Role of Thermal Equilibrium Dynamics in Atomic Motion during Nonthermal Laser-Induced Melting.

This study shows that initial atomic velocities as given by thermodynamics play an important role in the dynamics of phase transitions. We tracked the atomic motion during nonthermal laser-induced melting of InSb at different initial temperatures. The ultrafast atomic motion following bond breaking can in general be governed by two mechanisms: the random velocity of each atom at the time of bond breaking (inertial model), and the forces acting on the atoms after bond breaking. The melting dynamics was found to follow the inertial model over a wide temperature range.

Dispersion and monochromatization of x-rays using a beryllium prism.

We demonstrate experimentally and numerically that an x-ray prism made of beryllium can be used to disperse and monochromatize x-rays. A polished beryllium cuboid was employed as refractive and dispersive optics. The results of a proof-of-principle experiment and methods of performance optimization are presented. The spatial separation of undulator harmonics and their subsequent selection using a slit are described. A numerical study, assuming realistic beam and beamline parameters, suggests that undulator harmonics can be spatially separated in the range from 3 keV to beyond 20 keV, while maintaining throughput above 50%. Refractive optics is particularly suitable for low-repetition-rate sources such as free-electron lasers and other LINAC-based short-pulse sources.

Time-resolved X-ray diffraction investigation of the modified phonon dispersion in InSb nanowires.

The modified phonon dispersion is of importance for understanding the origin of the reduced heat conductivity in nanowires. We have measured the phonon dispersion for 50 nm diameter InSb (111) nanowires using time-resolved X-ray diffraction. By comparing the sound speed of the bulk (3880 m/s) and that of a classical thin rod (3600 m/s) to our measurement (2880 m/s), we conclude that the origin of the reduced sound speed and thereby to the reduced heat conductivity is that the C44 elastic constant is reduced by 35% compared to the bulk material.

Time-resolved investigation of nanometer scale deformations induced by a high flux x-ray beam.

We present results of a time-resolved pump-probe experiment where a Si sample was exposed to an intense 15 keV beam and its surface monitored by measuring the wavefront deformation of a reflected optical laser probe beam. By reconstructing and back propagating the wavefront, the deformed surface can be retrieved for each time step. The dynamics of the heat bump, build-up and relaxation, is followed with a spatial resolution in the nanometer range. The results are interpreted taking into account results of finite element method simulations. Due to its robustness and simplicity this method should find further developments at new x-ray light sources (FEL) or be used to gain understanding on thermo-dynamical behavior of highly excited materials.

Repetitive non-thermal melting as a timing monitor for femtosecond pump/probe X-ray experiments.

Time-resolved optical pump/X-ray probe experiments are often used to study structural dynamics. To ensure high temporal resolution, it is necessary to monitor the timing between the X-ray pulses and the laser pulses. The transition from a crystalline solid material to a disordered state in a non-thermal melting process can be used as a reliable timing monitor. We have performed a study of the non-thermal melting of InSb in single-shot mode, where we varied the sample temperature in order to determine the conditions required for repetitive melting. We show how experimental conditions affect the feasibility of such a timing tool.

Generation of a large compressive strain wave in graphite by ultrashort-pulse laser irradiation.

We have studied strain wave generation in graphite induced by an intense ultrashort laser pulse. The study was performed in the intensity regime above the ablation threshold of graphite. The aim was to maximize the strain and, thus, also the internal pressure (stress). Laser pulses with a 1 ps temporal duration melt the surface of graphite resulting in a molten material which initially exists at the solid density. As the molten material expands, a compressive strain wave starts propagating into the crystal below the molten layer. The strain pulse was studied with time-resolved X-ray diffraction. At a temporal delay of 100 ps after laser excitation, we observed >10% compressive strain, which corresponds to a pressure of 7.2 GPa. This strain could be reproduced by hydrodynamic simulations, which also provided a temperature map as a function of time and depth.

Communication: Demonstration of a 20 ps X-ray switch based on a photoacoustic transducer.

We have studied an X-ray switch based on a gold coated indium antimonide crystal using time-resolved X-ray diffraction and demonstrated that the switch could reduce the pulse duration of a 100 ps X-ray pulse down to 20 ps with a peak reflectivity of 8%. We have used a dynamical diffraction code to predict the performance of the switch, which was then confirmed experimentally. The experiment was carried out at the FemtoMAX beamline at the short-pulse facility of the MAX IV laboratory. The performance and limitation of the switch are discussed in terms of acoustic transport properties between the two materials and the electron transport properties of gold.

Measurements of light absorption efficiency in InSb nanowires.

We report on measurements of the light absorption efficiency of InSb nanowires. The absorbed 70 fs light pulse generates carriers, which equilibrate with the lattice via electron-phonon coupling. The increase in lattice temperature is manifested as a strain that can be measured with X-ray diffraction. The diffracted X-ray signal from the excited sample was measured using a streak camera. The amount of absorbed light was deduced by comparing X-ray diffraction measurements with simulations. It was found that 3.0(6)% of the radiation incident on the sample was absorbed by the nanowires, which cover 2.5% of the sample.

Time-resolved x-ray scattering from laser-molten indium antimonide.

We demonstrate a concept to study transient liquids with picosecond time-resolved x-ray scattering in a high-repetition-rate configuration. Femtosecond laser excitation of crystalline indium antimonide (InSb) induces ultrafast melting, which leads to a loss of the long-range order. The remaining local correlations of the liquid result in broad x-ray diffraction rings, which are measured as a function of delay time. After 2 ns the liquid structure factor shows close agreement with that of equilibrated liquid InSb. The measured decay of the liquid scattering intensity corresponds to the resolidification rate of 1 m/s in InSb.