface after pre-activation treatment (annealing at 1500°C for >1â h) and that the thermionic emission intensity as well as elemental composition vary between the central area and the edge of the old CeB6 surface.
RESUMEN
The design and performance of a soft X-ray free-electron laser (FEL) beamline of the SPring-8 Compact free-electron LAser (SACLA) are described. The SPring-8 Compact SASE Source test accelerator, a prototype machine of SACLA, was relocated to the SACLA undulator hall for dedicated use for the soft X-ray FEL beamline. Since the accelerator is operated independently of the SACLA main linac that drives the two hard X-ray beamlines, it is possible to produce both soft and hard X-ray FEL simultaneously. The FEL pulse energy reached 110â µJ at a wavelength of 12.4â nm (i.e. photon energy of 100â eV) with an electron beam energy of 780â MeV.
RESUMEN
The time evolution of beam properties in an electron bunch with the duration of a nanosecond was measured with a time resolution of several tens of picoseconds. A combination of horizontal and vertical slits cuts the beamlet from the original beam, with the current waveform of the beamlet measured using a fast wall-current monitor. The reconstruction of the waveform data obtained by scanning these two slits over the entire beam area provided the time evolution of the spatial profile. A similar measurement using two horizontal (vertical) slits separated by a certain distance also provides the time evolution of the phase-space profile. Using this method, the initial beam extracted from the CeB6 thermionic electron gun of the x-ray free-electron laser (XFEL) SACLA was evaluated. Although the slice emittance in the bunch was measured to be constant, the centroid of the spatial profile moved in the transverse direction by a few hundred micrometers in the 0.6 ns flat-top region. This movement arises from the temporal variation in the rectangular high-voltage pulse of the beam chopper and can cause an increase in the projected emittance. These measurements are important for evaluating the conditions of the initial beam emitted from the cathode and processed downstream of the gun. Hence, the proposed diagnostic system will play an important role in developing an extremely low-emittance electron beam or an artificial electron beam with a multi-bunch or micro-bunch structure that enhances the brightness of the XFEL light.
RESUMEN
We determined the pulse duration of x-ray free electron laser light at 10 keV using highly resolved single-shot spectra, combined with an x-ray free electron laser simulation. Spectral profiles, which were measured with a spectrometer composed of an ultraprecisely figured elliptical mirror and an analyzer flat crystal of silicon (555), changed markedly when we varied the compression strength of the electron bunch. The analysis showed that the pulse durations were reduced from 31 to 4.5 fs for the strongest compression condition. The method, which is readily applicable to evaluate shorter pulse durations, provides a firm basis for the development of femtosecond to attosecond sciences in the x-ray region.
Asunto(s)
Rayos Láser , Modelos Teóricos , Análisis Espectral/instrumentación , Análisis Espectral/métodos , Electrones , Silicio/química , Rayos XRESUMEN
A method of frequency-segmented power amplification using multiband radio frequency (RF) amplifiers was proposed to generate stable and arbitrary high-voltage pulses. The concept behind this method is that an arbitrary pulse with a specified duration and sharp edges can be reconstructed using only several frequencies, and most of the power is concentrated on the fundamental frequency. The high-voltage pulse can, therefore, be obtained by amplifying each segmented frequency and then combining it with the RF power combiners. To correct the frequency-dependent group delays and gain of the amplifier circuit and to perform fine-tuning of the pulse structure, a seed pulse is divided into several lines that have bandpass filters, variable delay lines, variable power attenuators, and main RF amplifiers. A prototype pulse amplifier was designed and fabricated based on this method to generate rectangular pulses for the electron beam chopper of an x-ray free-electron laser injector. Flat and stable pulses with a 2 ns width of 0.2 kV height, peak-to-peak flat top of 0.8%, and route-mean-squared peak jitter of less than 0.2% were successively generated in both single- and multi-bunch structures. In the future, this type of pulse generator will play an important role in accelerators that require complicated and precise beam handling at high repetition rates of kHz or MHz.
RESUMEN
The 13th harmonic of a Ti:sapphire (Ti:S) laser in the plateau region was injected as a seeding source to a 250-MeV free-electron-laser (FEL) amplifier. When the amplification conditions were fulfilled, strong enhancement of the radiation intensity by a factor of 650 was observed. The random and uncontrollable spikes, which appeared in the spectra of the Self-Amplified Spontaneous Emission (SASE) based FEL radiation without the seeding source, were found to be suppressed drastically to form to a narrow-band, single peak profile at 61.2 nm. The properties of the seeded FEL radiation were well reproduced by numerical simulations. We discuss the future precept of the seeded FEL scheme to the shorter wavelength region.
RESUMEN
Ultrabrilliant, femtosecond X-ray pulses from X-ray free-electron lasers (XFELs) have promoted the investigation of exotic interactions between intense X-rays and matters, and the observation of minute targets with high spatio-temporal resolution. Although a single X-ray beam has been utilized for these experiments, the use of multiple beams with flexible and optimum beam parameters should drastically enhance the capability and potentiality of XFELs. Here we show a new light source of a two-colour double-pulse (TCDP) XFEL in hard X-rays using variable-gap undulators, which realizes a large and flexible wavelength separation of more than 30% with an ultraprecisely controlled time interval in the attosecond regime. Together with sub-10-fs pulse duration and multi-gigawatt peak powers, the TCDP scheme enables us to elucidate X-ray-induced ultrafast transitions of electronic states and structures, which will significantly contribute to the advancement of ultrafast chemistry, plasma and astronomical physics, and quantum X-ray optics.