Understanding the bioaccumulation of pharmaceutical active compounds by clams Ruditapes decussatus exposed to a UWWTP discharge.

Twenty-four pharmaceutical active compounds (PhACs) were evaluated in the soft tissues of clams Ruditappes decussatus exposed along a 1.5-km dispersal gradient of the treated effluent from an urban wastewater treatment plant discharging in Ria Formosa, and compared with those in the marine waters and discharged effluents. The clams were exposed for 1 month, in June-July 2016, 2017 and 2018. PhACs were quantified by high performance liquid chromatography coupled to tandem mass spectrometry after the quick, easy, cheap, effective, rugged and safe (QuEChERS) method (clams) or solid-phase extraction (water samples). The most representative PhACs in the effluents and receiving waters (regardless of the tidal dilution effect) were diclofenac, carbamazepine and caffeine (on average ≤ 2 µg/L) and only caffeine exhibited significant inter-annual differences, with higher values in 2017. In turn, the most bioaccumulated PhACs in clams were caffeine (0.54-27 ng/g wet weight, significantly higher in 2016) and acetaminophen (0.37-3.7 ng/g wet weight, significant lower in 2016). A multivariate principal component analysis showed (i) PhAC bioaccumulation primarily depended on biotic factors (clams length and weight), (ii) PhAC physicochemical properties Log Kow, pKa and water solubility interplaying with water abiotic variables were more relevant for explaining data variability in water than the physical dilution/tidal mixing, (iii) this process, reflected by the salinity gradient, had a tertiary role in data variation, responsible for spatial discrimination of marine waters. This study provides a better understanding of PhACs bioaccumulation by clams Ruditapes decussatus in real environmental conditions, under the influence of urban treated effluent dispersal in Ria Formosa coastal lagoon, a major producer of bivalves, ultimately disentangling key factors of PhAC bioaccumulation.

Screening and Seasonal Behavior of Analgesics, Non-steroidal Anti-inflammatory Drugs, and Antibiotics in Two Urban Wastewater Treatment Plants.

Pharmaceutical active compounds (PhACs) belonging to analgesics, antibiotics, and non-steroidal anti-inflammatory drugs (NSAIDs) therapeutic classes were monitored in wastewater influents and effluents from two Portuguese urban wastewater treatment plants (UWWTPs) for 24 months. Both facilities were chosen due to their effluents are discharged in highly touristic and sensitive areas, Tagus river and Ria Formosa coastal lagoon, respectively. Target PhACs, acetaminophen, diclofenac, ibuprofen, naproxen, sulfadiazine, and sulfamethoxazole were measured using solid-phase extraction (SPE) coupled to liquid chromatography tandem mass spectrometry (LC-MS/MS). PhACs occurrence in the influents was higher than 98%, with acetaminophen presenting the highest concentrations, with values between 16.3 µg/L and 124 µg/L. In the effluents, distinct behavior was observed with diclofenac and sulfamethoxazole showing recalcitrant characteristics, whereas acetaminophen, ibuprofen, and naproxen showed removal efficiencies above 95%. Acetaminophen and ibuprofen amount in influents showed consistently higher concentration levels in autumn (in Beirolas and Faro Nw UWWTPs) and winter (only in Beirolas UWWTP) seasons. These seasonal trends were observed to a greater extent in Beirolas UWWTP than in Faro Nw UWWTP. This study enabled the comprehensive definition of a behavior pattern for these target contaminants, contributing to better characterization and build-up a library of PhACs occurrence. It also allowed a robust seasonal profiling of the target compounds due to the high number of samples analyzed by each season and a longer monitoring campaign, making the obtained results more significant.

Chlorination and oxidation of sulfonamides by free chlorine: Identification and behaviour of reaction products by UPLC-MS/MS.

Sulfonamides (SAs) are one class of the most widely used antibiotics around the world and have been frequently detected in municipal wastewater and surface water in recent years. Their transformation in waste water treatment plants (WWTP) and in water treatment plants (WTP), as well as, their fate and transport in the aquatic environment are of concern. The reaction of six sulfonamides (sulfamethoxazole, sulfapyridine, sulfamethazine, sulfamerazine, sulfathiazole and sulfadiazine) with free chlorine was investigated at a laboratory scale in order to identify the main chlorination by-products. A previously validated method, liquid chromatography/mass spectrometry, was used to analyse SAs and their chlorination by-products. At room temperature, pH 6-7, reaction times of up to 2 h and an initial concentration of 2 mg/L of free chlorine, the majority of SAs suffered degradation of around 65%, with the exception of sulfamethoxazole and sulfathiazole (20%). The main reaction of SAs with free chlorine occurred in the first minute.

Different approaches for estimation of the expanded uncertainty of an analytical method developed for determining pharmaceutical active compounds in wastewater using solid-phase extraction and a liquid chromatography coupled with tandem mass spectrometry method.

