Origin of hexavalent chromium in groundwater: The example of Sarigkiol Basin, Northern Greece.

Hexavalent chromium constitutes a serious deterioration factor for the groundwater quality of several regions around the world. High concentrations of this contaminant have been also reported in the groundwater of the Sarigkiol hydrological basin (near Kozani city, NW Greece). Specific interest was paid to this particular study area due to the co-existence here of two important factors both expected to contribute to Cr(VI) presence and groundwater pollution; namely the area's exposed ophiolitic rocks and its substantial fly ash deposits originating from the local lignite burning power plant. Accordingly, detailed geochemical, mineralogical, hydro-chemical, geophysical and hydrogeological studies were performed on the rocks, soils, sediments and water resources of this basin. Cr(VI) concentrations varied in the different aquifers, with the highest concentration (up to 120µgL-1) recorded in the groundwater of the unconfined porous aquifer situated near the temporary fly ash disposal site. Recharge of the porous aquifer is related mainly to precipitation infiltration and occasional surface run-off. Nevertheless, a hydraulic connection between the porous and neighboring karst aquifers could not be delineated. Therefore, the presence of Cr(VI) in the groundwater of this area is thought to originate from both the ophiolitic rock weathering products in the soils, and the local leaching of Cr(VI) from the diffused fly ash located in the area surrounding the lignite power plant. This conclusion was corroborated by factor analysis, and the strongly positively fractionated Cr isotopes (δ53Cr up to 0.83‰) recorded in groundwater, an ash leachate, and the bulk fly ash. An anthropogenic source of Cr(VI) that possibly influences groundwater quality is especially apparent in the eastern part of the Sarigkiol basin.

Geogenic Cr oxidation on the surface of mafic minerals and the hydrogeological conditions influencing hexavalent chromium concentrations in groundwater.

This study aims to specify the source minerals of geogenic chromium in soils and sediments and groundwater and to determine the favorable hydrogeological environment for high concentrations of Cr(VI) in groundwaters. For this reason, chromium origin and the relevant minerals were identified, the groundwater velocity was calculated and the concentrations of Cr(VI) in different aquifer types were determined. Geochemical and mineralogical analyses showed that chromium concentrations in soils and sediments range from 115 to 959 mg/kg and that serpentine prevails among the phyllosilicates. The high correlation between chromium and serpentine, amphibole and pyroxene minerals verifies the geogenic origin of chromium in soils and sediments and, therefore, in groundwater. Manganese also originates from serpentine, amphibole and pyroxene, and is strongly correlated with chromium, indicating that the oxidation of Cr(III) to Cr(VI) is performed by manganese-iron oxides located on the surface of Cr-Mn-rich minerals. Backscattered SEM images of the soils revealed the unweathered form of chromite grains and the presence of Fe-Mn-rich oxide on the outer surface of serpentine grains. Chemical analyses revealed that the highest Cr(VI) concentrations were found in shallow porous aquifers with low water velocities and their values vary from 5 to 70 µg/L. Cr(VI) concentrations in ophiolitic complex aquifers ranged between 3 and 17 µg/L, while in surface water, karst and deeper porous aquifers, Cr(VI) concentrations were lower than the detection limit of 1.4 µg/L.

Optimizing magnetic nanoparticles for drinking water technology: The case of Cr(VI).

The potential of magnetite nanoparticles to be applied in drinking water treatment for the removal of hexavalent chromium is discussed. In this study, a method for their preparation which combines the use of low-cost iron sources (FeSO4 and Fe2(SO4)3) and a continuous flow mode, was developed. The produced magnetite nanoparticles with a size of around 20 nm, appeared relatively stable to passivation providing a removal capacity of 1.8 µg Cr(VI)/mg for a residual concentration of 50 µg/L when tested in natural water at pH7. Such efficiency is explained by the reducing ability of magnetite which turns Cr(VI) to an insoluble Cr(OH)3 form. The successful operation of a small-scale system consisting of a contact reactor and a magnetic separator demonstrates a way for the practical introduction and recovery of magnetite nanoparticles in water treatment technology.

