RESUMO
Ordering of ferroelectric polarization1 and its trajectory in response to an electric field2 are essential for the operation of non-volatile memories3, transducers4 and electro-optic devices5. However, for voltage control of capacitance and frequency agility in telecommunication devices, domain walls have long been thought to be a hindrance because they lead to high dielectric loss and hysteresis in the device response to an applied electric field6. To avoid these effects, tunable dielectrics are often operated under piezoelectric resonance conditions, relying on operation well above the ferroelectric Curie temperature7, where tunability is compromised. Therefore, there is an unavoidable trade-off between the requirements of high tunability and low loss in tunable dielectric devices, which leads to severe limitations on their figure of merit. Here we show that domain structure can in fact be exploited to obtain ultralow loss and exceptional frequency selectivity without piezoelectric resonance. We use intrinsically tunable materials with properties that are defined not only by their chemical composition, but also by the proximity and accessibility of thermodynamically predicted strain-induced, ferroelectric domain-wall variants8. The resulting gigahertz microwave tunability and dielectric loss are better than those of the best film devices by one to two orders of magnitude and comparable to those of bulk single crystals. The measured quality factors exceed the theoretically predicted zero-field intrinsic limit owing to domain-wall fluctuations, rather than field-induced piezoelectric oscillations, which are usually associated with resonance. Resonant frequency tuning across the entire L, S and C microwave bands (1-8 gigahertz) is achieved in an individual device-a range about 100 times larger than that of the best intrinsically tunable material. These results point to a rich phase space of possible nanometre-scale domain structures that can be used to surmount current limitations, and demonstrate a promising strategy for obtaining ultrahigh frequency agility and low-loss microwave devices.
RESUMO
Cobalt nanoparticle thin films were electrophoretically deposited on copper current collectors and were annealed into thin films of hollow Co3O4 nanoparticles. These thin films were directly used as the anodes of lithium ion batteries (LIBs) without the addition of conducting carbons and bonding agents. LIBs thus fabricated show high gravimetric capacities and long cycle lives. For ≈1.0 µm thick Co3O4 nanoparticle films the gravimetric capacities of the batteries were more than 800 mAh g-1 at a current rate of C/15, which is about 90% of the theoretical maximum. Additionally, the batteries were able to undergo 200 charge/discharge cycles at a relatively fast rate of C/5 and maintain 50% of the initial capacity. In order to understand the electrochemistry of lithiation in the context of nanoparticles, Raman spectra were collected at different stages of the electrode cycles to determine the chemical and structural changes in the nanomaterials. Our results indicate that initially the electrode nanoparticles were under significant strain and as the battery underwent many cycles of charging/discharging the nanoparticles experienced progressive strain relaxation.
RESUMO
We report intense, narrow line-width, surface chemisorption-activated and reversible ultraviolet (UV) photoluminescence from radiative recombination of the two-dimensional electron gas (2DEG) with photoexcited holes at LaAlO3/SrTiO3. The switchable luminescence arises from an electron transfer-driven modification of the electronic structure via H-chemisorption onto the AlO2-terminated surface of LaAlO3, at least 2 nm away from the interface. The control of the onset of emission and its intensity are functionalities that go beyond the luminescence of compound semiconductor quantum wells. Connections between reversible chemisorption, fast electron transfer, and quantum-well luminescence suggest a new model for surface chemically reconfigurable solid-state UV optoelectronics and molecular sensing.
Assuntos
Óxido de Alumínio/química , Técnicas Biossensoriais , Elétrons , Gases/química , Luminescência , Óxidos/química , Estrôncio/química , Propriedades de Superfície , Titânio/química , Raios UltravioletaRESUMO
We demonstrate spatial probing of carrier transport within GaAs/AlGaAs core-shell nanowires with nanometer lateral resolution and subsurface sensitivity by energy-variable electron beam induced current imaging. Carrier drift that evolves with applied electric field is distinguished from a coupled drift-diffusion length. Along with simulation of injected electron trajectories, combining beam energy tuning with precise positioning for selective probing of core and shell reveals axial position- and bias-dependent differences in carrier type and transport along parallel conduction channels. These results indicate how analysis of transport within heterostructured nanomaterials is no longer limited to nonlocal or surface measurements.
