Changing from image intensifier to flat detector technology for interventional cardiology procedures: a practical point of view.

A small-scale internal audit has been used to evaluate the impact of the use of a dynamic flat panel detector in the clinical routine in the National Interventional Cardiology Centre in Luxembourg. The parameters tested during commissioning and constancy control of an X-ray system, the introduction of new clinical protocols, the patient and the personal staff dosimetry were considered. The technical parameters tested by the hospital physicist stay the same as for the image intensifier. No innovative protocols have been adopted due to the existence of the flat panel detector. A reduction in dose was noted after the installation of a flat detector, due mostly to the continuing education of the interventional cardiologists as well as the initial calibration of the radiological system. The understanding of the X-ray system and its possibilities is vital for the optimisation of clinical procedures in patient and staff exposure.

Survey on performance assessment of cardiac angiography systems.

Advances in imaging technology have facilitated the development of increasingly complex interventional cardiac equipment. Consequently, there is a need for definitive equipment requirements. The aim of the study is to assess the performances of different cardiac angiographic systems. A questionnaire was sent to centres participating in SENTINEL Project to collect dosimetry data (typical entrance dose rate in fluoroscopy and imaging mode), image quality evaluations (low and high contrast resolutions) and KAP calibration factors. Results from this survey could contribute to the explanation of patient dose variability in angiographic cardiac procedures and to derive reference levels for cardiac angiographic equipment performance parameters.

Reference levels at European level for cardiac interventional procedures.

In interventional cardiology, a wide variation in patient dose for the same type of procedure has been recognised by different studies. Variation is almost due to procedure complexity, equipment performance, procedure protocol and operator skill. The SENTINEL consortium has performed a survey in nine european centres collecting information on near 2000 procedures, and a new set of reference levels (RLs) for coronary angiography and angioplasty and diagnostic electrophysiology has been assessed for air kerma-area product: 45, 85 and 35 Gy cm2, effective dose: 8, 15 and 6 mSv, cumulative dose at interventional reference point: 650 and 1500 mGy, fluoroscopy time: 6.5, 15.5 and 21 min and cine frames: 700 and 1000 images, respectively. Because equipment performance and set-up are the factors contributing to patient dose variability, entrance surface air kerma for fluoroscopy, 13 mGy min(-1), and image acquisition, 0.10 mGy per frame, have also been proposed in the set of RLs.

Staff dosimetry in interventional cardiology: survey on methods and level of exposure.

In interventional cardiac procedures, staff operates near the patient in a non-uniformly scattered radiation field. Consequently, workers may receive, over a period, relatively high radiation doses. The measurement of individual doses to personnel becomes critical due to the use of protective devices and, as a consequence of the large number of methods proposed to assess the effective dose, great variability in monitoring programmes is expected among European countries. SENTINEL consortium has conducted a survey on staff dosimetry methods and on the level of staff exposure in 12 European cardiac centres demonstrating the urgent need to harmonise dosimetry methods. From the dosimetry survey, constraint annual effective dose of 1.4 mSv and Hp(0.07) over the protective apron of 14 mSv are proposed for the optimisation the exposure the most-exposed operator.

Patient dose in interventional radiology: a European survey.

Patient doses for a few common fluoroscopy-guided procedures in interventional radiology (IR) (excluding cardiology) were collected from a few radiological departments in 13 European countries. The major aim was to evaluate patient doses for the basis of the reference levels. In total, data for 20 procedures for about 1300 patients were collected. There were many-fold variations in the number of IR equipment and procedures per population, in the entrance dose rates, and in the patient dose data (total dose area product or DAP, fluoroscopy time and number of frames). There was no clear correlation between the total DAP and entrance dose rate, or between the total DAP and fluoroscopy time, indicating that a number of parameters affect the differences. Because of the limited number of patients, preliminary reference levels were proposed only for a few procedures. There is a need to improve the optimisation of IR procedures and their definitions and grouping, in order to account for their different complexities.

Does a flat panel detector reduce the patient radiation dose in interventional cardiology?

An internal audit has been performed to evaluate the patient radiation dose in the clinical use of X-ray cardiac flat panel detector (FPD) systems. Fluoroscopy and image acquisition (cine mode) programs are optimised for low-dose settings. The diagnostic and therapeutic interventional cardiac procedures are performed at 6 pulse s(-1) for fluoroscopy and 15 frames s(-1) for image acquisition. The FPD entrance dose is configured for 29 nGy pulse(-1) in the fluoroscopy mode and 0.10 microGy frame(-1) in the cine mode. From the data collected, the following local reference levels for coronary angiography and angioplasty have been obtained: kerma-area products 23 and 44 Gy cm(2), cumulative doses 376 and 776 mGy, fluoroscopy times 5 and 15.5 min and cine images 617 and 1163 images.