Although the evaluation of the uncertainty of an analytical method is a mandatory step in the method's validation, its applicability to the monitoring of trace compounds in complex samples is not simple, nor is it part of the routine of most laboratories, namely those dedicated to research. This manuscript focuses on the full validation of an analytical procedure for determining trace concentrations of twenty-four pharmaceutical active compounds (PhACs) in wastewaters using solid-phase extraction (SPE) and ultra-high performance liquid chromatography coupled with tandem mass spectrometry (UHPLC-MS/MS). The method optimization was performed on different wastewater matrices, namely influents and final effluents from two distinct wastewater treatment plants (WWTPs). Matrix effects and extraction efficiency (absolute recovery) of the developed method were determined. Validation was performed to obtain the method's linearity/working range, precision, trueness, method detection limits (MDLs) and method quantification limits (MQLs). The expanded uncertainty of the data obtained was estimated according to the requirements of international procedures dedicated to the expression of uncertainty. Different approaches for the estimation of uncertainty were applied. The validated method was used in the analysis of target PhACs in wastewater samples collected at two WWTPs. The obtained results facilitated the introduction of a validated method for routine measurement of PhACs in wastewater samples and allowed method accreditation by the competent national authority.

Ethylenediamine-N,N'-diglutaric acid (EDDG) as a promising biodegradable chelator: quantification, complexation and biodegradation.

[S,S]-ethylenediamine-N,N'-diglutaric acid (EDDG) has been gaining interest in the industrial sector as a promising chelator. In this study, the effective metal complexing capacity of EDDG over a wide pH range was modelled and its biodegradability assessed. Results showed that EDDG could effectively bind to several metallic ions in a wide pH range and was completely biodegraded after approximately 15 days by un-acclimatized sludge. To confirm its biodegradability, an accurate quantification method based on the combination of liquid chromatography and tandem quadrupole mass spectrometry (LC-MS/MS) was developed. Good linearity of the detector response was found for EDDG at concentrations ranging from 0.15 to 1.2 mg/L.

Bioaugmentation of membrane bioreactor with Achromobacter denitrificans strain PR1 for enhanced sulfamethoxazole removal in wastewater.

Achromobacter denitrificans strain PR1, previously found to harbour specific degradation pathways with high sulfamethoxazole (SMX) degradation rates, was bioaugmented into laboratory-scale membrane bioreactors (MBRs) operated under aerobic conditions to treat SMX-containing real domestic wastewater. Different hydraulic retention times (HRTs), which is related to reaction time and loading rates, were considered and found to affect the SMX removal efficiency. The availability of primary substrates was important in both bioaugmented and non-bioaugmented activated sludge (AS) for cometabolism of SMX. High HRT (24 h) resulted in low food to microorganism ratio (F/M) and low SMX removal, due to substrate limitation. Decrease in HRT from 24 h to 12 h, 6 h and finally 4 h led to gradual increases in primary substrates availability, e.g. organic compounds and ammonia, resulted in increased SMX removal efficiency and degradation rate, and is more favorable for high-rate wastewater treatment processes. After inoculation into the MBRs, the bioaugmentation strain was sustained in the reactor for a maximum of 31 days even though a significant decrease in abundance was observed. The bioaugmented MBRs showed enhanced SMX removal, especially under SMX shock loads compared to the control MBRs. The results of this study indicate that re-inoculation is required regularly after a period of time to maintain the removal efficiency of the target compound.

Determination of several pesticides in water by solid-phase extraction, liquid chromatography and electrospray tandem mass spectrometry.

The analysis of pesticides in water samples is a problem of primary concern for quality control laboratories due to the toxicity level of these compounds and their public health risk. In order to evaluate the impact of pesticides in the Lisbon drinking water supply system, following the requirements of the European Union Directive 98/83/EC, we developed and validated an analytical method based on the combination of solid-phase extraction with liquid chromatography and tandem mass spectrometry. In this work, several pesticides were studied: imidacloprid, dimethoate, cymoxanil, carbendazime, phosmet, carbofuran, isoproturon, diuron, methidathion, linuron, pyrimethanil, methiocarbe, tebuconazole and chlorpyrifos. Several parameters of the electrospray source were optimized in order to get the best formation conditions of the precursor ion for each pesticide, namely capillary and extractor voltage, cone voltage, cone gas flow rate and desolvation gas flow rate. After optimization of the collision cell energy of the triple quadrupole, two different precursor ion-product ion transitions were selected for each pesticide, one for quantification and one for qualification, and these ions were monitored under time-scheduled multiple reaction monitoring (MRM) conditions. The selection of specific fragment ions for each pesticide guarantees a high degree of selectivity as well as additional sensitivity to quantify trace levels of these pesticides in water samples. This method showed excellent linearity ranges for all pesticides, with correlation coefficients greater than 0.9989. Determination limits (between 0.0041 and 0.0480 microg/L), precision (RSD <9.18%), accuracy and recovery studies in several water samples using solid-phase extraction were also performed.

