Application of response surface methodology for uranium(VI) adsorption using hydroxyapatite prepared from eggshells waste material: study of influencing factors and mechanism.

Hydroxyapatite (HAp) was synthesized from biowaste hen eggshells by wet precipitation method in which calcium hydroxide and phosphoric acid were used as precursors. The effectiveness of uranium(VI) adsorption onto HAp was investigated by batch adsorption experiments from aqueous solutions. The obtained HAp powder was characterized by X-ray diffraction, Fourier transform infrared spectroscopy, Raman spectrometry, point of zero charge and Scanning electron microscope. The factors and levels used during the experiments were pH (2-5), adsorbent mass (0.01-0.05 g), and initial U(VI) concentration (100-310 mg L-1). A Box-Behnken design combined with analysis of variance was used to interpret the main effect influencing the adsorption. The results showed that pH was the most significant parameter affecting U(VI). The kinetic data correlates well with the pseudo-second-order model. The adsorption isotherms fitted the Langmuir-1 type model with the qmax = 175.22 mg g-1 at 25 °C. The calculated value of the mean free energy indicates the chemisorption process. Under optimal conditions, the uranium effluent derived from the precipitation of ammonium uranyl carbonate removal performance of 98% was achieved. This study proved that HAp prepared from eggshell was an ecofriendly and low-cost adsorbent and was very effective for the adsorption of U(VI) from aqueous solutions.

Modeling biosorption of Cr(VI) onto Ulva compressa L. from aqueous solutions.

The marine biomass Ulva compressa L. (ECL) was used as a low-cost biosorbent for the removal of Cr(VI) from contaminated aqueous solutions. The operating variables were optimized: pH ∼ 2, initial concentration of 25 mg/L, solid/liquid ratio of 6 g/L and a temperature of 50 °C, leading to an uptake elimination of 96%. A full factorial experimental design technique enabled us to obtain a mathematical model describing the Cr(VI) biosorption and to study the main effects and interactions among operational parameters. The equilibrium isotherm was analyzed by the Langmuir, Freundlich and Dubinin-Radushkevich (D-R) models; it has been found that the adsorption process follows well the Langmuir model. Kinetic studies showed that the pseudo-second order model describes suitably the experimental data. The thermodynamic parameters indicated an endothermic heat and a spontaneity of the Cr(VI) biosorption onto ECL.