Fractures in spina bifida from childhood to young adulthood.

This study assessed the prevalence and types of fractures in spina bifida and examined risk factors for fracture. Fracture prevalence was highest in childhood and reduced in adolescence and young adulthood. The importance of maintaining mobility is highlighted by the increased risk of fracture in those who are non-ambulatory. INTRODUCTION: The aims of this study are to study the prevalence and types of fractures according to age group in spina bifida and examine risk factors associated with fracture. METHODS: This is a retrospective cohort study of 146 individuals with spina bifida aged 2 years or older who attended the paediatric or adult spina bifida multidisciplinary clinic at a single tertiary hospital. RESULTS: Median age at which first fracture occurred was 7 years (interquartile range 4-13 years). Fracture rates in children (ages 2-10), adolescents (ages 11-18) and adults (age > 18) were 10.9/1000 (95 % confidence interval 5.9-18.3), 5.4/1000 (95 % CI 1.5-13.8) and 2.9/1000 (95 % CI 0.6-8.1) patient years respectively. Childhood fractures predominantly involved the distal femur and femoral shaft; these fractures were rarely seen in adulthood. Non-ambulatory status was associated with a 9.8 times higher risk of fracture compared with ambulatory patients (odds ratio 9.8, p = 0.016, 95 % CI 1.5-63.0). Relative risk of re-fracture was 3.1 (95 % CI 1.4-6.8). Urological intervention with intestinal segments was associated with renal calculi (p = 0.037) but neither was associated with fracture. CONCLUSIONS: The risk of fracture is lower in adults compared with children with spina bifida. The predominant childhood fracture affects the distal femur, and immobility is the most significant risk factor for fracture. Clinical factors contributing to fracture risk need to be elucidated to enable selection of patients who require investigation and treatment of osteoporosis.

Quantum dot thermometry at ultra-low temperature in a dilution refrigerator with a 4He immersion cell.

Experiments performed at a temperature of a few millikelvins require effective thermalization schemes, low-pass filtering of the measurement lines, and low-noise electronics. Here, we report on the modifications to a commercial dilution refrigerator with a base temperature of 3.5 mK that enable us to lower the electron temperature to 6.7 mK measured from the Coulomb peak width of a quantum dot gate-defined in an [Al]GaAs heteostructure. We present the design and implementation of a liquid 4He immersion cell tight against superleaks, implement an innovative wiring technology, and develop optimized transport measurement procedures.