Effect of marine ambient in the production of pollutants from the pyrolysis and combustion of a mixture of plastic materials.

A mixture of polyethylene (PE), polyethylene-terephtalate (PET), polypropylene (PP) and Nylon was submerged in marine water during 12 moths. The chlorine content of these plastics was measured through the passing time. Thermobalance was used to look for differences in the thermal decomposition of the plastics during in that time interval. Degradation of PET, PP and Nylon produced changes in the weight loss curve, but behaviour of PE is confusing. Pyrolysis and combustion at 850 °C was finally performed to get knowledge of the possible differences in the emission of main gases, volatiles and semivolatiles including polycyclic aromatic hydrocarbons (PAHs), polychlorinated benzenes (ClBzs), polychlorinated phenols (ClPhs), polybrominated phenols (BrPhs), polychlorinated biphenyls (PCBs) and polychlorinated dibenzo-p-dioxins and dibenzofurans (PCDD/Fs). Results show that the emission of chlorinated species is somewhat not affected by the chlorine content of the plastics mix. The production of PCBs and PCDD/Fs was very low, under 4 pg WHO-TEQ/g.

Pollutant content in marine debris and characterization by thermal decomposition.

Marine debris (MDs) produces a wide variety of negative environmental, economic, safety, health and cultural impacts. Most marine litter has a very low decomposition rate (plastics), leading to a gradual accumulation in the coastal and marine environment. Characterization of the MDs has been done in terms of their pollutant content: PAHs, ClBzs, ClPhs, BrPhs, PCDD/Fs and PCBs. The results show that MDs is not a very contaminated waste. Also, thermal decomposition of MDs materials has been studied in a thermobalance at different atmospheres and heating rates. Below 400-500K, the atmosphere does not affect the thermal degradation of the mentioned waste. However, at temperatures between 500 and 800K the presence of oxygen accelerates the decomposition. Also, a kinetic model is proposed for the combustion of the MDs, and the decomposition is compared with that of their main constituents, i.e., polyethylene (PE), polystyrene (PS), polypropylene (PP), nylon and polyethylene-terephthalate (PET).