Experimental and statistical validation of SPME-GC-MS analysis of phenol and chlorophenols in raw and treated water.

A procedure based on solid-phase microextraction (SPME) and gas chromatography coupled with mass spectrometry (GC-MS) was developed and validated in order to analyse 10 phenols in water samples. The optimised conditions were obtained using polyacrylate fibre (PA), 20ml of sample volume, 10% NaCl, pH 4.0 and direct extraction at 35 degrees C and 1000rpm, for 40min. The linear range and quantification limits for these compounds by SPME-GC-MS were defined. An evaluation of the main uncertainty sources of this method is included, which allows expanded uncertainties in the 9.4-35% range for the majority of the compounds. The main source of uncertainty is associated with matrix effects. The validated method is suitable for monitoring the production and distribution of potable water and was used, in field trials, for the analysis of samples from main intakes of water (surface or underground) and from water supply system of a large area (Lisbon and neighbour municipalities).

Occurrence and behaviour of pharmaceutical compounds in a Portuguese wastewater treatment plant: Removal efficiency through conventional treatment processes.

Wastewater treatments can eliminate or remove a substantial amount of pharmaceutical active compounds (PhACs), but there may still be significant concentrations of them in effluents discharged into surface water bodies. Beirolas wastewater treatment plant (WWTP) is located in the Lisbon area and makes its effluent discharges into Tagus estuary (Portugal). The main objective of this study is to quantify a group of 32 PhACs in the different treatments used in this WWTP. Twelve sampling campaigns of wastewater belonging to the different treatments were made in 2013-2014 in order to study their removal efficiency. The wastewaters were analysed by solid phase extraction (SPE) and ultra-performance liquid chromatography coupled with tandem mass detection (UPLC-MS/MS). The anti-diabetics were the most frequently found in wastewater influent (WWI) and wastewater effluent (WWE) (208 and 1.7 µg/L, respectively), followed by analgesics/antipyretics (135 µg/L and < LOQ, respectively), psychostimulants (113 and 0.49 µg/L, respectively), non-steroidal anti-inflammatory drugs (33 and 2.6 µg/L, respectively), antibiotics (5.2 and 1.8 µg/L, respectively), antilipidemics (1.6 and 0.24 µg/L, respectively), anticonvulsants (1.5 and 0.63 µg/L, respectively) and beta blockers (1.3 and 0.51 µg/L, respectively). A snapshot of the ability of each treatment step to remove these target PhACs is provided, and it was found that global efficiency is strongly dependent on the efficiency of secondary treatment. Seasonal occurrence and removal efficiency was also monitored, and they did not show a significant seasonal trend.

Chemical and biochemical characterization and in vivo safety evaluation of pharmaceuticals in drinking water.

The water constituents that are currently subject to legal control are only a small fraction of the vast number of chemical substances and microorganisms that may occur in both the environment and water resources. The main objective of the present study was to study the health impact resulting from exposure to a mixture of pharmaceuticals that have been detected in tap water at low doses. Analyses of atenolol, caffeine, erythromycin, carbamazepine, and their metabolites in blood, urine, feces, fat tissue, liver, and kidney after exposure to a mixture of these pharmaceuticals in treated drinking water were performed. The effects of this exposure were assessed in rats by measuring biochemical markers of organ injury or dysfunction. Simultaneously, the selected pharmaceuticals were also quantified in both physiological fluids and organ homogenates by liquid chromatography-tandem mass spectrometry (performed in multiple reaction monitoring mode and full scan mode). Following exposure of rats to a concentration of a pharmaceutical which was 10 times higher than the concentration known to be present in tap water, trace levels of some pharmaceuticals and their metabolites were detected in biological samples. This exposure did, however, not lead to significant organ injury or dysfunction. Thus, the authors report an experimental model that can be used to characterize the safety profile of pharmaceuticals in treated drinking water using a multiorgan toxicity approach. Environ Toxicol Chem 2016;35:2674-2682. © 2016 SETAC.

Occurrence of pharmaceuticals in a water supply system and related human health risk assessment.

A monitoring study of 31 pharmaceuticals along Lisbon's drinking water supply system was implemented, which comprised the analysis of 250 samples including raw water (surface water and groundwater), and drinking water. Of the 31 pharmaceutical compounds, only sixteen were quantified in the analyzed samples, with levels ranging from 0.005 to 46 ng/L in raw water samples and 0.09-46 ng/L in drinking water samples. The human health risk assessment performed showed that appreciable risks to the consumer's health arising from exposure to trace levels of pharmaceuticals in drinking water are extremely unlikely, as RQs values were all below 0.001. Also, pharmaceuticals were selected as indicators to be used as a tool to control the quality of raw water and the treatment efficiency in the drinking water treatment plants.