RESUMEN
In Henan, strawberry cultivation occurs on approximately 10,000 hectares, with annual production approaching 230,000 tons. In April 2022, a root rot disease with a 10% incidence rate was observed on the strawberry cultivars 'Ningyu' and 'Sweet Charlie' grown in plastic greenhouses (0.7 ha) located in Xingyang (113.39°E, 34.79°N), Henan, China. Disease symptoms included yellowing of the outer mature leaves, stunted growth, and subsequent wilting of the entire plant. The roots developed dark brown spots, which gradually turned necrotic (Figures 1a, 1b). To determine the causal agent, four symptomatic plants (two plants per cultivar) were collected. Twelve symptomatic root tissues (three root tissue samples per plant) were surface sterilized with 75% ethanol and 0.1% mercuric chloride, washed thrice in sterile water, air dried, and then placed on PDA at 25°C for 3 days. Eight pure isolates were obtained by hyphal-tip isolation (Fang 2007). Each colony had a dark olivaceous green to brown, cottony appearance with a round margin, and the reverse side was grey-black near the center (Figure 1c). Conidia were ellipsoidal, aseptate, with rounded ends, and 3.1 to 4.8 µm × 1.0 to 2.5 µm in size (Figure 1d). Chlamydospores were ellipsoidal, pale brown, and 7.9 to 11.9 µm × 7.6 to 10.7 µm in size (Figure 1e). A representative fungus isolate, designated as Z5, was selected for further molecular identification. Genomic DNA was extracted from the mycelia of isolate Z5, and four gene partial regions (ITS, TUB2, RPB2, and LSU) were amplified using the primer pairs ITS1/ITS4, Bt-2a/Bt-2b, RPB2-5F/RPB2-7CR and LROR/LR5, respectively (White et al.1990, O'Donnell et al.1997, Reeb et al. 2004, Rehner and Samuels 1994). PCR products were sequenced and submitted to GenBank with the following accession numbers OQ130480 (ITS), OQ190093 (TUB2), OQ190092 (RPB2), and OQ255570 (LSU). BLASTn search revealed that the ITS, TUB2, RPB2, and LSU gene sequences of isolate Z5 showed 99.42% (513/516 bp), 99.69% (320/321 bp), 100% (1071/1071 bp), and 100% (857/857 bp) identity with those of ex-type S. pogostemonis stain ZHKUCC 21-0001 (Dong et al. 2021), respectively. A phylogenetic tree was constructed showing that Z5 clustered with S. pogostemonis (Figure 2). The isolates in this study were identified as S. pogostemonis based on morphological and molecular evidence. To confirm pathogenicity, five one-month-old 'Ningyu' cultivar strawberry seedlings were planted in sterilized nursery soil mixed with wheat grains (0.5% w/w) coated with Z5 mycelia (Fang 2007). An equal number of strawberry seedlings were placed in pots filled with non-infected potting mix to serve as controls. The seedlings were kept in a greenhouse under a 12 h light/dark photoperiod at 25°C. After two weeks, the inoculated seedlings displayed symptoms such as leaf wilting and root necrosis, similar to those observed in the greenhouses, while the control seedlings showed no symptoms (Figures 1f, 1g). The experiment was performed thrice. The identical fungus was re-isolated from the symptomatic roots and identified as S. pogostemonis based on morphological characteristics and molecular analysis, thus fulfilling Koch's postulates. This is the first report of S. pogostemonis causing root rot on strawberries worldwide. Our findings will contribute to a more comprehensive study on investigating and managing this disease.
RESUMEN
STUDY DESIGN: A retrospective study. OBJECTIVE: The aim of this study was to compare clinical and radiological outcomes of the anterior cervical discectomy and fusion (ACDF) with a novel zero-profile variable-angle (Zero-P VA) spacer and a traditional poly-ether-ether-ketone (PEEK) cage and plate system in cases pertaining to cervical radiculopathy/myelopathy. There are two conventional types of ACDF procedures aimed at treating symptomatic cervical spondylosis. The first one involves an uninstrumented "stand-alone" approach utilizing bone graft/cage, while the second incorporates bone graft/cage in conjunction with a front plate positioned before the vertebral bodies. Both procedures have their own inherent advantages and disadvantages. The Zero-P VA spacer, however, represents a unique synthesis by amalgamating the advantages of both traditionally typical procedures. Notably, this spacer can potentially circumvent the issue related to prevertebral soft-tissue disturbance and reduce the occurrence of dysphagia. METHODS: Using our surgical database, the authors systematically conducted a retrospective analysis encompassing all patients who underwent single-level ACDF between January 2018 and January 2019, with a minimum two-year follow-up. Patients either received a Zero-P VA implant or PEEK cage coupled with plating. The Japanese Orthopedic Association (JOA) score and Visual Analogue Scale (VAS) for arm and neck pain were documented. Dysphagia was evaluated using the Eating Assessment Tool-10 (ETA-10). Additional parameters such as cervical alignment, fusion rate and the incidence of postoperative complications were assessed. RESULTS: According to the outcomes of the statistical analysis, there was no substantial disparity that emerged in the advancements observed in the JOA and VAS metrics between the two study cohorts. Noteworthy, however, the ETA-10 scores were statistically significantly reduced in the Zero-P VA group compared to the cage and plating group (p < 0.05). At the final follow-up, there were no statistically significant differences in the height of the operated segment, Cobb angle of the fused segment, C2-C7 Cobb angle and fusion rate between the two groups (p > 0.05). However, postoperative complications were slightly lower in patients with the Zero-P VA group (7.69%) as compared to the cage and plating group (16.67%). CONCLUSION: The clinical outcomes observed with the Zero-P VA spacer used for single-level ACDF were found to be satisfactory. The performance of this device is comparable or even superior to the traditional cage and plating method in preventing postoperative dysphagia and mitigating potential complications associated with the use of a plate.
