Impact of new operational dosimetric quantities on individual monitoring services.

The new operational dosimetric quantities framework, proposed in the ICRU95 report, has stimulated the scientific community to start investigations that aim to assess its impact on radiation protection practices. As part of this effort, the present study describes an inter-comparison exercise among individual monitoring services (IMSs) on passive whole-body dosimetry. The inter-comparison is performed in terms of both the existing operational dose quantityHp(10)and its proposed replacementHp, to allow an evaluation of the actions that may be necessary to adapt dosimetry systems to the proposed quantity. For two of the tested IMSs, simple modifications to the detector response function, or the dose calculation algorithm, were sufficient to obtain results within acceptable limits. However, these approaches are not sufficient to give a level of performance comparable to that achieved in terms ofHp(10). This may require a modification to dosemeter design.

EXPERIMENTAL VALIDATION OF ALGORITHMS USED TO ESTIMATE EFFECTIVE DOSE DURING INTERVENTIONAL RADIOLOGY PROCEDURES.

In IR procedures, in order to evaluate the effective dose, the importance of the double dosemeter has been recognised, one worn above and one under the apron. Over the last few decades several algorithms have been developed to combine the readings of the dosemeters, however currently there is no international consensus on which is the best one. In this work, eight irradiations, corresponding to typical interventional radiology procedures, were carried out in order to experimentally verify the accuracy of the algorithms. The patient was substituted by solid water-equivalent (RW3) layers, while effective dose to personnel was calculated by TLDs inside the Alderson Rando phantom. The results show that most of the algorithms, with a few exceptions, are too conservative, however there are many factors which can affect their accuracy, so it is impossible to achieve a high level of precision in the evaluation of the effective dose.

Secondary photon fields produced in accelerator-based sources for neutron generation.

Neutrons can be produced with low-energy ion accelerators for many applications, such as the characterisation of neutron detectors, the irradiation of biological samples and the study of the radiation damage in electronic devices. Moreover, accelerator-based neutron sources are under development for boron neutron capture therapy (BNCT). Thin targets are used for generating monoenergetic neutrons, while thick targets are usually employed for producing more intense neutron fields. The associated photon field produced by the target nuclei may have a strong influence on the application under study. For instance, these photons can play a fundamental role in the design of an accelerator-based neutron source for BNCT. This work focuses on the measurement of the photon field associated with neutrons that are produced by 4.0-6.8 MeV protons striking both a thin 7LiF target (for generating monoenergetic neutrons) and a thick beryllium target. In both cases, very intense photon fields are generated with energy distribution extending up to several MeV.

Uncertainties evaluation for electrets based devices used in radon detection.

In recent years uncertainty evaluation in measurements has achieved great importance. National and international standards offer guidelines to evaluate uncertainties, but these procedures are, until now, not well understood by the operators. This is because of the fact that a detailed uncertainty evaluation is not an easy operation and a standard rule to apply in all cases is not available. Every measurement procedure has its own uncertainty evaluation. In this work, attention is focused upon the electret ion chambers (EIC), widely used in radon concentration measurements. Measurements of gamma radiation sensitivity are performed in a secondary standard calibration laboratory and measurement of radon concentration sensitivity is performed in a radon chamber 0.8 m3 in volume. Raw data are analysed to evaluate the calibration factors and the combined uncertainties are determined. The aim of the work is to give a practical method to assess the uncertainty of a radon measurement.

A very low-background gamma-ray counting facility in the Baradello underground laboratory.

An underground station for the measurement of low-level radioactivity is in operation in Northern Italy in the town of Como under the Baradello hill. The rock cover is -300 m water equivalent. This paper reports about the preliminary measurements carried out to characterise the site of the Baradello hill and the installation of a high-purity Ge detector with a radio-pure copper shielding. Features and levels of the achieved background are reported and discussed, in comparison with other above ground and underground low-radioactivity stations. Sensitivities to radioactivity in typical environmental matrices are evaluated, confirming the very low-gamma background attained in the laboratory.

Study of suitability of Fricke-gel-layer dosimeters for in-air measurements to characterise epithermal/thermal neutron beams for NCT.

The reliability of Fricke gel dosimeters in form of layers for measurements aimed at the characterization of epithermal neutron beams has been studied. By means of dosimeters of different isotopic composition (standard, containing (10)B or prepared with heavy water) placed against the collimator exit, the spatial distribution of gamma and fast neutron doses and of thermal neutron fluence are attained. In order to investigate the accuracy of the results obtained with in-air measurements, suitable MC simulations have been developed and experimental measurements have been performed utilizing Fricke gel dosimeters, thermoluminescence detectors and activation foils. The studies were related to the epithermal beam designed for BNCT irradiations at the research reactor LVR-15 (Rez). The results of calculation and measurements have revealed good consistency of gamma dose and fast neutron 2D distributions obtained with gel dosimeters in form of layers. In contrast, noticeable modification of thermal neutron fluence is caused by the neutron moderation produced by the dosimeter material. Fricke gel dosimeters in thin cylinders, with diameter not greater than 3mm, have proved to give good results for thermal neutron profiling. For greater accuracy of all results, a better knowledge of the dependence of gel dosimeter sensitivity on radiation LET is needed.

Characterization of an underground site in Northern Italy in view of low radioactivity measurements.

A low background station for the measurement of low level radioactivity is under development in Northern Italy. The rock cover is about 300 m water equivalent. We report and discuss measurements of radon concentration in air and of gamma, muon and neutron fluxes performed in the neighborhood of the station site. We present and apply a simple analytical model capable to disentangle the contribution to the measured gamma activities due to 222Rn in air from the one due to 238U and its daughters in the rocks.

Uncertainty evaluation of radon measurements with LR115 detector and spark counter.

To evaluate the uncertainties for nuclear track detectors used in radon measurements, a full understanding is required of the physical phenomena involved and the behaviour of the instruments utilised in the measuring process. As it concerns the LR115 nuclear track detector, an overall evaluation of uncertainty was given. It was assessed taking into account different contributions and determining their relative weights. Since such detectors are often read by a spark counter device, a model to describe its behaviour was developed and a saturation factor was estimated. Its expression and its associated uncertainty are given. Hence, it has been possible to draw a calibration curve, in which all the uncertainty sources have been considered.