Spray Pattern and Plume Geometry Testing and Methodology: An IPAC-RS Working Group Overview.

Plume characterization for orally inhaled and nasal drug products (OINDP) provides valuable information during OINDP development. Spray pattern and plume geometry techniques, methods, and technology have evolved over the past 20 years since the publication of the original 1998 FDA MDI DPI draft guidance. The International Pharmaceutical Aerosol Consortium on Regulation and Science (IPAC-RS) discusses the historical context and background to plume geometry and spray pattern characterization studies; provides an analysis of the current regulatory context; addresses results from its industry surveys on application and value of such testing; and presents case studies and best practices-seeking to provide insights to regulatory bodies and other stakeholders. Assessment and consideration of published studies and industry experience note the value of plume geometry and spray pattern in development, and that further data is needed regarding their use in assessing formulation characteristics. Continued dialogue between industry and regulatory bodies is needed to establish the optimum use of these techniques.

In Vitro Performance of the Wixela Inhub Inhaler Using Severe Chronic Obstructive Pulmonary Disease Patient Inhalation Profiles.

Background: Wixela Inhub (trademarks of Viatris, Inc.) is a dry powder inhaler (DPI) that delivers a fixed-dose combination of fluticasone propionate and salmeterol and is approved as a generic equivalent to Advair Diskus (trademarks of GlaxoSmithKline plc) for the treatment of asthma and chronic obstructive pulmonary disease (COPD). The dosing performance of DPIs is dependent on the patient's inspiratory capability, which may be impacted in disease populations such as those with severe COPD. The objective of this study was to evaluate the in vitro dose delivery of fluticasone propionate and salmeterol from the Inhub inhaler with in vivo inhalation profiles of severe COPD patients, using two types of breathing simulator with different modes of operation. Materials and Methods: Two breathing simulators (Si-Plan and Copley BRS3100) were used with United States Pharmacopoeia (USP) <601> apparatus 5 (Next Generation Impactor and accessories) to measure the total emitted dose and fine particle mass of fluticasone propionate and salmeterol for Wixela Inhub (250/50 mcg) using 13 severe COPD patient inhalation profiles. Results: Wixela Inhub demonstrated low flow dependency across the range of COPD patient profiles tested (peak inspiratory flow rate 60.8-84.9 L minute-1), when assessed by total emitted dose and fine particle mass. The results were similar to literature results reported for fluticasone propionate from the Diskus inhaler, tested using a proprietary breathing simulator and Andersen Cascade Impactor. Comparison between the breathing simulators showed no significant difference in fluticasone propionate results, but a small difference was observed between the breathing simulators for salmeterol total emitted dose and fine particle mass. Conclusions: This study demonstrates that severe COPD patients are likely to achieve a consistent inhaled dose from Wixela Inhub, with low flow dependency observed within this patient population. In addition, both breathing simulators, which differ significantly in design, produced similar results for fluticasone propionate, but yielded slightly (but statistically significant) different results for salmeterol.