Forces and moments generated by 3D direct printed clear aligners of varying labial and lingual thicknesses during lingual movement of maxillary central incisor: an in vitro study.

ABSTRACT

OBJECTIVE: The objective of this study was to measure the forces and moments exerted by direct printed aligners (DPAs) with varying facial and lingual aligner surface thicknesses, in all three planes of space, during lingual movement of a maxillary central incisor. MATERIALS AND METHODS: An in vitro experimental setup was used to quantify forces and moments experienced by a programmed tooth to be moved and by adjacent anchor teeth, during lingual movement of a maxillary central incisor. DPAs were directly 3D-printed with Tera Harz TC-85 (Graphy Inc., Seoul, South Korea) clear photocurable resin in 100-µm layers. Three multi-axis sensors were used to measure the moments and forces generated by 0.50 mm thick DPAs modified with labial and lingual surface thicknesses of 1.00 mm in selective locations. The sensors were connected to three maxillary incisors (the upper left central, the upper right central, and the upper left lateral incisors) during 0.50 mm of programmed lingual bodily movement of the upper left central incisor. Moment-to-force ratios were calculated for all three incisors. Aligners were benchtop tested in a temperature-controlled chamber at intra-oral temperature to simulate intra-oral conditions. RESULTS: The results showed that increased facial thickness of DPAs slightly reduced force levels on the upper left central incisor compared to DPAs of uniform thickness of 0.50 mm. Additionally, increasing the lingual thickness of adjacent teeth reduced force and moment side effects on the adjacent teeth. DPAs can produce moment-to-force ratios indicative of controlled tipping. CONCLUSIONS: Targeted increases in thickness of direct 3D-printed aligners change the magnitude of forces and moments generated, albeit in complex patterns that are difficult to predict. The ability to vary labiolingual thicknesses of DPAs is promising to optimize the prescribed orthodontic movements while minimizing unwanted tooth movements, thereby increasing the predictability of tooth movements.