MoS2 Nanoparticles Decorating Titanate-Nanotube Surfaces: Combined Microscopy, Spectroscopy, and Catalytic Studies.

MoS2/TNTs composites have been obtained by impregnation of titanate nanotubes (TNTs) with a centrifuged solution of nanosized MoS2 particles in isopropyl alcohol (IPA). The characterization has been performed by combining UV-vis-NIR, Raman, AFM, and HRTEM analyses, before and after impregnation. HRTEM images show that the contact between single-layer MoS2 nanoparticles and the support is efficient, so justifying the decoration concept. The volatility of IPA solvent allows the preparation of composites at low temperature and free of carbonaceous impurities. MoS2 nanoparticles have strong excitonic transitions, which are only slightly shifted with respect to the bulk because of quantum size effects. Concentrations of MoS2, less than 0.1 wt %, are enough to induce strong absorption in the visible. Photodegradation of methylene blue (MB) has been performed on TNTs and MoS2/TNTs to verify the effect of the presence of MoS2. The first layer of adsorbed MB is consumed first, followed by clustered MB in the second and more external layers. The presence of low concentrated MoS2 nanoparticles does not substantially alter the photocatalytic properties of TNTs. This result is due to poor overlapping between the high frequency of MoS2 C, D excitonic transitions and the TNTs band gap transition.

Low temperature activation and reactivity of CO2 over a Cr(II)-based heterogeneous catalyst: a spectroscopic study.

A new heterogeneous catalyst for CO(2) activation was identified in the Cr(II)/SiO(2) Phillips catalyst, one of the most important catalysts used industrially for olefin polymerization. Interestingly, it was found that Cr(II)/SiO(2) strongly activates CO(2) already at room temperature, making it available for chemicals synthesis. A preliminary attempt in this direction was done by following the reaction of CO(2) with ethylene oxide at room temperature by means of FT-IR spectroscopy, which showed the formation of ethylene carbonate. Besides non-reductive CO(2) activation, Cr(II)/SiO(2) showed good performances in catalytic reduction of CO(2) to CO, when heated under mild conditions or irradiated with UV-Vis light. Both, in situ FT-IR and UV-Vis spectroscopy, were applied to highlight the redox process occurring at the Cr centres. These results open interesting perspectives to be developed in the field of CO(2) chemical fixation.

Probing the surfaces of heterogeneous catalysts by in situ IR spectroscopy.

This critical review describes the reactivity of heterogeneous catalysts from the point of view of four simple, but essential for Chemistry, molecules (namely dihydrogen, carbon monoxide, nitrogen monoxide and ethylene) that are considered as probes or as reactants in combination with "in situ" controlled temperature and pressure Infrared spectroscopy. The fundamental properties of H(2), CO, NO and C(2)H(4) are shortly described in order to justify their different behaviour in respect of isolated sites in different environments, extended surfaces, clusters, crystalline or amorphous materials. The description is given by considering some "key studies" and trying to evidence similarities and differences among surfaces and probes (572 references).

Storage of hydrogen as a guest of a nanoporous polymeric crystalline phase.

A mechanism of H(2) uptake, based on adsorption in the ordered cavities of nanoporous polymeric crystalline phases rather than on disordered amorphous polymeric surfaces, has been clearly established, for aerogels of syndiotactic polystyrene (s-PS) exhibiting the nanoporous δ phase. An ordered arrangement of the H(2) molecules is proven by FTIR spectra while the inclusion of H(2) is assessed by gravimetric measurements and molecular simulations.

FTIR spectroscopy and thermodynamics of CO and H(2) adsorbed on gamma-, delta- and alpha-Al(2)O(3).

The adsorption of CO and H(2) at the surface of transitional (gamma and delta) and corundum (alpha) phases of Al(2)O(3) is studied by means of FTIR spectroscopy at temperature variable in the 293-60 K (CO) and 293-20 K (H(2)) intervals with the aims of better clarifying the nature of the surface Lewis centres and evaluate the thermodynamics of the adsorption process.

Stability and reactivity of grafted Cr(CO)3 species on MOF linkers: a computational study.