Occurrence of Cr(VI) in drinking water of Greece and relation to the geological background.

This study provides a survey on potential Cr(VI) exposure attributed to drinking water in Greece. For this reason, a wide sampling and chemical analysis of tap waters from around 600 sites, supplied by groundwater resources, was conducted focusing on areas in which the geological substrate is predominated by ultramafic minerals. Results indicate that although violations of the current chromium regulation limit in tap water are very rare, 25% of cases showed Cr(VI) concentrations above 10 µg/L, whereas Cr(VI) was detectable in 70% of the samples (>2 µg/L). Mineralogy and conditions of groundwater reservoirs were correlated to suggest a possible Cr(VI) leaching mechanism. Higher Cr(VI) values are observed in aquifers in alluvial and neogene sediments of serpentine and amphibolite, originating from the erosion of ophiolithic and metamorphic rocks. In contrast, Cr(VI) concentration in samples from ophiolithic and metamorphic rocks was always below 10 µg/L due to both low contact time and surface area, as verified by low conductivity and salt concentration values. These findings indicate that under specific conditions, pollution of water by Cr(VI) is favorable by a slow MnO2-catalyzed oxidation of soluble Cr(III) to Cr(VI) in which manganese products [Mn(III)/Mn(II)] are probably re-oxidized by oxygen.

Sol-gel encapsulation of binary Zn(II) compounds in silica nanoparticles. Structure-activity correlations in hybrid materials targeting Zn(II) antibacterial use.

In the emerging issue of enhanced multi-resistant properties in infectious pathogens, new nanomaterials with optimally efficient antibacterial activity and lower toxicity than other species attract considerable research interest. In an effort to develop such efficient antibacterials, we a) synthesized acid-catalyzed silica-gel matrices, b) evaluated the suitability of these matrices as potential carrier materials for controlled release of ZnSO4 and a new Zn(II) binary complex with a suitably designed well-defined Schiff base, and c) investigated structural and textural properties of the nanomaterials. Physicochemical characterization of the (empty-loaded) silica-nanoparticles led to an optimized material configuration linked to the delivery of the encapsulated antibacterial zinc load. Entrapment and drug release studies showed the competence of hybrid nanoparticles with respect to the a) zinc loading capacity, b) congruence with zinc physicochemical attributes, and c) release profile of their zinc load. The material antimicrobial properties were demonstrated against Gram-positive (Staphylococcus aureus, Bacillus subtilis, Bacillus cereus) and negative (Escherichia coli, Pseudomonas aeruginosa, Xanthomonas campestris) bacteria using modified agar diffusion methods. ZnSO4 showed less extensive antimicrobial behavior compared to Zn(II)-Schiff, implying that the Zn(II)-bound ligand enhances zinc antimicrobial properties. All zinc-loaded nanoparticles were less antimicrobially active than zinc compounds alone, as encapsulation controls their release, thereby attenuating their antimicrobial activity. To this end, as the amount of loaded zinc increases, the antimicrobial behavior of the nano-agent improves. Collectively, for the first time, sol-gel zinc-loaded silica-nanoparticles were shown to exhibit well-defined antimicrobial activity, justifying due attention to further development of antibacterial nanotechnology.

Cu-Zn powders as potential Cr(VI) adsorbents for drinking water.

This work examines the possibility of applying CuZn alloys as a reducing medium for the efficient removal of hexavalent chromium from drinking water. In an effort to develop a route for producing powders of CuZn alloys under mild conditions and investigate the optimum composition for such application, a series of alloys in the form of powders were prepared, by a sequence of Cu and Zn ball-milling and low temperature annealing. Batch Cr(VI) removal tests, performed to evaluate and compare the efficiency of the products under typical natural water parameters (pH 7 and natural-like water), indicated that the best performing material have a composition around 50 wt% Cu. The dominant reduction mechanisms are both the corrosion of the alloy surface and the electron transfer to the solution. The behavior of granulated CuZn media was tested in rapid-scale column tests using the commercial KDF which verified the high potential of CuZn alloys in Cr(VI) removal. Nevertheless, Cu and Zn leaching problems should be also considered.