RESUMEN
Background and Aim: Serum uric acid to serum creatinine ratio (SUA/SCr) is associated with metabolic and cardiovascular diseases. We aimed to investigate the association between SUA/SCr and stroke recurrence among young adults with ischemic stroke. Methods: A total of 428 young patients with ischemic stroke were included in the present study. SUA/SCr was calculated from the concentration of serum uric acid and creatine (uric acid/creatine). Cox proportional regression models were performed to evaluate the association between SUA/SCr and stroke recurrence. Kaplan-Meier curves were used to compare recurrence rates in different quantiles of SUA/SCr. Results: During a median follow-up of 3.14 years, 51 (10.7%) patients had stroke recurrence. Multivariable analyses indicated that SUA/SCr was associated with stroke recurrence after being adjusted for potential confounders (quantile four versus quantile one: hazard ratio: 3.420; 95% confidence interval: 1.426-8.200; P = 0.006). Kaplan-Meier curves revealed that patients with a high concentration of SUA/SCr had an increased stroke recurrence risk. The time-dependent receiver operating characteristic curve showed that the area under the curve for SUA/SCr was above 0.7 during follow-up. Restricted cubic spline presented an increasing trend for the link between SUA/SCr and stroke recurrence among young adults. Conclusion: SUA/SCr was positively associated with the risk of stroke recurrence among young adults with ischemic stroke. Further prospective studies are warranted to assess the causality between SUA/SCr and the development of stroke recurrence among young adults.
RESUMEN
The cavity pressure in the injection molding process is closely related to the quality of the molded products, and is used for process monitoring and control, to upgrade the quality of the molded products. The experimental platform was built to carry out the cavity pressure experiment with a micro spline injection mold in the paper. The process parameters were changed, such as V/P switchover, mold temperature, melt temperature, packing pressure, and injection rate, in order to analyze the influence of the process parameters on the product weight. The peak cavity pressure and area under the pressure curve were the two attributes utilized in investigating the correlation between cavity pressure and part weight. The experimental results show that the later switchover allowed the injection to proceed longer and produce a heavier tensile specimen. By comparing different cavity pressure curves, the general shapes of the curves were able to indicate different types of shortage produced. When the V/P switchover position is 10 mm, the coefficient of determination (R2 value) of part weight, for the peak cavity pressure and area under the curve, were 0.7706 and 0.8565, respectively. This showed that the area under the curve appeared to be a better process and quality indicator than the peak cavity pressure.