Assuntos
Alumínio/química , Gálio/química , Nanofios/química , ElétronsRESUMO
Traditionally, the ferroelectric Curie temperature can be manipulated by chemical substitution, e.g., in Ba1-xSrxTiO3 as one of the archetypical representatives. Here, we show a novel approach to tune the ferroelectric phase transition applicable for nanostructured thin films. We demonstrate this effect in nano-grained BaTiO3 films. Based on an enhanced metastable cation solubility with Ba/Ti-ratios of 0.8 to 1.06, a significant shift of the phase transition temperature is discovered. The transition temperature increases linearly from 212 K to 350 K with increasing Ba/Ti ratio. For all Ba/Ti ratios, a completely diffused phase transition is present resulting in a negligible temperature sensitivity of the dielectric constant. Schottky defects are identified as the driving force behind the off-stoichiometry and the shift of the phase transition temperature as they locally induce lattice strain. Complementary temperature dependent Raman experiments reveal the presence of the hexagonal polymorph in addition to the perovskite phase in all cases. Interestingly, the hexagonal BaTiO3 influences the structural transformation on the Ba-rich side, while on the Ti-rich side no changes for the hexagonal polymorph at the ferroelectric transition temperature are observed. This concerted structural change of both polymorphs on the Ba-rich side causes a broad phase transition region spanning over a wide range up to 420 K including the transition temperature of 350 K obtained from dielectric measurements. These findings are promising for fine adjustment of the phase transition temperature and low temperature coefficient of permittivity.
RESUMO
The perovskite phase of cesium lead iodide (α-CsPbI3 or "black" phase) possesses favorable optoelectronic properties for photovoltaic applications. However, the stable phase at room temperature is a nonfunctional "yellow" phase (δ-CsPbI3). Black-phase polycrystalline thin films are synthesized above 330 °C and rapidly quenched to room temperature, retaining their phase in a metastable state. Using differential scanning calorimetry, it is shown herein that the metastable state is maintained in the absence of moisture, up to a temperature of 100 °C, and a reversible phase-change enthalpy of 14.2 (±0.5) kJ/mol is observed. The presence of atmospheric moisture hastens the black-to-yellow conversion kinetics without significantly changing the enthalpy of the transition, indicating a catalytic effect, rather than a change in equilibrium due to water adduct formation. These results delineate the conditions for trapping the desired phase and highlight the significant magnitude of the entropic stabilization of this phase.
RESUMO
This study employed an independent-groups design (4 conditions) to investigate possible biases in the suicide risk perception of mental health professionals. Four hundred participants comprising doctors, nurses and social workers viewed a vignette describing a fictitious patient with a long-term mental illness. The case was presented as being drawn from a sample of twenty similar clinical case reports, of which 10 were associated with an outcome of suicide. The participant tasks were (i) to decide whether the presented vignette was one of those cases or not, and (ii) to provide an assessment of confidence in that decision. The 4 conditions were used to investigate whether the presence of an associated face, and the nature of the emotional state expressed by that face, affected the response profile. In fact, there were no significant differences between conditions, but there was a significant bias across all conditions towards associating the vignette with suicide, despite the base rate being pre-determined at 50%. The bias was more pronounced in doctors and in male respondents. Moreover, many participants indicated substantial confidence in their decisions. The results are discussed in terms of availability bias and over-confidence bias.
Assuntos
Atitude do Pessoal de Saúde , Emoções , Pessoal de Saúde/psicologia , Saúde Mental , Percepção , Suicídio , Adulto , Feminino , Humanos , Masculino , Pessoa de Meia-IdadeRESUMO
Getting hit in the nose can be scary, especially if it starts bleeding a lot. Your nose is at risk in a collision with another player or piece of sporting equipment, and striking the bones in your face can be very painful. That's why wearing protective gear, like a helmet and a mouth guard, is so important when playing sports.
RESUMO
Team physicians must be prepared to manage facial injuries, including contusions, abrasions, lacerations, nasal fractures, septal hematomas, auricular hematomas, ruptured tympanic membranes, and fractures of the facial bones. With a focused history and a thorough physical exam, the diagnosis can be clearly established. Early treatment of sports-related facial injuries helps avoid complications, and athletes may expect to return to play after predictable time intervals.
RESUMO
Overtraining syndrome is a common cause of underperformance in athletes. Symptoms such as persistent fatigue, muscle soreness, reduced coordination, weight loss, mood changes, and frequent illness may accompany performance decrements, but they may also be signs of underlying medical conditions. Reliable and practical diagnostic laboratory tests for overtraining have not yet been identified. Clinicians can prescribe relative or complete rest and strive to identify and correct the training, nutritional, and psychosocial factors that contributed to the athlete's condition.
RESUMO
You've been feeling exhausted, achy, edgy, and burned out. Worse yet, your personal relationships are suffering and you're stressed over so many demands on your time. On top of that, your athletic performance has "hit the wall," and you just can't seem to do any better. What's wrong?