Reorientation of the left ventricular long-axis on myocardial transaxial tomograms by a linear fitting method.

A method is described for reorientating the left ventricular (LV) long-axis from myocardial transaxial tomographic data. On a midventricular transverse slice and on a midventricular sagittal slice, the apical and basal limits are selected successively by the operator. The linear activity profiles between these two limits are plotted line by line. In each profile, the two points with the maximum counts in the septal and lateral walls on the transverse slice, or in the anterior and inferior walls on the sagittal slice, are detected. The intermediate point with the minimum counts is then determined. The set of points with minimum counts are fitted by a straight line using the least squares method. This line is taken as the LV long-axis. In a series of 15 cases with stress-delayed 201Tl SPECT, the reproducibility of the reorientation with this semi-automatic method was compared with manual selection of the LV long-axis. In all patients, a successful reorientation was obtained with the present method. The reproducibility was significantly better with the semi-automatic method than with the manual selection of the LV long-axis.

Comparison between thallium-201 and technetium-99m methoxyisobutyl isonitrile defect size in single-photon emission computed tomography at rest, exercise and redistribution in coronary artery disease.

Defect size on myocardial tomograms was measured in 30 patients who underwent 2 separate studies, 1 with thallium-201 (TI-201), the other with technetium-99m-methoxyisobutyl isonitrile (MIBI). A group of 15 patients with myocardial infarction was studied at rest and received both tracers on the same day. The other 15 patients had documented coronary artery disease. They were were given injections of TI-201 at peak exercise and underwent imaging immediately after exercise and again 4 hours later. They then received a dose of MIBI for imaging at rest. A week later they underwent a second exercise test with the same work load and received a second dose of MIBI. Defect size on single-photon emission computed tomographic images was measured and repeated twice. Results were expressed in percentage of the volume of the whole myocardium. Reproducibility of the defect size measurement was high for TI-201 (r = 0.978; SEE = 1.59) as well as for MIBI (r = 0.981; SEE = 0.80). In patients with coronary artery disease the mean size of the defects was significantly larger with TI-201 than with MIBI at exercise (6.7 +/- 5.2 vs 4.6 +/- 5.2%, respectively, p less than 0.05) and at redistribution (5.1 +/- 4.4 vs 2.8 +/- 3.2%, respectively, p less than 0.05), where no difference was seen in patients with myocardial infarction studied only at rest (11.2 +/- 10.4 vs 12.0 +/- 11.5%, respectively, p = not significant). Smaller MIBI defect sizes, when compared with TI-201, in the exercise and redistribution studies were not due to technical artefacts since there was no difference when they were compared at rest.

3D modeling in myocardial 201TL SPECT.

A method to model the left ventricular myocardium in thallium-201 Single Photon Emission Computed Tomography (SPECT) is presented. This method is based on the fitting of the morphological skeleton of the left ventricle to a truncated bullet. This automatic approach would provide a more reproducible visualization of the organ for clinical applications.

Automatic detection of the left ventricular myocardium long axis and center in thallium-201 single photon emission computed tomography.

A new method for centering and reorienting automatically the left ventricle in thallium-201 myocardial single photon emission computed tomography (SPET) is proposed. The processing involves the following steps: (a) the transverse sections of the left ventricle are segmented, (b) the three-dimensional skeleton of the left ventricle is extracted using tools of mathematical morphology, (c) the skeleton is fitted to a quadratic surface by the least-squares method, (d) the left ventricle is reoriented and centered using the long axis and the coordinates of the centre of the quadratic surface. A series of 30 consecutive exercise and redistribution 201Tl SPET studies were centered and reoriented by two operators twice with this method, and twice manually. There was no significant difference in the mean realignment performed by the automatic and the manual methods while centering differed moderately in some instances. In all cases and for all parameters, the reproducibility of the automatic method was 1.00, while it ranged between 0.74 and 0.98 with the manual centering and reorientation. This automatic approach provides a fast and highly reproducible method for the reconstruction of short- and long-axis sections of the left ventricle in 201Tl SPET.