Asunto(s)
Benzofenonas , Trastornos de Deglución , Polímeros , Fusión Vertebral , Humanos , Estudios de Seguimiento , Estudios Retrospectivos , Resultado del Tratamiento , Trastornos de Deglución/etiología , Cetonas , Complicaciones Posoperatorias/epidemiología , Complicaciones Posoperatorias/etiología , Complicaciones Posoperatorias/prevención & control , Vértebras Cervicales/diagnóstico por imagen , Vértebras Cervicales/cirugía , Discectomía/métodos , Éteres , Fusión Vertebral/métodosRESUMEN
@#Abstract: Objective To understand the phenotypic and genetic characteristics of Yersinia pestis strains isolated from Himalayan marmot natural focus area and domestic rat plague focus area in southern China, and provide reference for mastering the pathogenic characteristics of Yersinia pestis of two plague foci. Methods A total of 412 of Yersinia pestis strains isolated from Himalayan marmot plague focus and domestic rat plague focus of southern China were subjected to to sorbitol fermentation assays, virulence factor, different region (DFR) typing, and clustered regularly interspaced palindromic repeats (CRISPR) typing. Results The biochemical types of Y. pestis from the two plague foci showed distinct regional distribution features. Five biochemical phenotypes were identified in Yersinia pestis isolated from Himalayan marmot natural focus area, while only one biochemical phenotype was identified in strains isolated from the domestic rat plague focus of Southern China. Most of the Yersinia pestis isolated from the two plague foci were capable of producing the virulence factors of Fl and PstI. Among the strains from Himalayan marmot focus, 70.53% (201/285) were VW-positive, 75.09% (214/285) were Pgm-positive, 20.00% (57/285) of the strains were Pgm-negative, and 5.26% (15/285) were Pgm mixed-type strains. Among strains from domestic rat plague focus of southern China, 37.80% (48/127) were VW-positive, 29.13% (37/127) were Pgm-positive, 58.27% (74/127) were Pgm-negative, and 12.60% (16/127) were Pgm mixed-type strains. DFR typing revealed 22 genotypes of Y. pestis from the Himalayan marmot plague focus, with the main genotypes being type 5, 7, 8, 10, 19, 32 and 49. All strains from domestic rat plague focus area in southern China belonged to type 9. CRISPR typing revealed that all strains from the Himalayan marmot natural focus were classified into 7 CRISPR gene clusters and 14 CRISPR genotypes, with the main genotypes being G7, G22, G26-a1'and G22-A1'. All strains from domestic rat plague focus area in southern China belonged to CRISPR genotype G30, with the gene cluster being Ca8. Conclusions The phenotypes and genotypes of the Yersinia pestis of Himalayan marmot plague focus are diverse, with an obvious characteristics of geographical distribution. The phenotype and genotype of the Yersinia pestis of domestic rat plague focus of Southern China are single. DFR and CRISPR genotyping methods with phenotypic characteristics can effectively identify the Yersinia pestis isolated from the two plague foci, thereby meeting the needs of identification and traceability research.
RESUMEN
@#Abstract: Objective To observe the phenotypic characteristics of 3 wild-type plague phages under different experimental environments, providing scientific evidence for the identification of phage biological characteristics and the study of their interaction with host bacteria in the future. Methods The sensitivity of 3 wild-type plague phages were detected by using liquid culture method, emisolid medium method and micro-liquid culture method based on OmniLog TM microbial identification system. Results The growth result based on LB liquid medium showed that the growth of plague phage 476 for 20-24 hours at both 28 ℃ and 37 ℃was better than that of plague phages 087 and 072204 at 37 ℃, and the growth of plague phages 087 was better than that of plague phages 072204 at 37 ℃. With the attenuated plague bacterium EV76 as the host bacterium, phage 476 was able to form visible plaque on double-layer agar medium for 20-20 hours at both 28 ℃ and 37 ℃, phages 087 and 072204 were only able to form opaque plaque on double-layer agar medium for 20-24 hours at 37 ℃. The growth results based on OmniLogTM system showed that when plague phage was lysed in EV76 strain at 33 ℃, the first row appeared as a straight line with a peak of no more than 100 in the 96-well microplate curve chart. As the phage quantity decreased, the dilution plate appeared with growth curve similar to EV76 strain in turn, and the color of tetrazolium dyes in the experimental wells gradually deepened as the phage number decreased and the host bacteria number increased. Therefore, it indicates that phage 476 was sensitively at both 28 ℃ and 37 ℃, while phage 087 and 072204 were temperature-dependent only at 37 ℃ to attenuated plague bacterium EV76. Conclusions The lysing ability of 3 wild-type plague phages are temperature-dependent, and the growth results are consistent under the three experimental conditions.