RESUMEN
The rapid development of consumer electronics and the extensive use of mobile devices require the ample use of miniature-loudspeakers for audio applications. The demand for better sound pushes manufacturers to design digital signal processing (DSP) chips (smart amplifiers), which in turn could cause unpleasant sound due to distortion and parameter nonlinearity or transducer damage caused by large diaphragm excursion or voice-coil (VC) burn. This article presents a methodology for nonlinear parameter estimation using an inverse method and displacement limiter for large VC displacement-dependent transducer damage prevention. A set of transduction equations is employed to inversely determine parameters using a polynomial expression. The appropriate selection of an objective function incorporating the unknown vector of nonlinear parameters leads to the adjoint problem that requires a gradient solution. A numerical solver is provided to obtain the VC displacement, current, and derivatives using a robust hybrid spline differential method. The dynamic limiter is proposed to control the peak values of the VC velocity so as to limit an excessive displacement which prevents impulsive damage to the receiver and further application of the DSP board. Numerical and experimental results indicate that the proposed method has high efficiency and can be widely used in transducer applications.
Asunto(s)
Acústica/instrumentación , Amplificadores Electrónicos , Miniaturización , Procesamiento de Señales Asistido por Computador , Sonido , Transductores , Algoritmos , Simulación por Computador , Diseño de Equipo , Modelos Teóricos , Dinámicas no Lineales , Análisis Numérico Asistido por Computador , Sonido/efectos adversosRESUMEN
This article presents an inverse method for estimating the electromechanical parameters of a moving-coil loudspeaker with or without the eddy current and suspension creep effects. With known voice-coil displacement, voice-coil current, and stimulus signal as inputs, four calculation procedures for the direct problem, adjoint problem, sensitivity problem, and conjugate gradient method are involved in inversely solving the unknown electromechanical parameters. The proposed method features high efficiency in solving the direct problem through a hybrid spline difference method. It requires a small number of iterations for the computational algorithm, while offering excellent accuracy in parameter estimations. Analysis results demonstrate small differences between the estimated and measured electromechanical parameters under a variety of stimulus signals, excitation times, and initial guesses. The results are also confirmed by experimental measurements. These results indicate that the proposed method has a strong potential for estimating the electromechanical parameters of moving-coil loudspeakers.