The possibility to modulate Cr(CO)(3) properties by grafting it onto metal-organic framework (MOF) linkers of different natures has been investigated using density functional methods. MOF linkers were modeled using clusters constituted by benzene rings doubly substituted in the para position. The effect of the electron-donor or electron-acceptor nature of benzene substituents on the stability of the (eta(6)-arene)Cr(CO)(3) adduct and on the shift of the CO bands has been considered. Different electron-donor (-NH(2), -CH(3), -OH, -COONa) and electron-acceptor (-F, -COOH, -CN, -CF(3)) substituents have been used and the results compared with the bare benzene. C(6)H(4)(COOZnOH)(2) and C(6)H(4)(Zn(4)O(13)C(6)H(5))(2) clusters have also been adopted as models of the MOF-5 benzene rings. The possibility of modulating the stability and the reactivity of Cr(CO)(3) species by grafting them to MOFs with different organic linkers was verified. In particular, this study indicates that electron-acceptor (e.g., C(6)H(4)(COOH)(2)) substituted MOF linkers facilitate the substitution of CO by incoming molecules, whereas the use of electron-donor ones (e.g., C(6)H(4)(OH)(2)) would improve the stability of the Cr(CO)(3) adduct and the ring acidity. Furthermore, an almost linear dependence of the Cr(CO)(3) binding energies on the calculated structural and vibrational features of the tricarbonyl was found, suggesting that the stability of the Cr(CO)(3) adduct can be inferred experimentally from vibrational and diffraction data. In the end, on the basis of the results obtained, it was possible to successfully explain the experimental shift of the CO IR stretching features of grafted Cr(CO)(3) on the UiO-66, CPO-27-Ni, and MOF-5 aromatic linkers and on the benzene rings of poly(ethylstyrene-co-divinylbenzene). The sign of the Delta nu(CO) shift with respect to C(6)H(6)Cr(CO)(3) has been found to be strongly dependent on higher/lower electron density on the ring.

Response of CPO-27-Ni towards CO, N2 and C2H4.

Coordinatively unsaturated Ni(2+) atoms in CPO-27-Ni form linear adducts with molecular nitrogen. The framework responds to the adsorption-modifying vibrational properties and local structure around adsorbing sites. The present paper deals with a fundamental infrared (IR) study of the interaction of gases on a microporous adsorbent metallorganic framework CPO-27-Ni containing, after solvent removal, coordinatively unsaturated Ni(2+) atoms [Dietzel et al., Chem. Commun. 2006, 959]. CO, N(2) and C(2)H(4) have been chosen. Notwithstanding the relative medium (CO and C(2)H(4)) and weak (N(2)) adsorption enthalpies and the low equilibrium pressures adopted (100-10(-3) mbar) the CPO-27-Ni framework responds promptly and reversibly to the adsorption process, modifying significantly both vibrational properties and local structure around Ni(2+) adsorbing sites as determined by a parallel EXAFS investigation locating the N(2) molecule 2.27 +/- 0.03 A apart from Ni(2+). For both N(2) and C(2)H(4), IR spectra have been discussed and carefully compared with literature data. Isosteric heat of adsorption of the Ni(2+)...N(2) complex formation has been evaluated from temperature dependent IR study to be -DeltaH(ads) = 17 kJ mol(-1).

Modeling CO and N2 adsorption at Cr surface species of Phillips catalyst by hybrid density functionals: effect of Hartree-Fock exchange percentage.

In this article, we present a computational study of the structure and vibrational properties of the species formed by the interaction between Cr sites of Phillips catalyst and probe molecules (CO, N(2)). The vibrational properties of these surface species, intensively investigated in the past, form a very rich and ideal set of experimental data to test computational approaches. By adopting the X(4)Si(2)O(3)Cr (X = H, OH, F) cluster as a simplified model of the ([triple bond]SiO)(2)Cr(II) species present at the surface of the real catalyst, we found that the B3LYP hybrid functional (containing 20% of Hartree-Fock exchange), when applied to this model, is unable to reproduce with reasonable accuracy the currently available experimental data (principally coming from IR spectroscopy). Better agreement is obtained when the percentage of Hartree-Fock exchange is increased (up to 35-40%).

Role of exposed metal sites in hydrogen storage in MOFs.

The role of exposed metal sites in increasing the H2 storage performances in metal-organic frameworks (MOFs) has been investigated by means of IR spectrometry. Three MOFs have been considered: MOF-5, with unexposed metal sites, and HKUST-1 and CPO-27-Ni, with exposed Cu(2+) and Ni(2+), respectively. The onset temperature of spectroscopic features associated with adsorbed H2 correlates with the adsorption enthalpy obtained by the VTIR method and with the shift experienced by the H-H stretching frequency. This relationship can be ascribed to the different nature and accessibility of the metal sites. On the basis of a pure energetic evaluation, it was observed that the best performance was shown by CPO-27-Ni that exhibits also an initial adsorption enthalpy of -13.5 kJ mol(-1), the highest yet observed for a MOF. Unfortunately, upon comparison of the hydrogen amounts stored at high pressure, the hydrogen capacities in these conditions are mostly dependent on the surface area and total pore volume of the material. This means that if control of MOF surface area can benefit the total stored amounts, only the presence of a great number of strong adsorption sites can make the (P, T) storage conditions more economically favorable. These observations lead to the prediction that efficient H2 storage by physisorption can be obtained by increasing the surface density of strong adsorption sites.