Clonal propagation of primate offspring by embryo splitting.

Primates that are identical in both nuclear and cytoplasmic components have not been produced by current cloning strategies, yet such identicals represent the ideal model for investigations of human diseases. Here, genetically identical nonhuman embryos were produced as twin and larger sets by separation and reaggregation of blastomeres of cleavage-stage embryos. A total of 368 multiples were created by the splitting of 107 rhesus embryos with four pregnancies established after 13 embryo transfers (31% versus 53% in vitro fertilization controls). The birth of Tetra, a healthy female cloned from a quarter of an embryo, proves that this approach can result in live offspring.

Analysis of DNA fragmentation of in vitro cultured bovine blastocysts using TUNEL.

Programmed cell death (apoptosis) characteristically affects the single cells of blastocysts whereas necrosis affects cluster of cells in both the inner cell mass (ICM) and the trophectoderm (TE). This study uses the trophectodermrminal deoxynucleotidyl transferase (TdT) mediated dUTP nick-end labeling (TUNEL) assay as a way of evaluating the proportion of apoptotic cells and, thus, bovine blastocyst quality during in vitro culture at Days 6,7, and 8. Furthermore, parthenogenetic blastocysts were compared to in vitro fertilized blastocysts at Day 7. Confocal microscopy was used to generate three-dimensional reconstructions of the blastocysts. Apoptosis was observed in both early (Day 6) and late (Day 8) developing blastocysts. The dead cell index (DCI, total number of apoptotic nuclei/total number of nuclei) tend to increase as the in vitro culture time increases, and apoptosis is proportionately higher in the ICM than in the TE. The ratio of ICM to TE cells remains relatively constant even as the blastocysts cell number increases (Day 6 = 11.9 +/- 2.2, Day 7 = 11.2 +/- 0.5, Day 8 = 11.7 +/- 0.4). The overall cell number is significantly reduced in parthenogenetic blastocysts compared to Day 7 in vitro produced blastocysts (P = 0.037). The parthenogenetic blastocysts also show an increase of apoptosis over Day 7 controls. The decrease in cell number in the parthenogenetic blastocysts may be due to the increase of apoptotic nuclei observed. Based on these results we found the TUNEL assay to be a useful method for evaluating in vitro culture conditions of pre-implantation bovine embryos.

Scanning electron microscopy of high-pressure-frozen sea urchin embryos.

High-pressure-freezing permits direct cryo-fixation of sea urchin embryos having a defined developmental state without the formation of large ice crystals. We have investigated preparation protocols for observing high-pressure-frozen and freeze-fractured samples in the scanning electron microscope. High-pressure-freezing was superior to other freezing protocols, because the whole bulk sample was reasonably well frozen and the overall three-dimensional shape of the embryos was well preserved. The samples were either dehydrated by freeze-substitution and critical-point-drying, or imaged in the partially hydrated state, using a cold stage in the SEM. During freeze-substitution the samples were stabilized by fixatives. The disadvantage of this method was that shrinking and extraction effects, caused by the removal of the water, could not be avoided. These disadvantages were avoided when the sample was imaged in the frozen-hydrated state using a cold-stage in the SEM. This would be the method of choice for morphometric studies. Frozen-hydrated samples, however, were very beam sensitive and many structures remained covered by the ice and were not visible. Frozen-hydrated samples were partially freeze-dried to make visible additional structures that had been covered by ice. However, this method also caused drying artifacts when too much water was removed.